Resse Q3) The response of a system is c(t)=1+0.2-1.2e Find the expression for the closed loop transfer function if the system is subjected to a unit step. Also, determine the error constants for the unity step, unit ramp and unit acceleration -601 -10

Resse Q3) The response of a system is c(t)=1+0.2-1.2e Find the expression for the closed loop transfer function if the system is subjected to a unit step. Also, determine the error constants for the unity step, unit ramp and unit acceleration -601 -10

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter11: Transient Stability

Section: Chapter Questions

Problem 11.18P

See similar textbooks

Related questions

Q: ● . Part a: Solve using a test voltage source of 1V. Part b: Solve using a test current source of…

Q: Q17) The figure shows Wheatstone bridge at equilibrium given that E=7V, R,= 150, L₁= 20cm and R2=20…

A: As per guidelines given to us, we can only provide the solution to one question in multiple types of…

Q: In an experiment to determine the direction of the magnetic flux: Q/ What happens to the piece of…

A: Types of magnetic material Diamagnetic material Ferromagnetic materials Paramagnetic material…

Q: The generating unit in Problem 11.1 is initially operating at Pmp.u. = Pep.u. Pep.u. = 0.7 per unit,…

A: Perunit swing equations- 2Hωpu(t)ωsynd2δ(t)dt2=Pmpu(t)−Pepu(t)=Papu(t) Assuming that…

Q: Q 3 please

A: Given: A series RC circuit in figure, To find: The system function H(s).

Q: A 450 V, four poles, 80 hp, 50 Hz, A connected three phase induction motor develops its full load…

A: It is given that: V=450Vp=4P=80 hpf=50 Hzs=0.0333R1=0.32 ΩX1=0.44 ΩX2=0.38 ΩXM=32 Ω

Q: Subsystems and elements of the EPS. Description of their functions

A: We need to tell about the EPS and it's subsystem .

Q: Estimate the total length of dipole FM antenna (L) and the length of each dipole (E) in meter if the…

A: We need to find out the length of antenna and length of dipole .

Q: Given that V₁ = -15V and V₂ = 26V, what is V3? V3 + V₁ +1 V₂

A: Given data, V1=-15 V, V2=26 V. Circuit diagram is given as,

Q: c) Find and plot the spectrum of the following periodic signal for 3 samples only (k = 0, 1 and 2).…

Q: 2.50. Find Io in the network in Figure P2.50. To V 2 mA 1ΚΩ 1ΚΩ Μ 1 ΚΩ ΣΙΚΩ 12V

Q: d²y equation di +Ady dt +ky(t) = kx(t) where y and x are represented output and input of the system.…

Q: Q2) Find k and for the system shown in Figure 2 by using = 0.5 and steady-state error (ess) = 0.3…

A: We need to find out the unknown for given system .

Q: Calculate the percentage saving in power if only one sideband transmission is used over DSBFC system…

A: We need to find out the percentage power saving.

Q: Give 5 examples of displacement transducers with desc

A: We need to tell about the displacement transducers .

Q: Q-2 A unity feedback System has a forward Transfer Function G(s)=100(s+1)/(s^2+7s+10)] a) Draw the…

Q: From Figure A1.3 below, compute current is when resistances R₁ and R2 are both 10 ohmand voltage…

A: Calculation of currents when voltage across resistances, V=10V R1=R2=10Ω As we know voltage in…

Q: Explain brifly blance modulator.

A: To explain: Balanced modulator. Note: Amplitude modulated signal consists of carrier signal and…

Q: can you write it for me. i need handwritten answer

A: Given: The solution of a Zener diode problem. To do: To write the given solution by hand on paper.

Q: 7. Consider the PMOS shown in Fig. 7, which has Vth = -1V. The gate voltage VG is swept from 2.5V to…

Q: What is the even component of the sequence x (n) = [0, 0, 0, 7, 6, 4, 2] with n = [-3, -2, -1, 0, 1,…

Q: 6. In the circuit shown in Figure determine the terminal voltage of the source VS, the power PL…

A: The given circuit is shown below. The given values of circuit parameters are written below. Source…

Q: and b) are separated by material potential difference of Vis Two long cylinders (radii a with…

A: Given data, The length of the cylinder is L. The radius of the smaller cylinder is a. Assuming that…

Q: The fuel-cost curves for a two generators power system are given as follows: C1 (P1)= 700 +20 P1+…

A: Introduction The fuel costs curves for two generators power system are given in the question as it…

Q: QUESTION 4 a) Determine the voltage vx(t) and current iy(t) shown in Figure Q4a. 292 b) vs(t)=100…

A: Note: Only active power will be available in purely R Load Only Reactive power will be available in…

Q: If the transfer function V2(s) / V1(s) = s / s^2+5s+4, then find the Z. (It may contain R,L,C…

Q: 1) H(s) = -10s² (1+₁3)(S+100) ² (1+106)

A: Since you have posted multiple questions, we will provide the solution only to the first question as…

Q: QUESTION 1 For a unipolar lead, the anode is at the distal tip of the lead, and the IPG serves as…

A: Disclaimer Since you have asked multiple questions, we will solve the first question (i.e., Question…

Q: b) Using the Superposition Theorem, show that the voltage Vo = -20 V in the circuit of Figure Q3b.…

A: Note: When more than one source is present in the electrical network, the Superposition theorem is…

