Answered: Q#4 Draw the Bode log-magnitude and…

Q#4 Draw the Bode log-magnitude and phase plots for the system shown in Figure R(s) + E(s) C(s) G(s) Where (s+ 25) G(s) = %3D (s + 1)(s+ 7)(s+ 07) Solution#4 I

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: A 500 µH inductor, 80/π^2 pF capacitor and a 628 ohm resistor are connected to form a series RLC…

Q: A series RLC circuit is connected to a voltage source of 100 V. maximum current of 0.5 A flow…

A: The solution can be achieved as follows.

Q: 5. A 12V DC voltage source vs has an unwanted frequency component at 600 Hz: v, = 12 + 2cos…

A: Chemical, nuclear, solar, or thermal energy is converted into electrical energy by a dc voltage…

Q: For the series RLC circuit shown, the frequency of the voltage source v, = 20cos(@ot) V is adjusted…

A: In the circuit, Resistance, inductance and capacitance are connected in series. At resonance XL =…

Q: b) Draw the locus diagram of the circuit shown in fig.(5), then find the value of RL that makes the…

A: Draw the current locus of given network Find the resistance R for resonance. At resonance,…

Q: 1. The resistance and inductance of the circuit are 100Ω and 20mH, respectively.1. Find the value…

A: (1) Write the condition for a critically damped system and substitute the known values.

Q: RLC Circuit: Below are some values of resistors, capacitors, and inductors which are used in setting…

A: Given : In the given question they have mentioned two cases for each case they want to know the…

Q: (1) The circuit shown in Figure 1.7 is a second-order RLC circuit where a capacitor, inductor and…

Q: Q. For the circuit shown, calculate the lower and the upper critical frequency due to the input…

Q: A parallel RLC circuit has an admittance of 20 ms when it resonates at 10 KHz. Given the quality…

A: In this question, RLC are parallel connected. Admittance at the resonance frequency 10k Hz is 20ms.…

Q: A second order system has damping ratio 0.2 and natural frequency 10 rad/sec. Therefore resonant…

A: The resonant frequency in rad/sec is as follows: ωr=ωo2-2β2β=0.2ωo=10 rad/secωr=102-×20.22 =9.89…

Q: Question 03: a) - The following RC circuit is described by a constant coefficient differential…

Q: 5) Assume C1= luF, C2 does not need to equal C1. Design a circuit that has the asymptotic magnitude…

A: Since there are five circuits given in which we have to use according to given bode plot. I am…

Q: 4. The frequency response of an RLC circuit is provided as jw +1 (jw+ 1)² + 9 H(juw): Use MATLAB to…

A: The frequency response of an RLC circuit is provided as, Hjω=jω+1jω+12+9 The above transfer function…

Q: Problem 1 Given: i(t) = I cos(ot) amps. find H(o)=V./I for the circuit below. i(t) www 10 92 10 92…

A: As per the guidelines of Bartleby, we need to solve Only First Question among multiple individual…

Q: G(s)=150(6.25s+1)(s+7)/[s(46.875s+1)(s+5)(s+15)] Draw bode plot using straight line

A: The Transfer function of the system is given as G(s) = 150(6.25s+1)(s+7)s(46.875s+1)(s+5)(s+15)The…

Q: BONUS: Consider the circuit shown below. Select values for the capacitances and inductances to…

Q: 1. Consider the circuit shown below. Select values for the capacitances and inductances to obtain a…

Q: Consider the circuit shown below. Select values for the capacitances and inductances to obtain a…

Q: s+1 e) Illustrate the bandwidth ( waw ) for the system G (s)= 5s +1 via Matlab or any other…

A: [e] The given transfer function is

Q: BONUS: Consider the circuit shown below. Select values for the capacitances and inductances to…

Q: A series RLC circuit has a resistance of 25.0 Ω, a capacitance of 50.0 μF, and an inductance of…

