Provide complete solution and box your final answer with appropriate unit. 1. What is the total length of the course XY if the rear tape-man holds exactly holds 9 pebbles and 3 pins after measuring the course XY? Assume that one tape length is equivalent to 30m

Provide complete solution and box your final answer with appropriate unit. 1. What is the total length of the course XY if the rear tape-man holds exactly holds 9 pebbles and 3 pins after measuring the course XY? Assume that one tape length is equivalent to 30m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: D Y (N) 2 m F X (N) |C 2 m A

Q: Suppose A= 2 3 B= 30 then calculate 2A-3B, AB – BA , A² + B² . 1 2

A: Given: The matrices are,

Q: C 15 ft D 74.4 A 30 ft B 30 ft 6.5 7.3 5.4 30 ft E 5.6 F 8.7 G 6.7 30 ft H/3.9 I|4.4 15 ft 15 ft J…

A: Consider the following diagram: Each borrow pit has been marked with a number.

Q: Using the rules for significant figures what is the sum of 7.6543 + 29.732 + 329.4 + 0.3126?

A: Given: The sum required to be found is, Sum=7.6543+29.732+329.4+0.3126

Q: Refer to Figure 7.1. A flexible foundation measuring 1.5 m x 3 m is supported by a saturated clay.…

A: Elastic settlement of a foundation occurs during or right after the construction of the structure.…

Q: The soil profile at a construction site is shown in the figure (not to scale). Ground water table…

Q: Show complete solution and 3 decimal placea for the final answer. Asap thanks! A boat rectangular…

Q: An 8m steel tape was purchased and advertised as follows: Standard temperature : 24°C Standard Pull…

A: As the ambient temperature at field is greater than that standard temperature, the length of tape…

Q: 6. Two pipes, each of diameter d, converge to form a pipe of diameter D. What should be the relation…

Q: 20 ku/m B 2. 'R 3m 2m 2m

Q: In a 200-hectare corn project, the field has to be tilled in 30 days. What size of heavyduty…

A: Given, Area A=200 hectare Tilling period = 30 days Speed =5 kph Field efficiency=75% Operating time…

Q: A prismatic shaped excavation is measured with a 1" 20' scale. The measurements are: 2" Wide x 3.5"…

A: Given: scale: 1"=20' 1"=240" width=2" length=3.5" depth=(1/2)"

Q: Compute the required derivative approximations for the functions at the specified location, for the…

Q: 3- Find the value of resultant R, if T=600N, P=450N, F=20ON, B=60°, a=40°.

A: Consider the free body diagram of the given force system. Resolution of forces in x-direction is…

Q: Q.78 A box contains 2 washers, 3 nuts and 4 bolts. Items are drawn from the box at random, one at a…

A: Explanation: The given method is drawing the items without replacement, therefore each and every…

Q: Determine the number of triangles formed given the following data of triangle ABC: a = 5.4, b = 10,…

A: To determine the number of triangles that can be formed with the given data of a triangle ABC.…

Q: sides inclined at 45

A: To find;- cost of making

Q: Using examples, describe possible mistakes AND errors involved in taping measurement, discuss…

A: Taping measurement:- Tapes are used in surveying for measuring horizontal, vertical or slope…

Q: Sand Fine Gravel Coarse Gravel % % Pit1 55 25 30 15 30 Pit2 45 Pit3 25 20 55 How many cubic meters…

Q: Given data Force=20 N Displacement=3 m Determine work done

A: This question is related with mechanics . In this question the value of force applied on object and…

Q: The length of a water course passing through the fields was measured with 30 m steel tape and the…

A: The Length of Gunter’s chain is 66 ft long. It consists of 100 links and the length of each link is…

Q: Look up the numerical value for the following factors from the interest-34 * tables (A/F,2%,16) a)…

A: Given, (A/F, 2 %, 16) It is in the form of (A/F, i, n) Here i the interest rate, and n is the number…

Q: Given: P(A) =0.70, P(B)=0.60, P(A or B) =0.88. Determine P(A and B).

Q: Determine height of 2nd floor of proposed residential apartment building from figure 1 below, as…

Q: SOLIDS FOR WHICH V = (mean B)h 8. The railroad cut shown in the figure has sides inclined at 45° to…

A: Solution: h=11+102=10.5 ft

Q: Determine whether the limit exists. If so, find its value. If the limit does not exist, indicate…

A: Given:- To find:- value of limit

Q: What are the two general types or methods of taping measurements?

Q: An 8m steel tape was purchased and advertised as follows: Standard temperature : 24°C Standard…

Q: express each common fraction as a decimalfraction. Round to four decimal places when needed. What is…

A: Given: Outer diameter, d2 = 1.836 in Thickness, t = 0.113 in

Q: *-4x If f(x): Solve to find lim f(x)?

