Pitot tube head Tube several metres long shown in cross- section Pitot tube head (1) State one factor that would have to be taken into consideration when choosing where to position the Pitot tube head on the exterior of an aircraft if the true airspeed is to be indicated. (ii) Would water be a suitable liquid for the manometer if airspeeds of up to 600 km h- are to be indicated in the cockpit of an aircraft? Justify your answer.

Pitot tube head Tube several metres long shown in cross- section Pitot tube head (1) State one factor that would have to be taken into consideration when choosing where to position the Pitot tube head on the exterior of an aircraft if the true airspeed is to be indicated. (ii) Would water be a suitable liquid for the manometer if airspeeds of up to 600 km h- are to be indicated in the cockpit of an aircraft? Justify your answer.

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter5: Displacement And Force In Two Dimensions

Section: Chapter Questions

Problem 86A

See similar textbooks

Similar questions

I want a quick solution, please fast, I don't have enough time Gas guns are used to investigate the properties of materi- als subjected to high-velocity impacts. A projectile is accelerated through the barrel of the gun by gas at high pressure. Assume that the acceleration of the projectile in m/s² is given by a = c/s, where s is the position of the projectile in the barrel in meters and c is a constant that depends on the initial gas pressure behind the projectile. The projectile starts from rest at s = 1.5 m and acceler- ates until it reaches the end of the barrel at s = 3 m. Determine the value of the constant c necessary for the projectile to leave the barrel with a velocity of 200 m/s.
The average density of the Sun is on the order 103kg/m3 . (a) Estimate the diameter of the Sun. (b) Given that the Sun subtends at an angle of about half a degree in the sky, estimate its distance from Earth.
A stunt cyclist rides on the interior of a cylinder 12 m in radius. The coefficient of static friction between the tires and the wall is 0.68. Find the value of the minimum speed for the cyclist to perform the stunt.
Stokes’ law describes sedimentation of particles in liquids and can be used to measure viscosity. Particles in liquids achieve terminal velocity quickly. One can measure the time it takes for a particle to fall a certain distance and then use Stokes’ law to calculate the viscosity of the liquid. Suppose a steel ball bearing (density 7.8103kg/m3 , diameter 3.0 mm) is dropped in a container of motor oil. It takes 12 s to fall a distance of 0.60 m. Calculate the viscosity of the oil.
A container of water has a cross-sectional area of A=0.1m2 . A piston sits top of the water (see be following figure). There is a spout located 0.15 m from the bottom of tank, open to the atmosphere, and a stream of water exits the spout. The cross sectional area of the spat is As=7.0104m2 . (a) What is the velocity of the water as it leaves the spout? (b) If the opening of the spout is located 1.5 m above the grand, how far from be pout does water hit the floor? Ignore friction and dissipative forces.
The mean diameter of the planet Mercury is 4.88106m , and the acceleration due to gravity at its surface is 3.78m/s2 . Estimate the mass of this planet.
Let the four compass directions north, east, south, and west be represented by unit vectors ne . . and respectively. Vertically up and down are represented as u and d. Let us also identify unit vectors that are halfway between these directions such as for northeast. Rank the magnitudes of the following cross products from largest to smallest. If any are equal in magnitude or are equal to zero, show that in your ranking, (a) (b) (c) (d) (e)
Wind velocity If v denotes the wind velocity (in m/sec) at a height of z meters above the ground, then under certain con- ditions v = c In (z/zo), where c is a positive constant and zo is the height at which the velocity is zero. Sketch the graph of this equation on a zv-plane for c = 0.5 and zo = 0.1 m.
Needs Correct solution plz don't use chat gpt or ai i definitely upvote you.
Kont Swim, who is taking Physics for the third year in a row (and not because he likes it), la rowed his boat within three foot of the dock, Kont decides to jump onto the dock and tum around and dock his boat. Explain to Kent why this docking strategy is not a good shalogy
Problem 1: Model Similitude You are designing a fountain on the moon, where gravity is one-sixth of that on Earth. You begin with a model fountain, on Earth, where the jet rises 65 feet above a lake surface. Both prototype and model fountains use water, and both have the same upward velocity where the water discharges from the jet nozzle. Neglect atmospheric resistance (from the atmosphere on Earth, and from the air inside the space station on the moon). Part A What dimensionless parameter will you match between the prototype and the model? Part B How high would the jet rise on the moon? [ft]
Instructor CE EXERCISES FOR LESSON 5 (3 page total) ht onters the urved side ot a semi-cylindnical dish ot tater alang a radius Ine at an angle ot 0-sa wll leave the dish th the ligut raugh the flat ade?If so at what angle of rehaction?tnot why nat? For Water 1.333 e