Question 2: An end system sends 50 packets per second using the User Datagram Protocol (UDP) over a full duplex 100 Mbps Ethernet LAN connection. Each packet consists 1500B of Ethernet frame payload data. What is the throughput, when measured at the UDP layer?

Question 2: An end system sends 50 packets per second using the User Datagram Protocol (UDP) over a full duplex 100 Mbps Ethernet LAN connection. Each packet consists 1500B of Ethernet frame payload data. What is the throughput, when measured at the UDP layer?

Operations Research : Applications and Algorithms

4th Edition

ISBN:9780534380588

Author:Wayne L. Winston

Publisher:Wayne L. Winston

Chapter20: Queuing Theory

Section20.10: Exponential Queues In Series And Open Queuing Networks

Problem 8P

See similar textbooks

Related questions

Q: What is a router's role in the Internet protocol stack? What are the layers that are affected by a…

A: The protocol stack : The protocol stack, often known as the network stack, is a computer networking…

Q: In the router layer 2 protocol, what flaws have been found? Even after switching the router serial…

A: Introduction: Problems with the layer 2 ProtocolThe OBI Data Link Layer is the second layer. The…

Q: In the figure, the communication link capacity between Router 1 and Router 2 is 3 Mbps. If a 2 Mbps…

A: Objective: Two routers are obtaining data traffic through a common channel. The channel capacity is…

Q: Give an explanation or draw a diagram illustrating what packets (IP datagrams, Ethernet frames, TCP…

A: Protocol for Internet communication: IP packets are composed of two components: a header and a…

Q: Consider a two-link network in which Host A has a 1 Mbps connection with a 10 ms propagation delay…

A: Intro The question is about to Consider a two-link network in which Host A has a 1 Mbps connection…

Q: Two transport-layer protocols may be used by certain application applications (UDP or TCP). Thus,…

A: The question is "Two transport-layer protocols may be used by certain application applications (UDP…

Q: What weaknesses in the router layer 2 protocol have been found? Why does the ICMP request still…

A: ICMP Request : In a PPP, the ICMP request image result still works. When network issues prohibit the…

Q: Question 1: True or False: 1-[ ] Telephone network is an example of Packet Switching network. 2- [ ]…

A: Note- Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for…

Q: (i) Explain with neat diagram, the three phases of connection establishment in connection- oriented…

A: The Answer is

Q: Compare the operation of the layer 3 entities in the end systems and in the routers inside the…

A: All layer 3 (network layer) entities both in the end systems and inside the network perform packet…

Q: B. Let us assume that Node A transfers data to Node D through local area notwork LAN1, R1 router,…

A: I have answered this question in step 2.

Q: The services of two transport-layer protocols can be used by some application applications (UDP or…

A: IF the devices are directly connected the TCP is involved in the communication. If the data is…

Q: Given a TCP host whose MSS and CW values are both set to 1,460 bytes, what will the value of CW be…

Q: Thus, how can a computer determine which transport layer is responsible for delivering a packet?

A: A networking protocol called User Datagram Protocol (UDP) is largely used to provide low-latency,…

Q: After the fifteenth collision, what is the maximum and minimum waiting time for a node on a 10 Mbps…

A: Introduction: Ethernet: Ethernet is a commonly used software and hardware networking protocol. The…

Q: What flaws have been found in the layer 2 protocol used by routers? Why does the serial interface…

A: Layer 2 Protocol problems Data Link Layer, the second layer in the OSI architecture, builds frames…

Q: What weaknesses in the router layer 2 protocol have been discovered? Why does the ICMP request…

A: Introduction: If you're responsible for securing a corporate or private network, you need to be…

Q: Assume that the link has an MSS of 100 bytes and that we are using a stop and wait protocol. If we…

A: Most extreme Segment Size = 100 bytes RTT = 100ms We know, RTT = 2 * Tp Henceforth, Propagation…

Q: Consider a packet sent on a bridged LAN to a nonexistent address. Across how many segments will…

A: A network in which computers are connected in a single room.