Q: SHOW COMPLETE SOLUTION PLS VALUES: Y = 25 A = 5

A: A=5 Y= 25 To find moment about point O

Q: An 8m steel tape was purchased and advertised as follows: Standard temperature : 24°C Standard Pull…

Q: What is the total length of the course AB if the rear tapeman holds exactly 5 pebbles and 3 pins…

A: Rear tape man holds 5 pebbles and 3 pins after measuring the coarse AB partial length is 4.1 1 tape…

Q: Given the following matrices: [o 3 7 and B] 5 0 [4 6 -2 [A] = 8 9 -2 9 = !7 2 3, perform the…

A: Given values: A=0508379-29B=46-272313-4 Transpose of matrix is done by interchanging rows into…

Q: SHOW COMPLETE SOLUTION PLS VALUES: A= 5 B = 5 C = 1 Y = 25

Q: What is the total length of the course AB if the rear tapeman holds exactly 5 pebbles and 3 pins…

A: 1 pin = 1 tape length1 Tally =10 tape lengths 1 pebble = 1tally

Q: LUE: Y = 25 NOTE: ANSWER ONLY NUMBERS 10

A: Mass of each crate, m=25 kg The coefficient of static friction is as follows: μs=0.20Let us find…

Q: field measuring 45 m x 90 m is to be prepared using 1-m upland power tiller at a speed of 3 kph.…

Q: An 8m steel tape was purchased and advertised as follows: Standard temperature : 24°C Standard Pull…

Q: 6. Two pipes, each of diameter d, converge to form a pipe of diameter D. What should be the relation…

A: A1 v1 + A2 v2 = A vd2 v + d2 v = D2 (v/2) d = D ⁄ 4.

Q: Determine the magnitude of the resultang.

A: Given that:

Q: , determine the magnitude F and direction 0 gnitude of 1400 lb.

A: Given:- To find:- F and θ

Q: An 8m steel tape was purchased and advertised as follows: Standard temperature : 24°C Standard Pull…

A: To Find a. Correction due to temperature b. Correction due to pull c. Correction due to sag d.…

Q: From the data given: Determine: A) Length of side DA (round to 2 decimal places) B) Bearing of side…

Q: b. There are five rainfall gauges on a square plot of land of dimensions 2km x 2km. One of the…

Q: I Revie Part A Consider the area shown in (Figure 1). Suppose that 20 = 1.1 m Locate the centroid y…

A: Simpson rule a method for estimating the area under a curve over a given interval that involves…

Q: B|| Given the following matrix: 1 3 A = -2 4 -1 -3] Find: 1) A? 2) A-1

Question

Provide complete solution and box your final answer with appropriate unit.

1. What is the total length of the course XY if the rear tape-man holds exactly holds 9 pebbles and 3 pins after measuring the course XY? Assume that one tape length is equivalent to 30m.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Prepare and complete the differential level notes for the information shown in the accompanying table. Include the customary arithmetic check. STA BS HI FS ELEV BMa 0.53 223.96 TP1 0.33 1.20 ТР2 2.75 2.21 ТРЗ 3.44 1.68 BMb 0.95
SITUATION V: Refer to the figure below: 150 200 --- 200 100 150 23. Determine the net area tor ABCD. Thickness of plate is 10mm and the diameter of the hole is 25 mm. a. 1815 mm? b. 5125 mm? c. 3725 mm? d. 2648 mm? 24. Determine the net area tor EFG. Thickness of plate is 100mm and the diameter of the hole is 25 mm. b. 5250 mm? d. 2250 mm? a. 4850 mm? c. 3750 mm? 150 200
GIVEN: diameter of sewer pipe = 1.8mDepth of water = 1.6mQ = 2.5m3/sCompute the velocity. Use 3 decimal places all throughout the solution. Box/underline your finalanswer.
Show solution. Answer with 3 decimal places.
Pls answer this. Complete solution with figures.
Q2 #2 Solve the ff. problems. Use 2 decimal places and BOX your final answer.
PLEASE ANSWER IT COMPLETELY AND ASAP. SHOW COMPLETE SOLUTION. FINAL ANSWER MUST BE IN 3 DECIMAL POINTS. DO NOT ROUND OFF INTERMEDIATE NUMBER.
ENGINEERING MECHANICS (UPVOTE WILL BE GIVEN. PLEASE WRITE THE COMPLETE SOLUTIONS LEGIBLY. NO LNG EXPLANATION. ANSWER IN 2 DECIMAL PLACES.) 9.29 As a round log passes through a sawmill, two slabs are cut off, resulting in the cross section shown. Calculate Ix of the cross section if h = R/2. What is the percentage reduction in Ix caused by the sawing operation?
A railroad curve has De = 4°00', I = 24°00', and PI station = 35+45.00 ft. Use the chord definition to calculate the requested values. Part E Calculate M. Express your answer to two decimal places and include the appropriate units. ΜΑ M= Value Units Submit Request Answer Part F ? Calculate LC. Express your answer to two decimal places and include the appropriate units. НА ? LC = Value Units Submit Request Answer
QUESTION 1 Complete the table below. LINE BEARING DIST (M) AB N 60° 15.3' E 40.311 BC S 64° 5.6' E 38.910 CD S 42° 29.2' W 37.014 DE S 20° 23.8' W 58.541 EA N 17° 15.6' W 82.900 LAT (m) * Express all values up to 3 decimal places. * If the value is zero just write 0. DEP (m) Sum DA Area DPD DA * If the value is negative, include the negative sign without space in between negative sign and the number. Example: value = -37, input: -37.000 * For positive values, do not include the + sign in writing the answer. * Do not include the unit in writing the answer/s.
ASAP. Round off the final answers to two decimal places. ..
PLEASE SHOW COMPLETE SOLUTION WITHIN 30 MINUTES Given: F = 800 N θ = 25° μs = 0.35 Find: Pmin = ? (round of to 2 decimal placed) Pmax = ? (round of to 2 decimal placed)