Obtain the transfer function using block diagram reduction

Q: A semiconductor laser has a threshold current of 25 mA and a slope efficiency of 0.25 W.A1 (measured…

A: We need to analyse the given laser , we need to find out  power and efficiency.

Q: B1. What are the methods for speed control of DC motors? B2. What are the methods for speed control…

A: We need to tell about methods for speed control for DC motor and induction motor .

Q: nd sequentially as shown in the figure below and the location of node 1 must be located at x=0.…

A:

Q: 2. The shown set of mechanical characteristics applies for: a) DC motor with armature voltage…

A:

Q: The parallel magnetic circuit should in Figure 1 is silicon steel with the same cross-sectional area…

A: Given i1= current in first coil i2= current in second coil Note : relative permeability of silicon…

Q: Q2. Find Io Source is in the circuit 5 200 A of fig. Q2, (Ans: -SA) 212 M --j2 n उपल пр give n -J22…

A:

Q: 16. Find the unknown current Ix using mesh current methods in the circuit below. Show that the…

A: it is asked to find the unknown current Ix using mesh analysis and also to verify the answer using…

Q: 2) The double-stub impedance matching circuit given in Fig. 2 consists of short circuited parallel…

A: A type of matching called "double stub matching" involves shunting two stubs across a set distance…

Q: Using the Routh-Hurwitz criterion, find the value range of K to get a stable system having a…

A: The Routh-Hurwitz criterion is a method for determining the stability of a system by analyzing the…

Q: typical D’ Arsonval movement having an internal resistance Rm=100 Ω with full scale deflection…

A: We need to find out series resistance to increase the range of given meter.

Q: Question 2: Find the inverse Laplace transform of 2 F(s) = 3 +35² +25

A: Dear,as per company guidelines we can answer only one question at a time.Kindly post other questions…

Q: Vs RCE Figure 1 LOAD

A:

Q: Consider the instrumentation amplifier with a common-mode input voltage of +5 V (dc) and a…

A:

Q: Use the following values ​​for the evaluation of the transfer function: R = 10Ω, C1= 1 μF, C2= 2.2…

A: The network in the figure is an RC low-pass filter, which is a type of electronic filter that passes…

Q: An RC-LPF circuit has R = (16) kΩ and C = (10)-μF. Find (a) the radian cut-off frequency (b) The…

A:

Q: Which of the following statements is not true for transistor amplifier circuits? a. The CC/CD…

A: A) Explanation- Most important use of CC transistor is an impedance matching device, It is seldom…

Q: For the system Given Evaluate the system Responce what is the system type? specify the system…

A: Solution:                  Replace the given system with respective signal flow graph SFG and…

Q: Problem 1: A baseband signal x(t) = 4cos (8nt) is amplified using an amplifier to produce the output…

A: We need to find out output for given system and given input .

Q: H.W. 8: The finite sheet 0 ≤ x ≤ 1, and 0 ≤ y ≤ 1 on the z = 0 has a charge density Ps = xy(x² + y²…

A: (a) Q=∫SρSdS=∫01∫01xy(x2+y2+25)3/2dxdynC Since xdx=1/2d(x2), now integrating with respect to x2(or…

Q: A BJT has a transition frequency of 600 MHz. If gm = 20 ms, what is the approximate total parasitic…

A: Introduction Parasitic Capacitance These are the small capacitors that are connected to the base of…

Q: The vertical tropospheric delay is 2.5 m. What is the delay for a satellite track at 30 degrees…

A: Given, Vertical tropospheric delay, h = 2.5 m We need to determine the delay for a satellite track…

Q: 4. A 400 kV, 150 km long OHL with parameters R-0.017 2/km, XL50.27 2/km and X 94520 2/km is used to…

A: Given data Receiving end voltage, VR=400 kV Length of the transmission line, L=150 km Resistance,…

Q: The open loop transfer function of the feedback control system is given by G(s) =…

A: G(s) = Ks+3s(s+4)2(s+5)(s+6)   We have to find the number of asymptotes and the centroid of…

Q: O Vin w Vout Consider Vo Rout? VAZO Av ? Rin?

