Self inductance of an inductor with toroidal geometry is 231 nH. The total number of turns of this inductor is 16. If a current of 17 A flows through the inductor, calculate its total magnetic flux in units of μWb. Yanıt: Cevap

Self inductance of an inductor with toroidal geometry is 231 nH. The total number of turns of this inductor is 16. If a current of 17 A flows through the inductor, calculate its total magnetic flux in units of μWb. Yanıt: Cevap

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter25: Surge, Spike, And Lightning Protection

Section: Chapter Questions

Problem 10RQ: In reference to the load, how are capacitors connected to help prevent voltage spikes and surges?...

See similar textbooks

Related questions

Q: 13. How can be increased the accuracy of the derivatives for linear finite elements in FEM…

Q: What is the voltage rating of the conductors in Type NMC cable?

A: Type NMC cable is a type of non-metallic sheathed cable commonly used in residential construction.…

Q: Question-Electrical Engg. The core of toroid is 12 cm² and is made up of material with the µ 200. If…

A: Area of the core of the toroid A=12 cm2, Relative permittivity μr=200, Mean radius R=50 cm,…

Q: In the following circuit, find the real part (R₂) of the Z,in order to obtain maximum power transfer…

Q: The configuration of the figure is 1 R₁ ww R₁ R ol C

Q: Bonus) Z-75-100 f=1.09 GHz C1 C L1 L=? R1 R=500 Find the values of C1 and L1 that cause the…

A: Given data R1=50 Ω Z=75+j0 Ω f=1.09 GHz To find out We have to determine the value of L1 and C1.

Q: Problem seven Using Routh- Hurwitz array, to determine the range of K for a stable system. functions…

Q: The only way to reach any of the levels where ABC Company is located in a building with ten stories…

A: In this scenario, we are tasked with describing the best wiring for the lift shaft in a ten-story…

Q: 7.3. For the following circuit, find the mathematical expressions for ic(t) and Vc(t) in the…

A: Given Data: An RC transient circuit with, Input current Is=10ut-0.5 mA Input voltage Vs=100ut-1.5 V…

Q: For the circuit attached: A. Write out the matrix equation for the voltages at the nodes B. Relate…

A: The nodal equation Matrix needs to be obtained by using the nodal analysis techniques

Q: A DC voltage has an average value of 68 V. What is the RMS value?

A: Average value of DC voltage = 68V

Q: Find the Thevenin equivalent at terminals a-b of the circuit 4Ω 2/0° A -j3 Q o a 1.51x b

Q: Let vs(t) = e-2tu(t) (in volts), R = 7 mΩ, C = 3 F, and vc(0-) = 0. Then the current…

A: In steady state capacitor act as open circuit. In steady state inductor act as short circuit. The…

Q: (Example 4.12) Determine all node voltages and branch currents assuming = 100. +5 Vo 10 ΚΩ 2₁ 22 +5…

Q: Q4 Calculate the value of the multiplier resistor for a 10 V rms ac range on the voltmeter in the…

Q: At what angle does the voltage reach its maximum negative value on a sine wave?

A: The angle at which voltage reaches its maximum negative value on a sine wave is called the phase…

Q: Question 6: Find the impulse response h[n] for causal LTI discrete-time system satisfying the…

Q: RG =1MQ From the Circuit Above Calculate VGS(off) Vp = ID= VDS = V MA V VDD = 30V www Rp 1kQ loss =…

Q: Find the output sign when the sign x(t) is applied to the input of the system with the unit impulse…

A: Given: To find: Output when the signal x(t) is applied to the input of the system with the impulse…

Q: QUESTION 2 The Capacitor in this circuit is fully discharged when the Switch is closed at time t =…

A: In this question we need to choose a correct option.

Q: Dielectric constant of a solid dielectric is 6, and it has an internal void of thickness 2mm. The…

Q: 4. Cylindrical volume 0 < p< 5 cm,0 < z< 20 cm, 0 < < 2π It has an electric flux density value D Z…

Q: Two loads are connected in parallel to a 2000 V(rms) 50Hz source. one of the loads Each of them has…

A: Since you have posted the questions with multiple subpart and so we are supposed to answer 3…

Q: Discussion 1- If Op Amp is operating at 1000 Hz as input wave, what is the frequency of the output…

A: The given input and output waveform for differentiator operational amplifier is shown below.

Q: Help please I have to design a combinational circuit that adds two 4 bits binary numbers together,…

A: To design a combinational circuit that adds two 4 bits binary numbers together, using one half…

Q: R. R₂- G₁ -H₁ G₁ G. G G I H, G₁ -C₁ C₂

Q: Accordingly, find the current i at t=21.6 seconds. V=35cos(1300t+40) volts R1=11 ohms C=90 microF…

A: Here in the expression of voltage, the phase is considering as in radians. (Since here, didn't…

Q: PLEASE SOLVE HANDWRİTİNG

A: Given: For PCM encoder, number of bits in encoder n= 7, Data rate, R=50×106 bits/sec, To find: a)…

Q: Which expression shows the most simplified version of the following circuit? (53 is the most…

A: We need to find out output for given MUX circuit.

