Saturated steam at 1 atm condenses on a 3 m high and 5 m wide vertical plate that is maintained at o 90 C by circulating cooling water through the other side. Determine: a) The rate of heat transfer by condensation to the plate, and b) The rate at which the condensate drips off the plate at the bottom.

Q: For inviscid and adiabatic flow, the thermal energy equation can be written as de p- dt -PV · ū.…

A: Given: To prove:

Q: Show that the condensation Reynolds number for laminar condensation on a vertical plate may be…

A: Express Reynolds number for the laminar condensation on a vertical plate as Ref=4m˙μf Here, the…

Q: Saturated steam coming off the turbine of a steam power plant at 40°C condenses on the outside of a…

A: Given: The mass flow rate of the steam is m=70 kg/h The outer diameter of the tube is D=3 cm The…

Q: A rigid tank contains water vapor at 400 C and an unknown pressure. When the tank is cooled to 150…

A: Given data The water vapor temperature is T1=400°C The final water temperature is T2=150°C

Q: Steam at 40°C condenses on the outside of a 5-m-long, 3-cm-diameter thin horizontal copper tube by…

A: Given: The length of the copper tube is L=5 m The diameter of the copper tube is d=3 cm The velocity…

Q: Problem Solving A 5.092 m³ rigid tank contains 100 Kg of saturated water vapour, What is the…

A: Write the given values along with suitable variables. V1 = V2 = 5.092 m3 Mg1 = 100 kg T2 = 200° C

Q: 1. Refrigerant 134-a enters an adiabatic compressor as saturated vapor at 0 °C and is compressed to…

A: Given data: R-134a refrigerant enters an adiabatic compressor as: Saturated vapor at T1=0 °C and is…

Q: 2- A- Cylinder has a 0.1m in length and 0.1min diameter, is initially at 292 K. It is suspended in a…

A: Given data: -  The length of the cylinder is l = 0.1 m. The diameter of the cylinder is d = 0.1 m.…

Q: Explain how does properties of substance and processes of vapor can be applied interms of…

A: Evaporation is the transformation of water from a solid to a vapour and its dispersion into…

Q: A mass of 200g of saturated liquid water is completely vaporized at a con- stant pressure of 100…

A: Write the given values with the suitable variables. m=200 g=0.2 kgP=100 kPa=0.1 MPa Here, m is the…

Q: Scale and sludge formation causes serious problems in boilers. Explain how the scales and sludge…

A: Thermal power plants use the calorific power of coal to convert to heat and evaporate water. The…

Q: . Determine the SOTR (g/m.h) in a deep tank aeration at a point x= 15.00 at 25°C when the the…

A: INTRODUCTION : The goal of this problem is to compute the SOTR of the given system, and we will use…

Q: Determine the specific volume, specific enthalpy, and specific internal energy of wet steam at 21…

A: As per the guidelines, I can solve only one(By default first one) question at a time. For rest…

Q: Saturated steam at 1 atm condenses on a 3-m-high and 5-m-wide vertical plate that is maintained at…

A:

Q: How do you resolve common problems with condensate traps?

A: The condensate trap is used in the air conditioning unit in which the water weight is generally used…

Q: In what kind of pot will a given volume of water boil at a higher temperature: a tall and narrow one…

A: In a tall and narrow type of pot, the pressure on the bottom is more, and hence the saturation…

Q: The condenser of a steam power plant operates at a pressure of 7.38 kPa (Tsat = 40°C). Steam at this…

A:

Q: Geothermal steam at 165°C condenses in the shell side of a heat exchanger over the tubes through…

A: The diameter of the tube is: D=4 cm=0.04 m. The length of the tube is: L=14 m The inlet tempearture…

Q: Water is boiled at atmospheric pressure by a horizontal polished copper heating element of diameter…

A:

Q: Water in a tank is to be boiled at 143.27 Pa absolute pressure by a 1.5-cm-diameter brass heating…

A: The pressure should be P = 143.27 kPa not Pa.

