Read and analyze the word problem. Solve the problem by identifying the given and formula needed. Write all the necessary given, substitution, conversion if there’s any, formula used and computations. Highlight the final answer. 1. In 1 minute, a 4.0 A current flows in a simple circuit. a. How much charge passes through the circuit during 1 minute? b. How many electrons would this represent?

Read and analyze the word problem. Solve the problem by identifying the given and formula needed. Write all the necessary given, substitution, conversion if there’s any, formula used and computations. Highlight the final answer. 1. In 1 minute, a 4.0 A current flows in a simple circuit. a. How much charge passes through the circuit during 1 minute? b. How many electrons would this represent?

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter1: Units And Measurement

Section: Chapter Questions

Problem 15P: Use the orders of magnitude you found in the previous problem to answer the following questions to...

See similar textbooks

Similar questions

Directions: Solve the given problems. Show your complete solutions.Round off your answers into the proper number of significant figures.1. A silver wire 2.5 mm in diameter transfers a charge of 370 C in 70 minutes.Silver is made up of 5.8 x 1028 free electrons per cubic meter.a. Find the current in the wire.b. What is the magnitude of the drift velocity of the electrons in the wire?
Check your understanding A. Solve the problems below. You are required to show the proper solution with the final answer written inside a box. Make sure to put the final unit of measurement. 1. If in the process of rubbing the lenses of the eyeglasses, 6.28 x 10 10 electrons were transferred, a. what is the charge of the lenses and the nylon cloth? b. what is the change in their masses? CS Scanned with CamScanner
Solve for the given problems. Show your complete solutions. Round off your answers into 3 significant figures Refer to figure 7. a. Find the current in the circuit. b. Find the terminal voltage Vab of the 16.0-V battery. c. Compute for the potential difference Vac.
. Solve the problems below. Make sure to show proper solution. All finalanswers should be written inside a box. 2. An electrician experienced a mild shock when he accidentally touched a wirecarrying 5.0 A for 1.5 s. a. How many coulombs of charge flow through the electrician? b. How many electrons constitute the given current?
Consider the graph shown below. a. Identify what the graph shows b. Briefly explain what kind of information you can determine from the graph and how that information could be useful in its application related to the field of health sciences. In your answer: a. Make specific reference to any values you can read from the graph. b. Include any appropriate equations for the graph and explain how they could be used. 100% 90% 80% 70% 60% 50.00% 50% 40% 30% 25.00% 20% 12.50% 10% 6.25% 3.13% 1.55% 0.78% 0.39% 0% 16 24 32 40 48 56 64 Elapsed time (in days) parent isotope (%)
Reclung.c A on ri gle Figure 1 2. The circuit shown above is constructed with two 6.0 V batteries and three resistors with the values shown. The currents 1₁, 12, and 13 in each branch of the circuit are indicated. 2 GEOMETRY AND TRIGONOMETRY Circle A = ²² C = 2πr Cy.inder bh - re Rectangular Solid Vlh Sphere 1. Using Kirchhoff's rules, write, but DO NOT SOLVE, equations that can be used to solve for the current in each resistor. ii. Calculate the current in the 200 9 resistor. iii. Calculate the power dissipated by the 200 2 resistor. V = ar²l S.. Figure 2 The two 6.0 V batteries are replaced with a battery with voltage & and a resistor of resistance 50 2, as shown above. The voltmeter V shows that the voltage across the 200 £2 resistor is 4.4 V. (b) Calculate the current through the 50 2 resistor. (c) Calculate the voltage & of the battery. V=² S = 4; 7² Rig Triangle 2 +6² = c² sin = COS== tan 8 = OJA b C 2m. a b 6.0 V 7,4 & A - area C=circumference h-hei £= le L W = IUL r=fuu.0…
The output power of a solar PV module is 120 Watts. The number of cells in the moduleis 39. Estimate the following: (Assume any other necessary data)i. Output voltage of the PV moduleii. Output current of the PV moduleiii. Total area of PV moduleiv. Area of one PV cellv. Power output of one PV cell
5. A 250-volt electrical heater is used to warm 3Li/hr of water from 19°C to 98°C. Assume heat conversion loss of 25% of the total heat supplied, how much current in amperes must be supplied to this heater. Derive with the formula below, show the cancellation, explain the step by step and DRAW a free body diagram/figure. refer with this: PE1 + KE1 + U1 + WF1 + Q1 + W1 = PE2 + KE2 + U2 + WF2 + Q2 + W2 + E losses.
Analyze and solve the following problems carefully. Show complete solutions and box the final answer. 1. Give the resistance of a 1-mile length of 12-gauge copper wire, assuming 1 mile = 1609 meters and the diameter is 0.2117cm.
Capacitance, Charge and Voltage: Q = CV 1. Click the Reset Button on the bottom right of the PHET simulation. 2. CHECK Plate Charges and Bar Graphs boxes in the upper right so your display resembles the graph below. 3. SET the Plate Area to 200 mm² and the Separation to 4.0 mm. Capactance Tup Pate Charge oc Sured Energy Pu Charges r Graphs O e Fd Cument Direction 1500 V 4. Connect the voltmeter across the capacitor by placing the red on the top plate and black on bottom. If the voltmeter reads a negative, switch the red and black. 5. Set the battery Voltage to 0.25 V. Record the measured plate charge, Q. 6. Repeat Step 5 for each Voltage in Table 3. Table 3: Charge and Voltage Voltage |(V) Plate Charge |(pC) 0.25 V 0.50 V 0.75 V 1.00 V 1.25 V 1.50 V
Solve the following problems. identify the given, the unknown, give the formula to be used, show the solution, and express the final answer into 2 decimal places. You can use a separate sheet of paper in solving the problem. 1. Find the current along a circuit if the voltage is 110 V with a resistance of 22 Ohms. and Given. Unknown: and Unknown: 3. Calculate for the voltage supplied to a load if the current is 2.5 A and the resistance is 10.80 Ohms. and Given: Unknown: Solution: Performance Task Formula: Solution: Final Answer: 2. What is the resistance of a bulb with a current of 0.72 A that is connected to a 110 V supply. Given: Formula: Solution: Final Answer: Formula: Final Answer:
Directions: Solve for the given problems. Show your complete solutions.Round off your answers into the proper number of significant figures.1. Copper has 8.5 x 1028 free electrons per cubic meter. A 75.0-cm length ofcopper wire with a diameter of 2.05 mm, carries 4.97 A of current.a. How much time does it take for an electron to travel the length of thewire?b. Repeat (a) for a wire with a diameter of 4.12 mm of the same length thatcarries the same current.c. How does changing the diameter of the wire affect the drift velocity ofthe electrons in the wire?