Microsoft Whiteboard Request control DC Pi log Po PI Gdev = I0 log 20 48M 2/24/2001 ansino O Type here to search MR MR Marwan Khalifa Awaid Zakiya Mohsin Zahran Dr.Jonathan Cansino Al Hassan Ali Mubarak. Malak Ahmed Moham.

Q: PAN is abbreviation of: O Private Area Network. O Personal Area Network. OPublic Area Network. O No…

A: We need to select correct option

Q: Select the FM Radio Quality recording format on the picture below and calculate the size of the 30…

A:

Q: 11- To increase the transfer power in a 230 kV transmission line, we plan to use a series capacitor…

A: Given - Length of the line= 100km Line X = 0.0911pu

Q: Design the following function F using: AB CD 00 01 11 10 00 1 01 1 11 1 10 1 1 1.4:16 decoder block…

A:

Q: Suppose I am using Orthogonal FSK to transmit data according to the following constellation where…

A:

Q: A Communication source sending alphabet letters S={ A, B, C, D, E, F}. The following table lists the…

A: Since, we are authorized to only answer up to 3 sub-parts. So we''ll answer up to first 3 sub parts.…

Q: What is the minimal solution for the Kmap shown? AB CD 00 01 11 10 00 1 1 01 1 1 1 11 10 1 1 1

A: Given K-map,

Q: No. Channels/cell BP= 0.01 BP= 0.005 BP= 0.002 1.36 1.13 0.9 10 4.46 3.96 3.43 20 12 11.1 10.1 70…

A:

Q: Assume that we are using QAM-system that are capable of sending two messages simultaneously at the…

A: Given data: x1t=cos1000tx2t=sin1100tst=cos10000t

Q: The voltage in a circuit is determined at various times, as follows: time: 12345678 voltage: 1.2 2.1…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: 2- find the B.W of the TDM system have (12 voice Chanel) with message frequency fm=3.5 KHz

A: Given data, Number of channel N=12 Message frequency fm=3.5 kHz

Q: Communication Fundamentals Second Year Homework 1 // AM transmitter has a total power (480kw) and…

A:

Q: The GSM cellular radio system uses GMSK in in a 200-kHz channel, with channel data rate of 270.833…

A: Given data, fc =880MHz

Q: The channel capacity of a telephone line noisy channel is 120 kbps with bandwidth (B=3 kHz).…

A: SNR

Q: 7. What is MIN? a) Subscriber's telephone number b) Paging message c) Traffic request number d)…

A: Given: What is MIN?

Q: Name one application in communication System that ISI disortion cause more problem than noise and…

A:

Q: 5. If GSM uses a frame structure where each frame consists of 8 time slots, and each time slot…

A:

Q: Power flow analysis using Newton-Raphson method occupies memory of the computer. O Limited O Less O…

A: Newton - Raphson method is used to solve load flow problems. It uses Tailor's series and partial…

Q: Complete the RIVP table. express your answers in mA or mW 19V 21 V + 4Ω www 3 Ω + | + 222 6Ω

A:

Q: Redraw Fig. and highlight the conductingpath(s) for the following sets of inputs for ABCDE:(a)…

A: (a) The given input is ABCDE = 10011. Here, input A, D, and E are high, hence the conducting path…

Q: A segment of the network where a single Ethernet packet can be transmitted is called Node O Hub O…

A: A segment of the network where a single Ethernet packet can be transmitted is called as Collision…

Q: Which type of modulation is used for the following: a) Geostationary satellite broadcasting…

A: a) Geostationary satellite broadcasting weather-related data: In this case, a special type of…

Q: Which of the following bus functions from Microprocessor to Devices and in other direction also at…

A: Bartleby has policy to solve only first question and incase if it has subparts then solve only first…

Q: Q2. Design a suitable generic SSB (USB) generator using a carrier (cos 2000nf.t) to modulate the…

A:

Q: Given the function Fla,b.c) = a (b' + c), ) express Fas an algebraic sum of products. Answer…

A: F= a(b'+c) F= ab'+ ac is the sop

Q: Assume that an AM system operates with an index of 0.8 and that the message signal ism(t) =…

A: The solution is given below

Q: In a broadcasting studio, a 1000kHz carrier is modulated by an audio signal of frequency…

A: Given: An audio signal of frequency range100-5000Hz. fc=1000 kHzfmmin=100 Hz=0.1 kHzfmmax=5000 Hz=5…

Q: The second generation of mobile communication phones was ________. a) digital b) analog c) semi…

A: Any digital device that can send and receive information is considered a communication technology…

Q: The following is configured on a router             Router(config)# interface g0/0.10…

A: On a router - The following instructions is set up, Router(config)# interface g0/0.10…

Q: As shown from the image below, when a carrier signal of 800 kilo-hertz is mixed with an audio signal…

A: We know that processing of converting low frequency signal to high frequency signal is called…

Q: 1. For an AM communication the modulating signal is given as m(t) = 5 cos(2n500t) + 10 cos(2nl1000t)…

A: Find the upperside power, Lower sideband power , Total power delivered to the load of 1000 ohm,…

Q: use Karnouph map to simplify F(x,Y,Z,w,u) ={(o,1,2,4,7,9,26,27,30) + ¢{ (3,17,20)

A: To draw the 5 variable K-map we will use two 4 variable K-map, 1st with A equal to zero and 2nd with…

Q: Design the following function F using: АВ 00 01 11 10 CD 00 1 01 11 10 1 1 1. 4:16 decoder block 2.…

A: The solution is given below

Q: Match the legislation with what it covers: Law enforcement can tap into U.S. telephone [Choose ]…

A:

Q: Can you answer my quesition which is in jpek format?

A: Assume it is silicon based transister then VB-VE=0.7 V A).

Q: Quèstion 3 Q. For function minterms = your student ID digits without repetition, find: 1. The…

A:

Q: Q2. Design a suitable generic SSB (USB) generator using a carrier (cos 2000nft) to modulate the…

A: The discrete Fourier transform (DFT) is a complex-valued frequency function that turns a finite…

Q: Which of the following I/O device has the lowest data rates? Select the correct response: old…

A: Input and output devices are a part of a computer. We can think of an input as a hardware device…

Q: 1. What is the value of Ip? Ip = 2. What should the value of Rp be if Vps = Vp,SAT? mA Rp

A: for saturation region  Vds >= Vgs -Vth

Q: 1009 s²+20.s+10o St3

A: Transfer function:  The ratio of the Laplace transform of output to the Laplace transform of input…

Q: Q.6. ABC organization wants to manage its four offices A, B, C and D. This organization has network…

A: Solution  An IP address is an identifier or label used to identify a machine on the internet or a…

Q: For the input function and the output function of a system X(Z)=(Z-1/2), Y(Z) = (Z-B), what should…

A:

Q: As shown from the image below, when a carrier signal of 800 kilo-hertz is mixed with an audio signal…

A:

Q: "If you are going to collect data through experiment, you will be collecting primary and qualitative…

A: The solution is given below

Q: RSL For ANBUL MEDI: L UN LECTRIOCIROCUITS COUS MIDTERM EAMINATION NOVEMBER 242821 @ 11.30 M the &UN…

A:

Q: octal number system it is not a positional weighted system Select one: True False

A:

Q: Communication system Finding the power equation for AM Modulation

A:

Q: Choose the correct option and explain each option for the below three questions. 1.The second…

A: In 1983, the first consumer mobile phone to be made available for purchase on the open market was…

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.