Q: 3–39 Water is to be boiled at sea level in a 30-cm-diameter stainless steel pan placed on top of a…

A:

Q: . A well-insulated piston-cylinder device contains 5 L of saturated water at a constant pressure of…

A: GivenV=5L=5×10-3 m3P=150KPaPw=500WI=8At=38minx=0.50

Q: Wet steam at 1 MPa flowing through a pipe is throttled to a pressure of 0.1 MPa. If the throttling…

A:

Q: Water is boiled at 250°F by a 2-ft-long and 0.5-in diameter nickel-plated electric heating element…

A: According to the given information, we obtain properties of water from the table with a saturation…

Q: h of the following is not an assumption that Nusselt made in analytically deriving the average heat…

A: we are to discuss the assumptions made for convection on vertical plate

Q: 2. Humid air at 35o C and a pressure of 1 atm and with 98% relative humidity enters a condenser in…

A: Given: Properties of humid air  T1=35oCP=1 atmRelative Humidity φ=98%Tcond=15oC=288…

Q: A horizontal pipe of 125-mm-diamter and 1 m long with a surface temperature of 95 ℃ is used to…

A: The modified latent heat can be determined from Jacob's number. Jacob's number is defined as…

Q: Water at 90° C and a rate of 0.5 kg/s is cooled to 45° C in a copper pipe of 2 cm outer diameter and…

A:

Q: fas The condenser of a steam power plant operates at a pressure of 7.38 kPa (Tsat = 40°C). Steam at…

A: SOLUTION  Saturated steam at a pressure of 7.38 kPa (Table A-9) condenses on a horizontal tube at 30…

Q: 6. Saturated steam at 1 atm is condensing on a horizontal tube at a rate of 300 kg/h. The tube is 2…

A: Given: The steam pressure, P = 1 atm The rate of steam condensation, m = 300 kg/h The length of…

Q: A hot water pump pumps water from a tank (known as the condenser) up to a storage tank- boiler. The…

A:

Q: Calculate the value of dryness fraction? in vessel which is volume of 5 m^3 contains (4.95 m^3) of…

A: Given data  P = 100 kPa Vf = 0.05 m3 Vg = 4.95 m3   To determine  dryness fraction

Q: At 101.325 kPa, the latent heat of boiling latent heat of water is 2257 kJ/kg. Calculate the amount…

A:

Q: In a reservoir system with a very large accumulation volume for the ideal fluid (water), a) Since…

A:

Q: Determine the type of steam, given: Enthalpy: 3423 kJ/kg Pressure: 500 kPa O subcooled Liquid O Wet…

A: Given:

Q: A horizontal pipe of 100-mm-diamter and 1 m long with a surface temperature of 94 ℃ is used to…

A: Given:d=100 mm =0.1 mTs=94°CAt P=1 atm =101.325 KPa:Tsat=100°Cρv=0.596 Kg/m3hfg=2257 KJ/KgTf=370…

Q: Water is boiled at atmospheric pressure by a horizontal polished copper heating element of diameter…

A:

Q: Determine the rate of change of the boiling point

A:

Q: Saturated refrigerant-134a vapor at 34°C is to be condensed as it flows in a 1-cm-diameter tube at a…

A: Draw the T-S diagram of the process. Write the given data:

Q: Carbon dioxide gas at 3 MPa and 500 K flows steadily in a pipe at a rate of 0.4 kmol/s. Determine…

A: Given The pressure of the carbon dioxide gas is P=3 MPa. The temperature of the gas is T=500 K. The…

Q: A mixture of benzene and toluene boils at 368 K (95º C) under a pressure of 101.325 kPa. Determine…

A:

Q: A 40 by 40 cm plate is inclined at an angle of 30° with the vertical and exposed to water vapor at 1…

A:

Q: How does a boiling process at supercritical pressures differ from the boiling process at subcritical…

A: Given Data⇒Boiling process Supercritical pressuressubcritical pressuresProblem definition⇒How does a…