Q3) For the open loop system G(s) Do the following: 1-Draw the Bode plot on a semi-log paper. 2- Find the phase margin, gain margin, and check the stability. 3- Find the error constant Ky. CAL s(s²+s+50) hoot for the second order factor and draw it

Q3) For the open loop system G(s) Do the following: 1-Draw the Bode plot on a semi-log paper. 2- Find the phase margin, gain margin, and check the stability. 3- Find the error constant Ky. CAL s(s²+s+50) hoot for the second order factor and draw it

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: (4) By using Routh-Hurwitz method find the stability of the following system characteristic…

Q: 2. Find the surface current density, K, for the following boundary condition: (Ħ₁−Ħ₂)×î = K‚K is the…

Q: In a three-phase balanced delta-delta system, the source has an abc-phase sequence. The line and…

A: The line impedance, Zl=0.3+j0.2ΩLoad Impedance =ZAB=ZBC=ZCA=9+j6ΩPhase 'AB' current of the load,…

Q: A series RLC circuit has R = 20 kQ2, L = 0.2 mH, and C= 5 μF. What type of damping is exhibited by…

Q: please update the solution TT

A: Since you have asked multiple questions in a single request, we will be answering only the part (c).…

Q: Find to in the circuit using superposition. 202 www 4 A 392 542 wwwww ww 192 510 4 20 V 402…

Q: 2) Calculate the total current (IT)? ( C1 0.1pF 14V 15 kHz R2 33052 www. C2 0.047µF C3 R1 47052…

Q: A transformer has 1200 primary turns and 200 secondary turns. The primary and secondary resistances…

Q: + V M 7mA → 5kQ (b)

Q: Determine the total solution for n20 of a discrete-time system characterized by the following…

Q: (a) Find the phasor form of the following vector – T A = 5e-¹0² cos at - 2 + 1 3 2 b) Find the…

Q: Derive the of QPSK overall scheme. probability of symbol error

A: We need to derive the overall Probability of symbol error .

Q: Decimal Binary 0000 0001 0010 0011 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 45 15 0100 0101 0110 0111 1000…

A: Yes, the table is filled correctly. To find out the octal equivalent, group three bits each starting…

Q: A microwaye receive receiver has a total input noise power of -108 dBm and an overall noise figure…

A: We need to find out minimum recived carrier power for given FM system .

Q: Mark all that apply for the circuit below if i = 5A. 25 Ω www 2002 1052 Ω The current ix = 75A ww…

Q: 6.) Based on the following diagram, compute and plot y(t) if x(t) is the following: x (t) a.) 5cos…

A: Given: A system with following block diagram, To find and plot: Output y(t) if input x(t) is, a)…

Q: A combinational circuit has three inputs x, y, and z and three outputs F1, F2, and F3. The…

A: Given, A combinational circuit has three inputs x, y, and z and three outputs F1, F2, and F3. The…

Q: Q1. Find the work needed to move an object along a straight line path from A(x=-1,y=1,z=0)…

Q: For VGs=0, the drain current becomes constant when Vos exceeds OVDD O Vp O OV cutoff

Q: 1. Sketch and obtain the vector a + b and the vector a-b b 18

Q: 15 V 싸 25k (c)

Q: The output of a measurement device (sensor/transducer) ranges between 0 Vdc minimum to +0.375 Vdc…

A: According to the question, the input to the 741 OP-AMP +0.375 Vdc. If the output of the amplifier is…

Q: 3. (a) Determine and plot the approximate magnitude response diagram by using DFT for the following…

A: DFT-

Q: The field strength has a great effect on voltage life. The relationship of the voltage life L with…

A: Given, The field strength has a great effect on voltage life. The relationship of the voltage life L…

Q: 25. A delta - connected load whose phase impedances are ZAB= 50 2, ZBC = -j50 , and ZCA = j50 2 is…

A: Given in delta connected LoadzAB=50ΩzBC=−j50ΩzCA=j50Ω.VP=100∠0∘=VAB,VBC=100∠−120∘V1VCA=100∠120∘V We…

Q: The output of a sensor is to be filtered with a cut-off frequency of 10 Hz. The nominal input…

A: According to the question, the output of a sensor is to be filtered with a cut-off frequency of 10…

Q: The output of a measurement device (sensor/transducer) ranges between 0 Vdc minimum to +0.375 Vdc…

A: According to the question, the input to the 741 OP-AMP +0.375 Vdc. If the output of the amplifier is…

Q: TYU 9.8 Use superposition to determine the output voltage vo in the ideal op-amp circuit in Figure…

A: Given A op amp circuit ,find the Vo of the circuit

Q: The primary of a 500/5 A, 5 VA, CT Carries 200A and secondary carries 2.5 A. The ratio error of the…

Q: The figure below shows part of a circuit. 13- w 14 1₂ M M = 0.5A, 1₂ = 6A, and 13 = 3.6A. Determine…

A: We need to find out the current for given circuit.

Q: In the single phase diode bridge rectifier shown in figure, the load resistor is R = 50 2. The…

A: The given bridge is shown below, The resistance, R=50 Ω The voltage is v=200sin(ωt) ω=2π×50 rad/s

Q: 18ΚΩ 20uV 22ΚΩ Determine the gain of each stage 680kΩ a. b. Calculate VOUT if VIN = 20 μV C.…

Q: 2. Consider the continuous-time signal x(t) plotted below. Sketch y(t) = 4x(-2t + 2). x(t) -6 -4 -2…

Q: Consider the function f(x) = 1, defined on the interval [0,1]. a) Find the Fourier cosine series…

A: given that function f(x) = 1 , defined for interval [0,1] To find the Fourier series coefficients…

Q: For the following electrical circuit: 1. apply Kirchhoff's method and generate the system of…

A: “Since you have posted multiple sub parts,we will provide the solution only to the first three sub…

Q: Solve for V and I. 6 V www 20 R₂100 www 3021

Q: 2. In the following circuit, ن منه a. b. C. 16 A Use the current divider to find the current ix.…

A: Introduction Current divider rule The current divider rule is a common electrical circuit formula…

Q: Example: find the complex Fourier expansion of the periodic function shown below f(x) = cosx π -<x</…

Q: PM 181 Q3: A step-index multimode fibre with a 50 µm core diameter and 10 km distance is designed to…

A: We need to find out the intermodal dispersion and numerical aperture for given fiber .

