QUESTION 3 Using the information provided in the figure below, find the branch resistors R1 and R3, the total resistance RT, and the voltage source E R1 = R3= RT= E= +₁₁ 9 mA RT R₁ www 5 mA R₂ 2 mA 4 kn R units units units units www

Q: i see thes answer, also graph for phase i think wrong, please can you check

A: Given:

Q: 2. What is meant by energy efficiency of a transformer? A 20-KVA transformer has a maximum…

A:

Q: A -To To 2 O 2 give the signal below as: To ➜t Determine the fourier series coffiicials of the above…

A: The given signal is shown below. It is asked to determine the Fourier series coefficients of the…

Q: D(1) v(1) 10 V -10 V Figure P7.85 LH N (b) 4₂(1) SRΩ r(s) Notes on entering solution: Enter your…

A:

Q: The input to the series RLC bandpass filter designed in Problem 14.21 is 20 cos wt V. Find the…

A: Given,For a series RLC bandpass filter,Input voltage = 20cosωt V.C = 5 nF, L = 79.16 mH, R = 1.99…

Q: In the circuit Vbe(on) = 0.7 V, Vce(sat) = 0.2 V and Beta-=200 Vcc = 9V Rc =1k and Rb = 10K a.)…

A: In this question We need to determine the all unknown parameters.  We know If collector current is…

Q: Problem 5. Calculate the cross-sectional area, in mm², of a piece of copper wire, 40 m in length and…

A:

Q: 2. Consider a causal continuous-time LTI system whose input signal (1) and output signal y(t) are…

A:

Q: Using the circuit: a.) Find the impedance of the Resistor at 1 MegaHertz? b.) Find the impedance…

A:

Q: What is the advantage of PWM?   Explain with the help of a diagram how we can control the voltage…

A: PWM or Pulse width modulation technique is an technique used to generate gate pulses for the…

Q: -m ww = 1K 1K

A: Given Circuit: To derive Truth table for A=1,B=1 and A=1, B=0 Schematic Diagram Logic function…

Q: Get the value and show the direction of the current using conventional flow.

A: The current will flow from higher potential to lower potential and based on that the direction of…

Q: The current through a 10-mH inductor is 10e-12 A. Find the voltage and the power at t = 2 s. The…

A:

Q: Using Thevenin’s theorem reduce the circuit in the drawing to an equivalent circuit and calculate…

A: Given: A network, With values of elements as,  R1=8Ω, R2=7Ω, R3=4Ω, RL=14Ω, V1=10 V. To find:…

Q: 9. Calculate the GMR, GMD and inductance per phase per kilometer of the line with a radius of 0.250…

A: Given the arrangement of conductors   To determine: GMD GMR Inductance per phase

Q: X e Z₁ b {5»Q[®[v D Z₂ + C

A:

Q: 4. Solve for vo(t) in the circuit using the superposition principle for the circuit shown in Figure…

A:

Q: Rs 50 Ω Vs =500 m Vp- f=1 kHz Signal Generator R₁ 1.0 ΚΩ R, =10 ΚΩ k (Sai) +15 VA 2 3 KA741 -15 V 6…

A: For this circuit we need to find out,  output voltage of the inverting amplifier . Circuit :

Q: Please select all true statements about the signals at Points A and B in the partial superhet block…

A: Given: A part of block diagram of super-hetrodyne receiver,  To do: We have to select correct…

Q: (1) Find the Laplace transform of the following 2π-periodic functions: (i) f1(t) = t if 0 < t < 2π…

A: To find the Laplace transform of the following 2π-periodic functions: (i) f1(t) = t if 0 &lt; t &lt;…

Q: Figure i v,3100 Ω 2502 50 6.25 is 1 of 1 Part A Use the node-voltage method to find in the circuit…

A:

Q: The closed loop gain of the system shown in the given figure is : 0.5

A: Given data, Open loop gain G = -3. Feedback factor H = 0.5. Block diagram is given as,

Q: Sketch the energy band diagram for an ideal p+-n step junction diode showing the carrier activity in…

A:

Q: An iron ring has its mean length of flux path as 60 cm and its cross sectional area as 15 cm^2. Its…

A: We need to find out current for given magnetic field .

