qa O ac Oq % O qd Calculate the magnitude of the electric field at the location of charge q. given that the square is 5.00 cm on a side and q=2.00 μC, given that qa= qb= +0.74 μC and ge= 94 = -0.74 μC. N/C

Q: Define the quantization error and then show how it is changing when using an A/D converter with…

A: When an analogue signal is converted to a digital signal by an analog-to-digital converter (ADC), a…

Q: Q1) for the signal that is shown in the figure below A) plot the amplitude spectrum X(t) 2 A 4- B)…

A:

Q: 4. Exercises Qu 1. Generate Bode Plots of the transfer functions given below. Use them to obtain the…

A: The given transfer functions are as follows,“Since you have posted a question with multiple…

Q: The Fourier transform Continuous-time function X(t) is X(+) = Sx(+) @J₂Xpt dt j2xAt Find the Fourier…

A:

Q: 10) The "Four Quadrant Operation" principle: a) implies that the power is bidirectional. b)…

A: The above questions are based on Power Electronics.

Q: 2. Find the voltages across R1, R2 and R3 10 V: + 292 ww R₁ AD₁ Si R₂ 322 Si D₂ R3 222

A: Given:A diode circuit,To find:Voltages across all resistances.

Q: Q4. For the following circuit, vs (t) = cos(5t). Redraw the circuit in Fourier Domain with all the…

A:

Q: Energy and Potential • Exercise: Calculate the work done in moving a 4 C charge from B(1, 0, 0) to…

A:

Q: A 470- uF capacitor is connected in series with a 120- k2 resistor. How long will it take the…

A:

Q: 20 40° (St3-j4) I₁ -(3-j4) I₂ 10 490° (3-j4t2) I2-(3-j4) I, -213 -15 40°= -10 490° = (12+2) I3-212

A: Given equations:Aim:Find the solution for

Q: FIND io and Vo

A: In this questionWe need to determine the voltage Vo and current io  as shown the circuit. We are…

Q: 8- Find E at the origin if the following charge distributions are present in free space: point…

A: X= constant means YZ Plane and X is perpendicular axisY= constant means XZ plane and Y is…

Q: A: A single core cable covered by the lead, if the radius of the cadactor is r and the insulator…

A: Cross Section of Underground Cable: Given:Single Core Cable covered by Lead Radius of conductor =…

Q: What kind of filter gives an insertion loss graph like in the figure? Amplitude O A. Low-pass B.…

A: This question is related to filter design. There are so many types of filters.

Q: Q4) If we have a point charge for which Q=4* 10-¹6 and m= 10* 10-26 kg is moving in combined fields…

A: Given Point charge: A point charge is defined as an electric charge assumed to be concentrated at a…

Q: 6- Let S = 120 cm², d = 4 mm, and ER = 12 for a parallel-plate capacitor. a) Calculate the…

A:

Q: Find the Fourier Transform

A: The above function x(n) is given as:

Q: Given the following periodic continuous-time signal x(t) = 3 cos (50nt) + 10 sin(300nt) signal is…

A: Given Data:A continuous-time signal of,Sampling Frequency To Find:Discrete-Time signal.Observation…

Q: Q5-single phase half wave-controlled rectifiers with inductive load R-L connected with AC power…

A: In this questionWe need to choose the correct option. What is rms load current in the single phase…

Q: 8/ Find the modulation index for the following AM modulated signal: () 2 15 1 05 0 -05 -1 -15 -2 0…

A: here we have to find the modulation index of the AM signal.

Q: 3. In the control system shown below, determine the value of ki and k₂ so that the damping ratio and…

A:

Q: 7. 4.4-2. Consider the circuit shown below. Use Laplace transform techniques to solve the following:…

A: Solution:Given data :=> R=C=1=> x(t)==> Find :=> here find first standard form for…

Q: Q.12: Consider the linear transformer in Fig. Q12. Determine the input impedance Zin and the current…

A:

Q: 12/0° V www -j4 () ¹1 20 j20 L₂ 4 [1 X/90° A

A: it is asked to find vo using thevenin's method

Q: 1. For the following circuit, a. find a. b. find wo. c. write a differential equation in v(t). d.…

A: As per our guidelines we are supposed to answer first three subparts only.

