Q3) Find the received power using the approximated 2-ray ground reflection model. Assume the height of the transmitter is 40 m and the height of the receiver is 3 m. The frequency is 1800 MHz, and unity gain antennas are used. Calculate the received power at distances 1 km, 10 km. Assuming the ground reflection coefficient of -1. The E-field at 1 km from the transmitter is measured to be 10-3 V/m.

Q3) Find the received power using the approximated 2-ray ground reflection model. Assume the height of the transmitter is 40 m and the height of the receiver is 3 m. The frequency is 1800 MHz, and unity gain antennas are used. Calculate the received power at distances 1 km, 10 km. Assuming the ground reflection coefficient of -1. The E-field at 1 km from the transmitter is measured to be 10-3 V/m.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

b) A particular antenna has a VSWR of 2.4. Determine the following and, in each case, show full working: i) Reflection coefficient. Please transpose the equation for VSWR and show your working. ii) Calculate the mismatch efficiency of the antenna. Show your working.
Describe the working principle of loop/sense antenna in ADF. Then, draw the resulting radiation field of ADF antenna.
1.) If the far field distance of a pyramidal horn antenna at 200 MHz is 3.5 m, what is the width of the antenna, in meters? 2. The near-earth range equation is used by the cell phone industry to determine the maximum range between a cell phone and a repeater. Determine the change in maximum range if the repeater antenna height is increased by a factor of two. step by step and clear thanks.
b) Fill in blanks with a suitable answer 1. The bandwidth of an antenna can be broader by increased the... 2. Radiation pattem is . . dime nsional quantity 3. One steradian is equal to . . square degrees 4. The minimum value of the directivity of an antenna is. . 5. The radiation resistance of short dipole is given by... 6. Gain is equal to directivity in case of ... 7. Radiation resistance of antenna is.. .
Determine the radio horizon for a transmit antenna that is 100 ft high and a receiving antenna that is 50 ft high and for antennas at 100 m and 50 m.
(B) A commercial 50 92 Radio Shake coaxial cable is used to carry RF signal power from a transmitter to an antenna of 300 2 as a load through flat antenna transmission line with 300 2 characterstic impedance as shown in Figure 3. The above situation would happen if we connect the coaxial cable to the antenna without a matching techinque. Determine: 1- The reflection coefficient at junction B. 2- The input impedance at point A. 3- The reflection coefficient at junction A. 4- The fraction of the reflected power. 5- The fraction of the transmitted power to the antenna. 1²=0 5052 30052 (B) Z₁ = 30052 Figure 3
QA3 Dish antennas are a common type of antenna at high frequencies. (a) Explain the design and operation of dish antennas with the use of equations and diagrams. Discuss different types of dish antennas and identify the main advantages and disadvantages of each type. Identify the main trade-offs between different types of dish antennas and suggest ways to improve efficiency. (b) With the aid of diagrams, explain the following three types of radiation patterns and give examples of where each type is used: (i) (ii) (i) Isotropic Omnidirectional Directional
2- Directivity is inversely proportional to...... (A) Beamwidth (B) FNBW (C) Beam area (D) HPBW Z so reflection coefficient is 12 4- What determines antenna polarization? (A) The direction of the electric field vector (B) The direction of the radiated wave (C) The direction of the magnetic field vector (D) The frequency of the radiated wave 5- Antennas convert -to- (A) Electrical into electromagnetic (B) electromagnetic into electrical (C) Both A and B (D) None of the these
P 2.7a What will be the cutoff wavelength for dominant mode in rectangular waveguide whose length is 10 cm? (2)
ATR works by measuring the changes that occur in an internally reflected IR beam when the beam comes into contact with a sample.. True False
Orientation of victim and electromagnetic-wave EMI. The rule that an antenna must be a few percent of a wavelength long to operate effectively becomes a problem with long-wave signals (below 3 MHz), where the wavelengths exceed 100 m. As a result, some radios receive only the magnetic field associ- ated with the radiated wave, because magnetic-field pickup devices can be much smaller than a wavelength and still operate reasonably well. One way this is done is with a type of antenna called a loopstick, which is basically a long cylindrical magnetic core inside a coil of wire. The loopstick antenna is sensitive only to the component of the magnetic field that is parallel to the axis
From an operational point of view, what are the major differences between the Yagi-Uda and the log-periodic antennas? Explain, with the aid of diagrams.