Q: 9.6.4 Use Kirchhoff's laws to compute the source voltage of the net- work shown in Fig. P9.6.4. Vs…

A:

Q: 2- Write the truth table and logical expression for the following logical circuit: a. b. 48 B UD P -…

A: In these questions We need to determine the logical expression of the given circuit and need to…

Q: Show in detail how you would connect 60V, 2A PV panels to satisfy a demand of 180V and 500W during…

A: Given data Rating of each PV panel; 60 V, 2 A Demand value 180 V, 500 W To find out We have to find…

Q: When a Bipolar Junction Transistor, in common emmiter configuration, is in the active mode, it can…

A:

Q: 3. Determine i.(t) in the op amp circuit given below if vs = 4 cos(104t) V and where R = 97 KQ.

A: The value of output current can be calculated by using the ideal operational amplifier…

Q: A. Find to 5 V B. Find Vo 36 ΚΩ 10 V 2 mA 4 ΚΩ Μ 6 ΚΩ 50 Ω m 10 V που του -10 V 4 ΚΩ . 20 Ω σν −3V…

A: We need to find out current and voltage for given comparators .

Q: An iron ring has its mean length of flux path as 60 cm and its cross sectional area as 15 cm^2. Its…

A:

Q: 1- By using Thevenin's Theorem, solve the circuit in Fig (1) and calculate the value of current and…

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Q: The responsivity unit is V/W True False Receivers are used to recover the signal as an electrical…

A:

Q: 3. Prove (justify) whether or not the following impulse responses of LTI systems are causa and/or…

A:

Q: The following data were obtained when a short circuit test was performed upon a 100 kVA, 2400/240…

A:

Q: 2- In the circuit shown in fig (3), calculate the current through the resistor R when its resistor…

A:

Q: (a) Write, as a series, the z-transform of the number sequence generated by sampling the time…

A:

Q: Suppose r0=0x300010A0, r2 = 0x00000011, and the memory layout is as follows. Address Data 0x300010A7…

A:

Q: QUESTION 1 Find all unknown currents and their directions in the circuit below 11 = 12 = 20 A 11…

A:

Q: Question-2 Consider the following circuit, and given: lin(s) Iin (s) = 1) 2s - 1 (s + 1)(s² +25) m…

A: We need to find out the current for given circuit.

Q: For a particular BJT, Is = 5×10–15 A and I's = 10-13 A, calculate the collector current knowing that…

A: It is given that: Is=5x10-15 A,Is'=10-13 A,VBE=0.7 V,VCE=0.15 VVT=25.9 mV

Q: 5 The phase voltages for unbalanced System are : Vb = 100 (1500 V. Vc = 80 (-100 ✓ (150⁰ Va= 100…

A: Given data:- Phase voltages:- Va=100∠30°Vb=100∠150°Vc=80∠-100°

Q: 5ΚΩ 2.5ΚΩ Μ 2mA 1+ 2.5ΚΩ www 25ΚΩ 15ΚΩ 12V a 9 b 24ΚΩ ( Τ 6mA

A: We need to find out the equivalent resistance for given circuit.

Q: i) Draw a counter set-up that follows the output sequence - 1, 2, 4, 8, 16, 32, 1, 2, 4, 8, 16, 32,…

A: i) The counter sequence is 1,2,4,8,16,32. The excitation table will be based on the counter…

Q: QF Consider a solar cell with a photocurrent of 25mA and a reverse saturation current of 3.66x10-11…

A: Given: I=3.66×10-11 AT=300 K

Q: Calculate the pulse width T of the circuit. Plot Vo

A:

Q: Consider the following circuit, and given: M lin(s) Iin (s) = = 2) 1) 2s 1 (s+ 1)(s² +25) 400 Ω 400…

A:

Q: (5) Over what band of frequencies will a 100 MHz carrier modulated at 5 kHz extend?

A: Given- Frequency of carrier wave = 100 MHz The modulation frequency of carrier wave = 5 kHz.   To…

Q: Determine vo in the circuit if R=2kQ. 3 mA O 2kQ ww The voltage Vols 4kQ ww V R Vo

A: We need to find out Vo for the given circuit.

Q: A 308-V, 30-hp, 8-pole, 50 Hz, A-connected induction motor has full-load slip of 2 %. What is the…

A: Given data, Output power PO=30 hp. Supply voltage V = 308 V. Number of poles P = 8. Frequency f = 50…

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.