Q3(b) A 3-phase, 50 Hz, 66 kV overhead line conductors are placed in a horizontal plane as shown in Figure Q3(b). The conductor diameter is 1-25 cm. If the line length is 200 km, calculate : (i) capacitance between any two conductors; (ii) charging current per phase, assuming complete transposition of the line and (iii) capacitance between two conductors of a 3-phase line and explain how capacitance exist between the two conductors. -2m –

Q3(b) A 3-phase, 50 Hz, 66 kV overhead line conductors are placed in a horizontal plane as shown in Figure Q3(b). The conductor diameter is 1-25 cm. If the line length is 200 km, calculate : (i) capacitance between any two conductors; (ii) charging current per phase, assuming complete transposition of the line and (iii) capacitance between two conductors of a 3-phase line and explain how capacitance exist between the two conductors. -2m –

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Derive the equation of Capacitance per phase for the 3-phase double circuit line with hexagonal spacing. (transposition of conductors is not required)
Single core cable design for 25 kV. The radius of conductor is 0.5 cm. The insulation material consists of two layers. The thickness of each layer is 2 cm. The voltage of first and second layers are 20 kV, 5 kV respectively. The minimum Electric stress of the cable is *
A three phase, 11 KV, underground cable system, consider a single core of conductor radius 0.5 cm diameter and lead sheath of 1.25 cm. The core and lead sheath have been separated by two intersheaths with radius 0.75 cm and 1 cm. Draw the cable core, dielectric and intersheath layers showing the thickness of each layer, then determine the voltages on the both intersheaths. Suppose the maximum stress on the layers are the same.
Single core cable design for 25 kV. The radius of conductor is 0.5 cm. The insulation material consists of two layers. The thickness of each layer is 2 cm. The voltage of first and second layers are 20 kV, 5 kV respectively. The maximum Electric stress of the cable is
12. There are 6 conductors in a double circuit line. Each conductor has a radius of 12 mm. The 6conductors are arranged horizontally. The center to center distance between the conductor is 2m. The sequence of conductors are from left to right as follows: a,b.c,a', b', c'. Calculate the inductance per km per phase of system. the a' 2 m 2 m 2 m 2 m 2 m
In a string of suspension insulator with three units, the line unit has 20kV and k=0.35. The voltage across tower unit is........ and across middle unit is.......
In an outdoor substation the three bus-bar conductors are supported by units of post type insulators. Each unit consists of a stack of 3 pin type insulators fixed one on the top of the other. The voltage across the lowest insulator is 15kV and that across the next unit is 12kV. Estimate: i. ratio of mutual to self-capacitance ii. the bus-bar voltage of the substation. iii. Efficiency across the string of insulators
Q2. A 3-phase, 132 KV, 50 Hz, 100 Km, single circuit bundle conductor transmission line as shown in the figure below. If the diameter of each strand is1 cm, and the conductors are regularly transposed. Determine, the capacitance to neutral per phase per Km . 6 m 5 m 0.18 m
(a) A three phase transposed transmission tower comprises of three-bundled conductor and double-circuit configured in vertical position as shown in Figure 2. Each sub-conductor in each circuit and each phase is an ACSR type, size 477,000 cmil and stranding 26/7. Given the GMR of each sub-conductor is 0.8809 cm and diameter is 2.1793 cm, analyze: i. Inductance in mH/km ii. Capacitance in µF/km 0.75m 7.5m b' 4m 4m 45cm Figure 2
A three phase, 33 KV, underground cable system, consider a single core of conductor radius 0.8 cm diameter and lead sheath of 2.3 cm. The core and lead sheath have been separated by two intersheaths with radius 1.3 cm and 1.8 cm. Draw the cable core, dielectric and intersheath layers showing the thickness of each layer, then determine the voltages on the both intersheaths. Suppose the maximum stress on the layers are the same. Please i need it know please
1. A Single-phase, two-wire overhead line has solid cylindrical copper conductors with 2.4 cm diameter. The conductors are arranged in a horizontal configuration with 3 m spacing. Calculate the inductance of each conductor due to both internal and external flux linkages in mH/km. (
INSULATORS A string of suspension consists of four (4) units. The Voltage between each pin and earth is 0.14 of the Self-Capacitance of the unit. The Voltage between the Line Conductor and earth is 135 KV. Find the Voltage distribution across each unit. Draw the diagram.