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: b) and protecting valve. There is a large river of fresh water (having the density of 1000 kgm) in…

A: Given: In this question, the given details are, There is a large river of fresh water (having the…

Q: what is the different of Quasi-stationary heating model (Resistivity p is function of specific…

A: Model for quasi-stationary heating: The research on heat transport in this paper is focused on a…

Q: Find XC at the resonant frequency in the below circuit. R = 22 Q, L = 5 mH, and C = 84 pF The result…

A: We need to find out the Xc , for given circuit .

Q: A 3-phase, 10-kVA, 400-V, 50-Hz, Y-connected alternator supplies the rated load at 0.8 p.f. lag. If…

A: In this question We need to determine the voltage regulation Given R= 0.5ohm X= 10 ohm Voltage…

Q: The PMOS in Fig. 8 is specified to have Vth=-1V and kp = 0.3mA/V². The ideal current source has I =…

A: We need to find out the voltage for given circuit.

Q: H-w/s Perify the gain "k" such that the output has overshoot of Maximum 10% in response to aunity…

A:

Q: The type of the amplifier circuit in the shown figure is: 50 kn www V₂ 20 k Un elect one: Oa.…

A:

Q: function given as G(s) U = k s(s+3)(5+4) 1. Represent the poles of the System the S plane Using the…

A:

Q: Q5 Obtain the line currents and the line to neutral voltages if a SLGF occurs at bus 4 for the…

A:

Q: What is the difference between combinational and sequential circuit in analyzing logic diagram in…

A: We need to differentiate between combinational and sequential circuits.

Q: 3. Two loads in the circuit of Figure 2 can be described as follows: Load 1 absorbs an average power…

A: It is given that: X- 5, Y- 6, Z- 4  Load 1:Pavg=6 kWcosϕ=0.8 leadingLoad 2:kva=50cosϕ=0.6 lagging

Q: A three-phase transmission line has parameters Xc-6 k 2, R-3.25 2 and X₁-25 0, and delivers 300 MW…

A: The system parameter of the 3ϕ systems is given as Capacitive reactanceXC=6kΩ/ph,Y=1-jXC=j6k,Now the…

Q: Find Vo? R₁ 10 ww O b. -5 О с 0 O d. 5 O e 4 SV Select one: Oa None of them 4V 40 ww 15V -15V No

A: We need to find out the output voltage for given circuit.

Q: 5. Determine the output voltage waveform for the circuit below and determine the maximum and minimum…

A:

Q: -10R Q3-A-Find the Fourier series components of the signal 10m ث إضافة ملف x (+) = a + Σ an Coswont…

A: We need to find out Fourier series for given signal .

Q: A modulating signal is given as x(t) = sin (2π 20 x 10³t). Draw the delta modulation for signal…

A: Given, Modulating signal is x(t) = sin(2π×20×103t)  Step size,∆ = + or - 8V/sec We need to draw the…

Q: For the circuit shown in Figure 1, find I. Let find current w = 10 rad Is. CARS: 9.135 +327.4712;…

A: We need to find out impedance and current for given circuit.

Q: Which device is used to convert mechanical energy into electrical energy? Draw a neat diagram and…

A:

Q: Solve please both part. a)What is the Voltmeter reading on diagram A? b)In circuit B what is the 1)…

A: For the given circuit calculate:  Voltmeter reading on diagram A. In circuit B: Total resistance.…

Q: from your aspect, can you control on the speed and current of DC motor by PID ?controllers at the…

A: Method of Speed control of DC Motor  Using Field current  Using armature voltage  Using armature…

Q: A 100-MVA synchronous generator supplies 62.5 MVA of power at 0.8 lagging power factor. The…

A: Given data, The base MVA is 100 MVA Power 1 delivered P1=62.5 MVA at 0.8 PF lagging. Power 3…

Q: synchronous machine generator

A:

Q: 4.1.2 U₁ (+1) + UD- The rectifier + Ro No Question: (assuming diode is ideal). 2) Sketch output for…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: Problems: 1.) Determine X(2) if x(n) = ( 13 ) ^ Mc-n). What is the regions of convergence of 2.

A: Since you have posted multiple questions, we will provide the solution to the first question only as…

Q: An 8 pole DC shunt generator with 778 wave connected armature conductor and running at 500 RPM…

A:

Q: Vin MI Vout Ideal M2 VB Av=? Rout=? dyo Consider fo

A: