Please solve this question i will rate it.

Q: convolve (use integration) 2-) 11 (+-2) * v( x +4) Please be easier output: also snow plots when…

A:

Q: A field excitation of 20 A in a certain alternator results in an armature current of 400 A in short…

A: Given: Field excitation, If = 20 A, Short circuit or armature current, Isc = 400 A, Open circuit or…

Q: (use integration) [u(t) - u (t-1)] * 8 (+-1) Convolve also snow plots when solving to Please be…

A:

Q: A wire carrying a current of 3.8 A is located inside a magnetic field of constant magnetic flux…

A:

Q: Q2-For the circuit shown Find the following: 1-Z 28 2-I 3- P 4- Q 5- S m-m 2 ohm 3ohm 1ohm 3ohm ~…

A: We need to determine the Impedance Z, current I, active power P, Reactive power and apparent…

Q: 1. An AC circuit has a frequency of 400 Hz. A 16- resistor, a 0.0119-H inductor, and a p16.6-F…

A: Here we have to solve the questions 1 and 2 as asked.

Q: The Sinusoidal Source Learning Goal: To identify various features of a sinusoid described by an…

A: In this question We need to determine the amplitude of the voltage source, frequency in rad/s and…

Q: Determine the Nyquist sampling rate for the following signals: (a) 4 sinc(420πt); (b) 5 sinc²…

A: As per Bartleby guidelines, as more than 3 subparts are present in the question, only the first 3…

Q: Explain how an oscilloscope and signal generator are used in a lab?

A: In this question we discuss how an oscilloscope and signal generator are used in a lab.

Q: Find formulas for the current i and the voltage vc for the circuit described by the equation below,…

A: In this question we need to find the current iL(t) and voltage Vc(t) from the given equation

Q: 25 PART A) Use the principle of superposition to find the voltage v in the circuit(Figure 1)if vs =…

A: The voltage across the 10 ohm resistor can be calculated by using the superposition theorem and it…

Q: Determine vo and the required PIV rating of each diode for the configuration of Fig. 2.173. In…

A: In the forward bias condition, the diode works as a short-circuited element and in the reverse bias…

Q: For the following mechanical system, find the transfer function G(s) = X1(s)/F(s), without using…

A:

Q: Two charges q₁=-3nC and q2 +9nC are placed 5 cm apart and exerting electric forces on each other,…

A:

Q: 4. A three-phase, 11kV, star-connected alternator delivers a current of 80A at (a)0.85 pf leading,…

A:

Q: i) ii) iv) The currents I₁, I₂ and 13. (Answer: I₁ = 0.27A, 1₂ = -2.16A, I3 = -1.89A) The voltage…

A: Note: Since you have posted a question with multiple sub-parts, we will provide the solution only to…

Q: 36. Sketch iR and vo for the network of Fig. 2.180 for the input shown. 10 V -10 V + Vi 10 ΚΩ + 5.3…

A:

Q: 3.17. A power transmission line carries current from a 6000-V generator to three loads, A, B, and C.…

A: Voltage at the loads is decreased due to line resistance.  Voltage drop in a line=(current in…

Q: In a power system, there are 50 buses as follows: Slack bus = 1 Generator buses = 8 Load buses = 41…

A: Given- A power system- Number of buses n=50 Generator buses m=8 Slack bus=1 Load buses=41 To Find-…

Q: Find vo(t) for t>0 in the circuit in Fig. P7.113 and plot the response, including the time interval…

A:

Q: #5 a) f= 60 Hz FIND > R=40₂2 3 L=.05h ZIN POLAR FORM: I c = 50 μfD XL = 10-2 b) f=100 H2

A: In this question We need to determine the impedance in polar form.  We know Inductive Reactance XL =…

Q: Classify this signal: Closing prices of utility stocks on the New York Stock Exchange, according to…

A: Solution:   classify this signal: closing prices of utility stocks on the new york stock exchange,…

Q: What are the various types of power quality disturbances that can occur in an electrical power…

A: We need to explain What are the various types of power quality disturbances that can occur in an…

Q: Question 51 For the two-source circuit of Fig. 8.82, note that one source is always on. Obtain an…

A:

Q: Oblain vat t=0·15 24 i v 28 www 2n IH when i(t) = 10 cos 2tP

A:

Q: Determine four distinct types of modulation processes.

A: Solution:   Modulation is an essential process that enables the transmission of information through…

Q: Assuming the wire in Question 1 is solid and used in a single phase transmission line separated at…

A:

Q: 1. We are transmitting a digital signal whose logic levels are A (volts) and B (volts) where A<B.…

A:

Q: Define the following terms in complete sentences. 1. Zener Diode 2. Zener Region 3. Breakdown…

A: Dear student, Since you have posted a question with multiple sub parts, we will provide the solution…

Q: a) Construct the state table and determine the state equation of this circuit. (b) Consider the…

A: Given,  Transition table is (a)We need to Construct the state table and determine the state…

Q: Given the following open-loop transfer function. Hand draw the root locus of each and determine the…

A:

Q: Find VN, Vo and K when R₁ = 20KN and R₂ = 5kQ, V₁ = 1V Vs + Vp VN ip VO IN R₁ iN Feedback path R₂

A: Given  R1 = 20 K  R2 = 5 K  Vs = 1 V  We need to find out the output voltage and feedback factor and…

Q: Question 8 Given the circuit shown, obtain the Norton equivalent as viewed from terminals a-b. 120 V…

A:

Q: The reactance of a single phase line, 60 Hz, 120 km long, is 8592. Calculate: a. The diameter of the…

A: length of the line  l = 120 Km frequency  f  = 60 Hz reactance of the line XL = 8592 Ω distance…

Q: Soive using classical methods. Assume zero initial condition: dx +7x = 5cos2t dt

A: Given: A differential equation,  dxdt+7x=5 cos2t, Initial conditions are zero.  To find: Solution of…

Q: 5. Draw the digital circuit to verify De-Morgan's theorems for three variables. You can draw the…

A:

Q: *39. For the network of Fig. 2.183: a. Calculate 57. b. Compare 57 to half the period of the applied…

A:

Q: 1) For the UJT relaxation oscillator in the following figure, it is known that; RBB =2K ohm, n =0.7…

A: Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: 13. Given that gm 1ms for Q1 and hie = 1 kohm & hfe = 100 for Q2, determine Val/vin and the overall…

A:

Q: Examine the discrete-time system: y (n) = x(n) I then determine which of the following properties…

A: Given Data: A discrete-time system of, yn=xn To Verify: Static or Dynamic Linear or Non-Linear TIV…

Q: Figure P4.4(j) Figure P4.4(k) της α Νοσ D₁ Μ ΙΚΩ 1 mA 52 ΚΩ D₁ D₂ ΙΚΩ 01/0 Oto

A:

Q: 10 Α 1 ΜΜ 3 Ω Μ 2 Ω 2 4Ω 4ix 3 6Ω

A: Given a circuit diagram with current sources. Since there are current souurces apply mesh analysis…

Q: 1.2 Magnetic Circuits The figure shows a ferromagnetic core whose mean path length is 40cm. There is…

A:

Q: 64V | t = 0 4Ω χω Find the equations for 8Ω M i, (t) 40Ω 8Η i(t) fort20* 48Ω

A:

Q: 1. Expand f(x) = 0 if 0 < x 1 if TT 2 in a half-range: (a) Sine series. (b) Cosine series. < < x <…

A:

Q: 12.13 Sketch the magnitude characteristic of the Bode plot for the transfer function H(jw) =…

A: In this question 12.13 We need to draw the bode plot of the given system.  This is given in the…

Q: Given the following voltage and current: • i(t) = 5 sin(377t - 20°) V v(t) = 10 cos(377t +30°) V,…

A: Given:  i(t)= 5 sin( 377t-20°) A  v(t)= 10 cos(377t+30°) V

Q: 1. Is it possible to determine the phase relationship between a power phasor and the corresponding…

A: Three questions are given, Answers to all questions are given below.

Q: Determine four distinct types of modulation processes.

A: Modulation is a process in which low-frequency signal is converted into high-frequency signals and…

Q: What would be Av for a CC single stage? What would be Ai for a CC single stage?

A: As per the guidelines of Bartleby we answer 1st two question since this question is from common…

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.