Q: An EHV line is approximated by losses line. The propagation constant (B) of lossless line is 0.00112…

A: Given- An EHV line, Propagation constant- β=0.00112 rad/km, Line length = 400 km, To Find- The value…

Q: 45) A 40hp, 440V, four pole dc motor has an armature wave-wound with 846 conductors and the…

A: The armature response is brought about by a magnetic flux that rotates at synchronous speed and has…

Q: 1. Consider the system v.(t) C HH + vc(t)- ic(t) R₁ ww S ww R₂ a) Using u(t) = V(t) as an input and…

Q: The fuel-cost functions in S/h for two 800 MW thermal plants are given by C1-400-6P1-0.004(P1 P11,…

A: The incremental cost of power is defined as the rate of change of cost per unit of power. d Cd P=λ

Q: Problem 3. If R= 2002, L = 0.6H, what value of C will make an RLC series circuit: (a) overdamped,…

A: Introduction RLC circuit: A series or parallel connection between a resistor (R), an inductor (L),…

Q: 2.50. Find I in the network in Figure P2.50. To V2 2 mA 1 ΚΩ 1ΚΩ 1 ΚΩ 1 ΚΩ FIGURE P2.50 |12V

A: We have to find I0 in the given network

Q: 5. Regenerative braking of a DC motor can not be performed by: a) first quadrant chopper drive b)…

A: it is asked in which drive the regenerative braking of DC motor can not be performed

Q: 1- Find (and sketch) the PSD and the autocorrelation function of a white Gaussian noise at the…

A: Introduction White Gaussian Noise: The essential property of Gaussian white noise (GWN), a…

Q: A shunt generator gave the following results in the O.C.C. test at a speed of r.p.m. Field current…

Q: Calculate the Antenna Gain (dBi) if the operating frequency is 1080 MHz and the Antenna Factor 11.82…

A: The antenna factor is 11.82 db/m and operating frequency is 1080 MHz.

Q: Problem 1: A baseband signal x(t) = 4cos (8nt) is amplified using an amplifier to produce the output…

A: We need to find out output for given system and given input .

Q: B6. The circuit at right represents: a) induction motor with three-phase voltage-source inverter b)…

A: Induction motor working Principle When an ac supply is connected to a stator it creates a rotating…

Q: GND GND Figure 2: Complete circuit, including internal resistance.

A: The given circuit can be solved by using the resistance reduction techniques. The parallel…

Q: Consider three currents, Ia, Ib & Ie which combine to form Iout as in the diagram belo Ic 2 Where Ia…

A: In this question We need to determine the value of current IC. We are solving this problem using the…

Q: Please solve Last time Rejected i give upvote. Two single phase scott-connected transformers…

Q: 19. Look at the drawing shown in the figure above. When you see this drawing in a schematic diagram,…

A: We need to tell about the given circuit .

Q: a) Name the types of Operational amplifiers (OPAMPS) in below circuit diagrams of Figures A4.1 and…

A: For the given two op-amplifier circuit discuss about types of op-amp and calculation of gain and…

Q: Calculate the percentage saving in power if only one sideband transmission is used over DSBFC system…

A: We have to calculate the percentage saving in power if only one sideband transmission is used over…

Q: Consider two meters A and B. Meter A has a range of (0 - 150) V and multiplier resistance of 50 kQ.…

Q: Hello, I want clarification with a solution to this question

A: Given: A clamper circuit, with input, and output, To explain: The operation of above mentioned…

Q: MVA · KV .9. D. MVA). @ T₁ 110 MVA 15/132 kv jo. p.u TL1:24+70) TL2(4+370) Load S=(20+315) MUA 0…

Question

Resse
Find the expression for the closed loop
Q3) The response of a system is c(t)=1+0.2-1.2e
transfer function if the system is subjected to a unit step. Also, determine the error constants for the
unity step, unit ramp and unit acceleration.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2: Solution

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What are static error coefficients? how will you calculate the steady state error using static error coefficients? (Write equations also, about kp, Kv, Ka) subject: control system
The derivative mode is combined with the proportional and integral modes to reduce ....... settling time steady state error rising time overshoot
Generate differential equations,of the electrical circuit by hand using Newton’slaw and the basic principle of Kirchoff's law.
Can you classify this differential equation, as well?
Discussion of system damping and steady-state mistakes as a result of integral and derivative control.
Find the steady-state error for unit step, unit ramp, and unit acceleration inputs for the following.
3 - Which of the following is true about the LEAD compensator?A) It decreases the rise time.B) It decreases the number of branches of the root-locus curve.C) NoneD) Increases the number of branches of the root-locus curve.E) It reduces the steady state error and increases the stability.
What are static error coefficients? how will you calculate the steady state error using static error coefficients? (Write equations also, about kp, Kv, Ka)
Explain and give an example of linear time-invariant system.
True Fuels If the dumping ratio is between 0 and 1, the system poles are complex conjugates. The To Workspace Sink Block like the To File Sink Block, the time is not saved in the variable, and must be stored separately IT the damping factor/is zero, the unit-step response is a Pufely sinusoidal.
2. (a) Define Biot-Savart’s law with the equation. (b) Define Lenz’s Law.
Derivative controller is acting on a. Depending on the system itself b. Both of Transient and steady state c. Transient d. Steady state