Q: i(t) 10 H 4 kQ ww iload (t) 2 μF + Vload(t)

A: Given Data:An AC circuit with,Input current source Resistor Inductor Capacitor To Find:Phasor…

Q: Can you redo this again? The answer should be typewritten, thanks. Provide the following: Step 1.…

A: Asked to find transfer function by using Mason's rule

Q: 1) Each line of a 3-phase system given in figure is suspended by a string of 5 identical disks and…

A: Solution:

Q: what is the voltage across the R1 resistor? expressed in volts with 2 decimal places what is the…

A: Note: Since you have mentioned for a handwritten solution, I am solving it in both the formats of…

Q: Use the node voltage method to find the fault at node 2. Voltages before fault: V₁ = 8027.1∠0. 685°…

A: before fault, the voltage at node 1 and node 2,

Q: 4 DECIMAL PLACES : 2. (a) Calculate the step angle of a single-stack, 4-phase, 8/6-pole VR stepper…

A: Given dataThe number of phases of the given single-stack variable reluctance stepper motor is .The…

Q: (d) X(z) (b) X(z) Z 16z² + 1 5z + 1 4z² + 4z + 1

A: Given functions:(d) (b) Aim:To find inverse z-transform

Q: 4-0: Determine initial and final values of h(t) = £¹ [H(s)] if 5s² + 5s + 14 s3 +8s² + 12s H(s) =

A: Function is given as,

Q: what is the secondary rms voltage, filtered dc voltage, maximum voltage at the output, pk to pk…

A: Find :-Secondary RMS voltage = ?Filtered dc voltage = ?Maximum voltage at the output = ?Ripple…

Q: Consider the ac circuit in Fig. 25 cos(4x 10³) V Determine io using nodal method. 2 k Figure 2 µF…

A: it is asked to find the current io using nodal analysis

Q: 2- The output of the non-inverting a. Is in phase with the input. amplifier b. Increases with the…

A: “Since you posted multiple questions, we will provide the solution only to the first question per…

Q: 2. The 2-to-4 decoders with active-low outputs are available as building blocks. Each block has two…

A:

Q: task 8 Analyse dynamic responses of PID controllers in terms of position control of a DC motor,…

A: PID controllers are frequently employed in control systems for DC motor position control. Following…

Q: Calculate the node voltages in the circuit shown below. 4 Α 4 ΖΩ ΑΛΛ 5Ω 2 ΑΜ 6Ω 0 8 Ω ΑΛΛ 3 21,

A:

Q: G₁ = 10 (8 + 2)(8 + 5) Yukarıda verilen transfer fonksiyonuna ait Nyquist diyagramının nasıl…

A:

Q: Determine the capacitor voltage v(t) for t > 0 t = 0 6Ω 12V Μ 200 mF Η + v(t) – 3 Ω 2Ω

A:

Q: D1 10 k -20 V -10 V D2 10 k -10 V D3 KH t1₁.

A: We need to find diode currents ( si diode forward voltage is 0.7V )Circuit:-

Q: 7. For the circuit shown in Fig. 2.135 (a), calculate the current in the 10 ohm resistance. Use…

A: It is given that:

Q: For the system of Figure 1, T = 2 s and G(z) = K(Z+0.8) (z - 1)(z-0.6) T G(s) Figure 1. Unity…

A: The unity feedback system is shown below,

Q: Find the initial and final values of f(t)=L-¹[F(s)] if 5s² + 7s +1 s. (s + 1)² F(s)

A:

Q: A permanent-magnet dc motor has RA = 1.0 Ω. With no load, it operates at 1000 rpm and draws 1.0 A…

A: Losses in PMDC Motor Armature cu lossField cu lossRotational power lossStray load loss

Q: Example: Find the current through a 200 resistance, and current through a 400 resistance 12V 2002 w…

A: Given network is current through 20 and 40 is i1,i2=?

Q: G(z) = K(z + 0.8) (z − 1)(z- 0.6) T G(s)

A: Given dataTo find outWe have to determine the stability using the Jury test.

Q: 3-Phase, 60Hz, transposed transmission line has configuration and spacing as shown in the figure…

A:

Q: In the circuit of Fig. 7_1, what is Leq? 2H O Leq-7H O Leg - 17 H O Leq=5 H Leg-15 H O Leg-20 H O…

A: The circuit diagram,

Electric field

A physical field present around an electrically charged particle that exerts a force on all other charged particles is called an electric field. The charged particles present in the field either repel or attract. From electric charges or time-varying magnetic fields, the electric field originates. One of the manifestations of electromagnetic force which is one of the four fundamental forces present in nature are the electric fields and magnetic fields.