A: Given that R=25 ohmC=50×10-6 FL=0.30 HV=120 voltf=60 Hz Calculate capacitive and inductive…

Q: 2. A circuit consists of an inductor which has a resistance of 10 Q and an inductance of 0.3 H, in s…

A: In this question we will find series RLC circuit impedance , resonant frequency and stored…

Q: Let Vs = 20 cos(wt) V. The magnitude of the capacitor voltage |Vc| at resonance is..V 12 kQ 45 k2 I…

Q: Q3/ Plot the Bode diagram of the below system 0. 1s(s + 5) G(s) (s + 6)(s + 2)

A: Control systems are represented by transfer function. This can be written in both time domain and…

Q: In the above circuit, when Ri=0, the frequency a is 1.2 kHz in the amplitude spectrum drawn. The…

Q: For the system described by the following differential equation: a. Plot the poles and zeros on the…

Q: The vector sum of the voltages across the capacitor and inductor in a series RLC circuit at…

A: TRUE

Q: (a) A system consists of two components that can be presented by the respective h₁ (t) =…

A: GIVEN: h1(t)=3000e-20th2(t)=t e-10tu(t) input voltage of the system…

Q: A parallel RLC network is constructed using R = 5 Ω, L = 100 mH, and C = 1 mF. (a) Compute Q0. (b)…

Q: A series RLC circuit, which is driven by a variable frequency and 2 A current source, has the…

A: Solution : In case of series RLC circuit the quality factor is given by Q={ [1/R ] × √(L/C) }…

Q: A series RLC circuit, which is driven by a variable frequency and 2 A current source, has the…

A: given R = 1K OHM L= 100mH C= 10uF

Q: Plot the following Transfer Functions T(s), [Magnitude and Phase] Vo(s) 100 (1+10-4 S)(1+10-6 s) 1.…

A: Given the three transfer functions: 1. T(s)=Vo(s)Vi(s)=-100(1+10-4s)(1+10-6s)(1+10-2s)(1+10-8s) 2.…

Q: (d) The change in the resonant frequency for a small change in the inductance, AL, and capacitance,…

A: The oscillation of a system at its natural or unforced resonance is known as the resonant frequency.…

Q: A filter circuit consisting of a series L-C in parallel with an inductor is to be designed to pass a…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: Construct the magnitude and phase plot for the following transfer functions 100(s +20) H(s) = s(s+…

A: By observing se can se that the system is single input single output. The order of the system can be…

Q: Q4: For the circuit shown, calculate the value of the capacitance (C,) if the resonant frequency is…

Q: = 10 2 C = 10 µF R = 40 2 %3D R. HE Vị :R (a) Using the numeric values provided above, complete the…

Q: ) Draw the locus diagram of the circuit shown in fig.(5), then find the value of RL that makes the…

A: Draw locus diagram of the given network with variable of resistance RL Find the value of RL at…

Q: Determine intersection of asymptotes, breakaway points, and imaginary axis crossing point with…

A: The given transfer function Determine the number of asymptomates Angle of asymptomates Centre of…

Q: BONUS: Consider the circuit shown below. Select values for the capacitances and inductances to…

Q: 4. A coil whose resistance is 10 ohms and inductance of 50mH is connecte in parallel with a series…

A: According to the given data, equivalent circuit is shown below. At resonance, the circuit should be…

Q: Consider the RLC series circuit shown with ve(t) = 10cos(wt) V, R = 15N, L = 3mH and C = 7µF.…

Q: 2. For the following forward transfer function of a system separately plot the magnitude and phase…

Q: In the circuit in the figure, Rs = 3.8 kΩ, R1 = 82 kΩ, R2 = 22 kΩ, RC = 5.6 kΩ, RE = 1.5 kΩ and RL =…

A: Answer for this question is as follows:

Q: A series RLC circuit, which is driven by a variable frequency and 2 A current source, has the…

