Q-7 b, A transmission line has equal voltages at the two ends maintained constant by two sources a third source is to be provided to maintain constant voltage equal to the end voltages either at the mid-point or 75% of distance from the sending end then the maximum power transfer capabilities from sending end in original case and the other two cases will be in the ratio?

Q-7 b, A transmission line has equal voltages at the two ends maintained constant by two sources a third source is to be provided to maintain constant voltage equal to the end voltages either at the mid-point or 75% of distance from the sending end then the maximum power transfer capabilities from sending end in original case and the other two cases will be in the ratio?

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter5: Transmission Lines: Steady-state Operation

Section: Chapter Questions

Problem 5.12P

See similar textbooks

Similar questions

For medium transmission line under light load or no load condition the receiving end voltage is greater than sending end voltage. This is known as effect. Ferranti Effect Proximity effect Skin effect No load effect
Voltage regulation of a transmission line should be O a. as low as possible O b. None of the answers O c. as high as possible O d. 0.5
What are the maximum and the minimum value of VSWR of transmission line?
4. A 400 kV, 150 km long OHL with parameters R-0.017 2/km, X₁50.27 2/km and X 94520 2/km is used to transmit 1800 MW at 0.9 power factor (lag). Calculate the sending end voltage using: a) Simple short-line R/L model b) Full distributed line model
Consider the following statements: Surge impedance loading of a transmission line can be increased by 1. increasing its voltage level 2. addition of lumped inductance in parallel 3. addition of lumped capacitance in series 4. reducing the length of the line Which of these statements are correct? (a) 1 and 3 (b) 1 and 4 (c) 2 and 4 (d) 3 and 4
What is the necessary condition for matching transmission lines? In addition, what is a micro strip line?
1. Following are types of Transmission Lines EXCEPT A. Medium Line B. Long Line C. Capavitive Line D. Short Line 2. What is the theory used to express the voltage and current relations? A. Per-Phase B. Equavalent Transmission Line Model C. Two Ports Network 3. A 300km transmission line is considered as A. Long Line B. Medium Line C. Short Line 4. For a short transmission line, values for element A B C and D are A. A=1, B=0, C=Z, D=1 B. A=1, B=Z, C=0, D=1 C. A=0, B=Z, C=1, D=1
explain the effect of sag verses tension in an overhead transmission line
4/ Which parameter is neglected or ignored in Short Transmission Lines? A. SHUNT CAPACITANCE ONLY B. SERIES CONDUCTANCE AND SHUNT CAPACITANCE C. SHUNT CONDUCTANCE AND SHUNT CAPACITANCE D. SHUNT CONDUCTANCE ONLY
A bipolar HVDC link is delivering 1000 MW at ±400 kV at the receiving end. Calculate the losses in the line, assuming the resistance per conductor as 1 2. Also estimate the sending end power, sending end voltage, power in the middle of the line, and line losses. Ans:=PLosses = 3.75 MW, P,= 1003.75 MW, V401.25 kV, P=1001.562 MW
13.) In practice, what would happen to the transmission line voltage when it is heavily loaded and lightly loaded? A.) Constant B.) Decrease, Decrease C.) Increase, Increase D.) Decrease, Increase 14.) Given the ABCD parameters for long transmission line model: A = 0.0093 pu, B = 2 + j3 N, C = jo.o0049 S, what would be the value of the D parameter? A.) 1 B.) 0.0093 pu C.) 0.00049 S D.) 2 + j3 N 15.) The velocity of propagation of voltage and current waves along a lossless overhead line is the same as speed of A.) Light B.) Sound C.) Bullet Train D.) Thunder 16.) What parameter do we neglect when solving lossless lines? A.) Resistance above B.) Conductance C.) All of the above D.) None of the 17.) A wavelength is the distance required to change the phase of the voltage or current by how many degrees? А.) о° В.) 90° C.) 180° D.) 360° 18.) What do you call the power delivered by a lossless line to a load resistance equal to the surge impedance? A.) Surge Power B.) Surge Impedance Loading…
iii. Short transmission lines are limited in their power handling capability by the