Q: What problems have been detected in the router's layer 2 protocol? What are the ramifications of…

A: Introduction: Layer 2 Protocol IssuesThe Data Link layer is the second layer in the OSI…

Q: True or False: As a packet being processed on a single machine is passed down the layers of the…

A: In a computer network, there is a requirement for communication which is fulfilled by an addressing…

Q: Consider a two-link network where Host A is connected to the router by a 1 Mbps link with 10 ms…

A: The answer is..

Q: (1) Explain with neat diagram, the three phases of connection establishment in connection- oriented…

Q: A host is receiving data from a remote peer by means of TCP segments with a payload of 1460 bytes.…

A: Size of each segment in this scenario is 1460 bytes. The maximum size of a TCP header can be 60…

Q: The router layer 2 protocol has been shown to include weaknesses. Which ones have been discovered?…

A: Introduction: ICMP is a network level protocol. ICMP messages communicate information about network…

Q: Consider an IP packet with datagram of size 850 bytes. This packet will be forwarded on the link…

A: According to the given question, it is required to determine the number of fragments. The detailed…

Q: IP hosts that are not designated routers are required to drop packets misaddressed to them, even if…

A: A would be inudated with the multiple copies the packets if the same host address is arrived at a…

Q: What are issues found in router layer 2 protocol? Why even after changing the router serial…

A: In OSI model Data LInk layer is the second layer that creates frames from data bits and provides…

Q: What problems have been detected in the router's layer 2 protocol? What ramifications does this find…

A: Launch: Protocol Issues at the Layer. The OSI Data Link layer generates frames from data bits while…

Q: The TCP/IP application layer is equivalent to the combined session, presentation, and application…

A: Given: The TCP/IP application layer is equivalent to the combined session, presentation, and…

Q: Describe how the ARP protocol works to assist a host A in successfully sending a datagram to its…

A: NOTE :- Below i explain the answer in my own words by which you understand it well. A large…

Q: What flaws in the layer 2 router protocol have been found? Why does the ICMP request still function…

A: Layer 2 Protocol problems Data Link Layer, the second layer in the OSI architecture, builds frames…

Q: 4) One of the main functions of the. .. layer is to provide a routing mechanism. 5) .. is the length…

A: answer is

Q: Consider a packet switched network, where two packets with size of each packet equals to 1000 bits…

A: Formulas used- R is in kbps so convert to bps by multiplying 10^3. Bandwidth=R bps = 2 x 1000 bps…

Q: router interconnects a subnet

A: Solution is given below:

Q: In terms of delivering services, TCP is a stable and full duplex transport layer protocol…

A: Let's see the meaning of the terms full-duplex, connection-oriented, and dependable delivery in…

Q: Computer science What problems can be found in the protocol for router layer 2? Why do the ICMP…

A: Introduction: What issues may be identified in the router layer 2 protocol?Why does an ICMP request…

Q: QUESTION 3 In an SDN-controlled network, the routing function is? Centralized within the SDN…

A: SDN stands for Software Defined Networking. It is a network architecture which virtualizes the…

Q: Consider a link of length 1000 km with 10° bps rate connecting a sender and receiver. Assume a fixed…

A: Sliding window Protocol: In this protocol, the size of the sender window is always equal to the size…

Q: Consider this scenario. A network link has an MTU (Maximum Transmission Unit) limit of 1500 bytes.…

A: Given: The given data is 3300 Bytes. Given a network link has an MTU (Maximum Transmission Unit)…

Q: Is it true that weaknesses in the router layer 2 protocol have been discovered? Why does the ICMP…

A: Layer 2 Protocol Issues In the OSI architecture, the Data Link layer is the second layer. It is…

Q: a) For the given network diagram, suppose an application running on Host 1 transmits a packet…

A: a) Process of packet encapsulation and de-capsulation along the path from Host 1 to Host 2. host 1…

Q: Question 1: True or False: [ ] Telephone network is an example of Packet Switching network. […

