revolve the objects:   1) top view 2) right side view 3) front view

Q: The elevations of water surfaces in reservoirs A and B are 300 ft and 250 ft, respectively, and…

A: g =9.81m/s2 = 32.185 ft/s2  Q1 = 50ft3/s

Q: LIGHT COEFFICIENT 1. objective method of artificial illumination 2. method of tentative…

A: Light coefficient- It is a measure of the efficiency of a luminaire. It is expressed as the ratio of…

Q: neter is connected to essure in the pipe if the er reading shown in

A: given:

Q: Bending moment at free end Bending moment at 5 m from free end Bending moment at 6 m from free end…

A: Given: Cantilever beam: Span = 10 m UDL=10 kN/m entire span To find: As asked: e. Bending moment at…

Q: Seepage is occurring through a porous media shown in fig. The hydraulic conductivity values (k1,k2,…

A:

Q: An open channel of most economical section of a trapezoidal cross section is required to pass 36000…

A:

Q: A floor panel 3 4 m wide and 12 m long is intended for a vibratory machine in a factory. The…

A:

Q: SITUATION: A rectangular footing, a = 3.5m, b = 2.5m, has a thickness of 700 mm. The column load is…

A:

Q: 1. The Dam ABC has a width of 30 m into the paper and the dam bottom length is 60m. The dam material…

A: We will calculate each moment and find FOS.

Q: A3 meter high W14 x 43 columns in a 5-Story steel braced frame is pinned at the top and bottom and…

A:

Q: Example 4-6: The water flows through the pipe bend with a discharge of 200LS. The bend is placed…

A: Answer We can determine the the Magnitude and Direction of the resultant force(R) on the  bend by…

Q: A 3-m long steel column of hollow circular cross-section is supported on a steel base plate and a…

A:

Q: A cylindrical tank with 10 inches inside diameter contains oxygen gas at 2500 psi. Calculate the…

A: Answer Inside diameter D = 10 inch Internal pressure due to oxygen gas = 2500 psi limiting stress…

Q: find the slope at point CAD by virtual wors Methocd EI: Cost. 1 mt 13 A 2 m

A: We will apply unit moment at point A to calculate slope.

Q: The length of a pipe is 1000 m and its diameter is 20 cm. If the diameter of an equivalent pipe is…

A:

Q: The bar DA is rigid and is originally held in the horizontal position. The wires are made of 304…

A: Force in rod DE is given by ; FDE = σDE × ADE  Stress in DE ; σDE = E × εDE  E = Youngs modulus = 29…

Q: Two soils, soil A and soil B arranged in the manner shown in figure in tubes. Determine rectangular…

A:

Q: Given is the 200mm X 400 mm rectangular beam below. 9 kN 7.50 kN/m 400 mm 1.50 kNm A 1.50m 7.50m 200…

A: We will use formula for Moment of Inertia.

Q: (a) Total roof area, (b) How many polycarbonate roofing sheets are needed, and (c)How many rivets…

A:

Q: g) At what single point along the beam does this maximum occur? h) What are the values of internal…

A:

Q: A rectangular beam 250 mm wide, 500 mm deep is reinforced at the bottom with 4-20-mm-diameter bars…

A: Solution-The given values are as follows,b=250mh=500mThe bottom with 4-20-mm-diameter bars The top…

Q: Investigate the acceptability of the concrete beam with length (L=5400 mm) and cross-section…

A: Given Data:L=5400mmb=300mmd=500mmfc=24mpafy=400Mpa

Q: A 4.5m square foundation exerts a uniform pressure of 200kPa on a soil. Determine (i) The vertical…

A: Given Data:Size of footinf = 4.5×4.5 Pressure = 200kpa(i) Depth= 10m(ii) Depth = 3m     radius = 4m

Q: Exercise A single span beam is simply supported between two columns and carries a reinforced…

A: simply supported beam : A simply supported beam is one that is supported by only two points and can…

Q: Compute the immediate deflection of the figure for Problem 14.3. The a span of 30 ft must resist…

A:

Q: Compute the strength of figure ABCD for all the routes by which the length CD can be determined from…

A: n = Total number of lines = 6 n' = Total number of lines in both direction = 6 s = no. of station =…