Q: Determine the resonant frequency in rad/s and hertz of a series circuit composed of a 100-nF…

A: When an inductor coil with an internal resistance is connected in series with capacitor with no…

Q: Q. For the circuit shown, calculate the lower and the upper critical frequency due to the output…

Question

AABBCCI
abe x, x'
-A
T Heading 2 T Heading 6
T Normal
Font
Paragraph
Styles
Solution#3
Q#4
Draw the Bode log-magnitude and phase plots for the system shown in Figure
R(s) +
E(s)
C(s)
G(s)
Where
(s + 25)
(s +1)(s+ 7)(s + 07)
G(s) =
Solution#4
I
O#5
prds: 440
W

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

30. Realize the imego phase fiteo with tue impulse desponse - hon) = son) + Scn-+) - son2) + scna)+SCny) %3D
A parallel R-L-C circuit is fed by a constant current source of variable frequency. The circuit resonates at 100 kHz and the Q-factor measured at this frequency is 5. Find the frequencies at which the amplitude of the voltage across the circuit falls to (a) 70.7% (b) 50% of the resonant frequency amplitude.
Now, how (as what equivalent value) does this capacitor transform into the frequencydomain?
21) Looking at the following circuit, select the correct Transfer fucntion. Please recognize that the answers are expressed in rectangular coordinates and not in magnitude, making this an easy problem. 21). ww w For the circuit in the given figure, assume L = 0.5 H and R= 200 kohm. ele O Vout (jw) Vin (jw) 200 k Vin R Vout –200 k+jw0.5 Vout (jw) ju0.5 200 k- jw0.5 Vin (jw) O Vout (ju) Vin (jw) - jw0.5 200 k– jw0.5 Vout (jw) 200 k Vin (jw) 200 k+jw0.5
a. Determine the frequency responseVout( jω)/Vin( jω) for the circuit of Figure. b. Plot the magnitude and phase of the circuit forfrequencies between 10 and 107 rad/s on graphpaper, with a linear scale for frequency. c. Repeat part b, using semilog paper. (Place thefrequency on the logarithmic axis.) d. Plot the magnitude response on semilog paper withmagnitude in decibels.
A coutimuous-time sinusoid has frequency 2 = 70r rads sec and is sampled at a sampling interval of T=0.01 sec. What is the frequency of the discrete-time sinusoid? %3D Oa =70z rads ses OL- 0.7z rada sec Oce= 7x rads sec Od0= 7000r ads see
H.W: A resistor of resistance R-1000 2 is maintained at 17 °C and it shunted by 100 uH inductor. Determine the rms noise voltage across the inductor over a frequency bandwidth of: i) 15.9 kHz Ans: 182 x109 volt ii) iii) Ans: 9.22 x10-8 volt Ans: 2.34 x10-6 volt 159 kHz 1590 kHz
D Skech by hand the asymptotes of the Bode maunitude and phase plots Sor the open loop trens fer function below, Embellish the plots with a rough estimate of the transitious for each break -point. Label the slopes od the maunitude plot dB /decade Osymptotes in (s+2)° s² ( s+10) ( s²+ 6s +25) LG)=
Q2: Express each of the following functions in phase angle form and sketch the fre- quency spectrum (a) f(t)= 2+3sint- 2 sin3t – cos5t (b) f(t)=1-sint+ 2cost – cos2t + cos3t – 2 sin3t (c) f(t)= sin t cos3t
Complete the table below with the transient response characteristics of following transfer function. Rise Time sys = s²+28+3 S4 +1.55³ +5s² +6s+2 Settling Time Overshoot SteadyState Value
A non-inductive resistor R is connected in parallel with an inductive reactance of 10 ohms. The combination is then connected in series with a capacitive reactance of 5 ohms. Solve for the value of R at which the circuit will be at resonance.
Square law circuit produces Standard AM without Harmonics O DSB-LC with harmonics DSB-SC with harmonics O DSB-LC without harmonics