A: Note: - As per the guidelines we can only answer a maximum of three subparts. Please resubmit the…

Q: In step 4 of the CSMA/CA protocol, a station that successfully transmits a frame begins the CSMA/CA…

Q: 2-A bus LAN has stations with packet arrival intensity 2=1.5 packets/sec per station. Packets are…

Q: 2. Now suppose there are two links between source and destination, with one router connecting the…

A: Given that, Packet size= 30 Mb Band width or transmission rate= 10 Mbps Propagation speed= 2*108…

Q: An IP packet to be transmitted by Ethernet is 60 bytes long, including all its headers. If LLC is…

A: Actually, IP stands for Internet Protocol.

Concept explainers

Network transmission cabling

A network is a collection of devices connected by communication links. A device can be a computer or any instrument capable of sending and receiving data or information formed by other nodes toward the network. A channel that connects people or things is known as a network. It sends the data from one place to another. It is the basic concept of a computer, network, and data communications.

Question

Solve it , only if you are good in computer networking. Otherwise i will downvote.

Computer science

Question 2: An end system sends 50 packets per second using the User Datagram
Protocol (UDP) over a full duplex 100 Mbps Ethernet LAN connection. Each packet
consists 150OB of Ethernet frame payload data. What is the throughput, when
measured at the UDP layer?

System that digitally connects two or more computers for the purposes of communication and/or sharing resources. These networks may be composed of general or specialized hosts, PCs, servers, or networking hardware.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Given question is:

VIEW

Explanation:

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

TCP session sends 50 packets per second over an Ethernet Local Area Network (LAN). Each packet consists 2280B (excluding the preamble and cyclic redundancy check (CRC)). Calculate the size of the headers, and hence the TCP payload data. What therefore is the TCP throughput of the session?
problems with routers' layer 2 protocols? How come ICMP packets are unaffected when the subnet of a PPP-encapsulated router's serial interface is changed?
In the figure below a router is transferring packets, each of length L= 5 000 bits over a link with a transmission Rate R= 1 Mbps to another router at the other end of the link. The speed prorogation of the light signal on the link is 3x108 m/s. The length of the link is 1 Km. L: packet length (in bits) R: link transmission rates (Mbps) Queue of packets waiting for output link 1-Calculate the total transmission delay. 2- How many packets can be transmitted in one second.
A 3200 bit long TCP message is transmitted to the IP layer and becomes a datagram after adding a 160 bit header. The following Internet is connected by two LANs through routers. But the data part of the longest data frame that the second LAN can transmit is only 1200 bits. Therefore, datagrams must be segmented in the router. How many bits of data does the second LAN transmit to its upper layer?
What problems have been detected in the router's layer 2 protocol? What ramifications does this find have? Why does the ICMP request continue to work in a PPP encapsulated router even when the serial interface subnet is changed?
The path of a packet is defined by source and destination addresses in a connectionless system like Ethernet.A connection-oriented protocol, such as ATM, however, uses virtual connection identifiers to specify a cell's route (VPIs and VCIs). Could you please elaborate on this statement?
What problems have been detected in the router's layer 2 protocol? What are the ramifications of this finding? Why does the ICMP request continue to work in a PPP encapsulated router even when the serial interface subnet of the router is changed?
A packet switch receives a packet and determines the outbound link to which the packet should be forwarded. When the packet arrives, one other packet is halfway done being transmitted on this outbound link and four other packets are waiting to be transmitted. Packets are transmitted in order of arrival. Suppose all packets are 1,500 bytes and the link rate is 2 Mbps. What is the queuing delay for the packet? More generally, what is the queuing delay when all packets have length L, the transmission rate is R, x bits of the currently-being-transmitted packet have been transmitted, and n packets are already in the queue?
What issues have been found in the layer 2 protocol of the router? What does this discovery mean, if anything? Why does an ICMP request sent by a PPP-encapsulated router continue to function after the subnet of the serial interface has been changed?