Q: If liquid with viscosity equal 5.16*10" m/sec, flow in 60 m long square duct with side dimension 50…

A: step 1-

Q: The height of the sample sand to be tested = 20 cm and the height of the saturated sand = 16 cm.…

A: Given data- height of sand sample h1=20 cmheight of saturated sand sample h2=16 cmTo Find-The…

Q: Fastly calculate the value of displacement Work done=20 J force%33 N

A:

Q: Two distances 200 m and 298 m are measured from tacheometer instrument and corresponding staff…

A: Given data : The value of distance D1=200 m The value of distance D2=298 m The value of staff…

Q: A umple horizontal (circular) curve has a deflection angle of 45. The curve s highway segment with a…

A: Given data:- ∆ = 45° e = 5% = 0.05 f = 0.12 PI station = 4+600 V = 100 km/hr

Q: Exercise A single span beam is simply supported between two columns and carries a reinforced…

A: simply supported beam : A simply supported beam has no moment resistance, is supported on both ends,…

Q: An old building has a future life of 15 years. The rate of interest on capital is 7%. If the…

A: Given data- future life=15 yearsrate of interest i=7%coefficient of annual sinking fund S=0.43

Q: Q4: Helium gas in an ideal Otto cycle is compressed from 20°C and 2.5 L to 0.25 L, and its…

A:

Q: 7.30 FLUS For this refinery pipe, DA = 20 cm. Dg = 14 cm, and L= 1 m. If crude oil (S = 0.90) is…

A:

Q: 1 During the time interval 0 <t< 1, the velocity of an object as a function of time is v = 5 + 3t^2…

A: The velocity is : v = 5 + 3t2 +  2 t3  As the object follows the rectilinear path the acceleration…

Q: Act as on earth retaining structure for the whole or part of its height on one face. (answer with…

A: The one word for the given description has to be identified.  "Act as on earth retaining structure…

Q: Determine the theoretical steel areas required for tension of a rectangular section with b = 350 mm,…

A:

Q: Whats the final answer

A:

Q: [14] Electrolysis process is based on : thermal effect of current O chemical effect of current…

A: The process of decomposing ionic compounds into their constituent elements by running a direct…

Q: Calculate the number of steel bars #6 in a square footing necessary to resist a factored moment of…

A: The given data is as follows: Imperial bar size=#6Factored moment=50 T-mB=2.6 mFy=4200 kg/cm2f'c=250…

Q: The W21x 201 columns on the ground floor of the 5-story shopping mall project are fabricated by…

A: For A36 steel fy = 250MPa For W21 x 201, (Iy)w = 226.7x106 mm4 ; Aw(area of w-section) = 38230 mm2…

Q: A cantilever beam of span 10 m

A: Given:  A cantilever beam of span  10 m and Uniformly distributed load 10kN/m   To find: Shear…

Q: Calculate the pressure at B.

A:

Q: Given is the 200mm X 400 mm rectangular beam below. 9 kN 7.50 kN/m 400 mm 1.50 kNm 1.50m 7.50m 200…

A:

Q: Read The passage carefully and then answer the items that follow. Nada had a little white lamb and…

A: Q1. Nada kept the lamb tied to a tree. Q2 Hazem had stolen the lamb. Q3. Original colour of the lamb…

Q: Aggregates samples (coarse and fine) were placed in a pan and then weighed. The weight was 1,045.1…

A: To find out the moisture content of the sample in percent.

Q: In a cylinder-piston arrangement shown (D1 = 100 hm), the piston is moving downwards at V, = 0.5 %3D…

A: Given: Diameter of Piston, D1=100 mm Velocity of Piston, Vp=0.5 mm/sec Diameter of orifice , D2=10…

Q: A) Two reservoirs with different liquids A (S-1.5) and B (S-0.8) are connected by a Im quare opening…

A: Appreciate if there is detailed work with explanation and finds you helpful for ease of…

Q: Given is the 200mm X 400 mm rectangular beam below. 9 kN 7.50 kN/m 400 mm 1.50 kNm 1.50m 7.50m 200…

A: Draw the FBD of the segment and using equilibrium derive the equation of shear in the same segment.