Q: Assume after sending its frame, node A wait for the acknowledgment back from node C before sending…

Q: 12 mA 14₂2 www 3 mA 2 mA -+) 14 4 mA

A: Given the network, we have to find out the current following branch,

Q: Determine I, and I. 3 V 100 Ω 200 Ω Μ 201 220 Ω Τ

A: Given data: circuit diagram is given as:

Q: X₂ find the transition matrix of this channel shown below and l(x, z) if p(x1)-0.8? xz. 1 Add file…

Q: A 200V long-shunt generator delivers 100A, has an armature resistance of 0.050, a series field…

Q: PROBLEM: The impedance of the primary windings of a 22000/440-V three-phase delta-star transformer…

Q: Find and illustrate the approximate magnitude response by using DFT for the following sequence: 3…

A: Given: Magnetic response using DFT for sequence is xn=2cos2π38n, where N=10.

Q: sinusoidal discrete signal as an input to that system. What would be the output of that system?…

Q: Problem 1-A 6 V battery with storage capacity of 2 A-hr and internal resistance of 1 2 is connected…

A: In this question We need to determine the energy in the battery. We know Energy E= power× time

Q: solve for d, a=-bcd

A: We have given an equation and we need to find the value of d variable in terms of other variables…

Q: Vgen 10 V 109 F 3 ΚΩ 10³ H 1 kn Vout 3. In the circuit shown the generator voltage is given by, Vgen…

Question

50
s(s²+s+50)*
Q3) For the open loop system G(s)
Do the following:
1-Draw the Bode plot on a semi-log paper.
2- Find the phase margin, gain margin, and check the stability.
3- Find the error constant Ky.
4- Find the magnitude of the overshoot for the second order factor and draw it
on the graph.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step by step

Solved in 5 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

D Skech by hand the asymptotes of the Bode maunitude and phase plots Sor the open loop trens fer function below, Embellish the plots with a rough estimate of the transitious for each break -point. Label the slopes od the maunitude plot dB /decade Osymptotes in (s+2)° s² ( s+10) ( s²+ 6s +25) LG)=
Identify the reason for a nonsinusoidal signal being distorted when it passes through a filter. -The distortion occurs because harmonics are removed or rejected, leaving a different waveshape. -The distortion occurs because harmonics are synchronized, leaving a different waveshape. -The distortion occurs because the signal is modulated, leaving a different waveshape. -The distortion occurs because harmonics are added in the filter, leaving a different waveshape.
We use the transfer function Vo (s) / Vi (s) for the electric circuit given in the figure.in terms of parameters. R1 = 1Kohm to the transfer function you found,Bode the expression you get by typing the values R2 = 1Kohm C1 = 1nF, C2 = 1nFDraw the diagram.
9 - In Bode diagram the frequency at which the two asymptotes meet is called ... A) the corner frequency B) asymptotic frequency C) gain cross over frequency O D) gain frequency O E) phase cross over frequency
H.W: A resistor of resistance R-1000 2 is maintained at 17 °C and it shunted by 100 uH inductor. Determine the rms noise voltage across the inductor over a frequency bandwidth of: i) 15.9 kHz Ans: 182 x109 volt ii) iii) Ans: 9.22 x10-8 volt Ans: 2.34 x10-6 volt 159 kHz 1590 kHz
A coutimuous-time sinusoid has frequency 2 = 70r rads sec and is sampled at a sampling interval of T=0.01 sec. What is the frequency of the discrete-time sinusoid? %3D Oa =70z rads ses OL- 0.7z rada sec Oce= 7x rads sec Od0= 7000r ads see
Now, how (as what equivalent value) does this capacitor transform into the frequencydomain?
Draw polar plot for the open loop function given. Determine Phase margin, Gainmargin, Phase cross over frequency, Gain cross over frequencyG(s) H(S)= 1/s2(1+s)(1+2s)
a. Determine the frequency responseVout( jω)/Vin( jω) for the circuit of Figure. b. Plot the magnitude and phase of the circuit forfrequencies between 10 and 107 rad/s on graphpaper, with a linear scale for frequency. c. Repeat part b, using semilog paper. (Place thefrequency on the logarithmic axis.) d. Plot the magnitude response on semilog paper withmagnitude in decibels.
Subharmonics are the interharmonics with frequencies lower than the fundamental frequency. True False
Proposed an industrial application with a transfer function. Using the proposed transfer function: 1. Sketch the corresponding magnitude and phase asymptotic Bode plot by hand (Using semi log paper). 2. Plot the corresponding Bode plot in MATLAB and verify that the result corresponds to you hand-sketched asymptotic plot. refer here https://www.mathworks.com/help/ident/reflbode.html 3. Use the MATLAB function to obtain the gain margin and phase margin. Tips: watch class video 4. Comment on system stability based on obtaining gain margin and phase margin.
Problem 5 Using Multisim, design RC HPF considering R=5KN, C=4nano farad. Simulate the design and find out cut-off frequency. Make suitable assumptions wherever necessary.