Q: Explain about the power generation from renewable sources, write an example of each type. (Solar,…

A: Step-1-> Renewable energy sources are forms of energy that can be replenished naturally and…

Q: Temperature coefficient of resistance. 3. Simplify the Boolean function below and draw the…

Q: 14.- classify classify the filter. с in L ross SR 41 fo Rout

A: We need to tell about type of filter for given circuit.

Q: Here is my truth table and here's my digital circuit. I need help making sure it works with the…

A: A truth table of four input variables A, B, C and D with 7 output variables a, b, c, d, e, f and g…

Q: A. What is the electromagnetic compatibility? And what is its aspects? B. What is the difference…

A: Answer is given below:

Q: Determine the total input resistance of the emitter follower in Figure 6-29. Also determine the…

Q: VIN 68Ω 68Ω 5V NMOS VOUT

Q: A source voltage is given by the equation e- 277 sin(314t). If this source voltage is connected to a…

A: Voltage equation is given as, e=277sin314t V. Resistance is given as, R=10 Ω.

Q: How is the grounded conductor in a flat multiconductor cable 4 or larger identified?

A: In a flat multiconductor cable, the grounded conductor is identified using a color code. This is…

Q: 3 mA 10 ΚΩ

A: Circuit diagram is given as,

Q: As given in the figure a clamper circuit with the input signal Vi is proposed to design. Determine…

A: According to the question, we need to plot output waveform for the for the proposed clamper circuit…

Q: Explain about the power production scenario and write down about the growth.

A: Step-1-> The power production scenario refers to the overall landscape of electricity generation,…

Q: Explain the principle of operation of Zener diodes

Q: obtain the expression for Vo for the following circuur

A: When p side of diode is at higher potential than n side it is forward bias. When p side of diode is…

Q: Problem 5: (Fourier Transform of the Complex Exponential Signal) Calculate the Fourier Transform of…

Q: In the circuit below, BDC-BO-180 is given as VBE-0.7V. Find the Zib and ZO values accordingly. a) 5…

A: In the given questions we need to calculate the input and output Impedance of the amplifier.

Q: For the system of Figure 2, T = 2 s and + G(z) = K(z + 0.8) (z − 1)(z-0.6) T G(s) Figure 2. Unity…

A: Given data T=2 s Gz=Kz+0.8z-1z-0.6 To find out We have to determine the stability using the…

Q: The average value of a sine wave is as 0.637 0.5 1.21 0.707 ***** . times the peak value

Q: In the circuit below, we know that Q1 and Q2 have Beta-100 and VA-100 V. Knowing Vcc=10 V, (c) Find…

Q: Obtain the state-space model of the electrical system given below. Take the coil current and…

Q: Design an active first-order bandpass filter with a lower cutoff frequency of 2,000 Hz, an upper…

A: Given that, lower cutoff frequency, f1=2000 Hz upper cutoff frequency, f2=40000 Hz pass band gain,…

Question

Calculate please...

Self inductance of an inductor with toroidal geometry is 231 nH. The
total number of turns of this inductor is 16. If a current of 17 A flows
through the inductor, calculate its total magnetic flux in units of μWb.
Yanıt:
Cevap

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given data :

VIEW

Step 2: Calculation of flux :

VIEW

Solution

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
In reference to the load, how are capacitors connected to help prevent voltage spikes and surges? Are capacitors connected in parallel or in series with the load?
Please answer it in 1hr. Topic: Capacitance and Magnetics write your solutions neat and complete thank you
An inductor is constructed by winding a coil of 100 turns around a magnetic core. The core is a cylinder with radius 0.5 cm and the core material has relative permeability of 1000. The coil covers a length of 10 cm. Determine the resulting inductance. Enter your answer in mH rounded to two decimal places.
Self inductance of an inductor with toroidal geometry is 231 nH. The total number of turns of this inductor is 16. If a current of 17 A flows through the inductor, calculate its total magnetic flux in units of uWb. Yanıt: Cevap
An air core toroidal coil has 120 turns, the length is 12 cm and 12 sq. cm in area What is the current required to set up a flux of 1.2x10° weber. What is the current?
A ferromagnetic core in the shape of a doughnut has a cross-sectional area of 0.11 m2 and an average length of 1.4 m. The permeabil ity of the core is 1.206 × 10-3 Wb/A-t. m. Determine the reluctance of the magnetic circuit
Self inductance of an inductor with toroidal geometry is 231 nH. The total number of turns of this inductor is 16. If a current of 17 A flows through the inductor, calculate its total magnetic flux in units of uWb.
A 100-turn coil wound on a magnetic core is found to have an inductance of 200 mH. What inductance will be obtained if the number of turns is increased to 200, assuming that all of the flux links all of the turns?
4. The flux produced in the dielectric of a capacitor is 9 x 10-4 coulomb when th impressed emf is 1,500 volts. What is the capacitance of the capacitor? 5. Calculate the capacitance of a parallel-plate capacitor that consists of 80 glas plates, each one 0.045 in. thick, and 81 sheets of 6.5- by 7.5-in. aluminum fo
Define the term Capacitance and Inductance? Capacitance: It is the amount of charge that is stored inside a capacitor at a given voltage. Inductance: It is defined as the property of a coil to resist any changes in electric current flowing through it. Mutual inductance happens when a secondary coil opposes current change in the primary coil. Mention what is the difference between generator and alternator? Both generator and alternator work on the same principle they convert mechanical energy into electrical energy. Generator: It converts induced emf (Electro Motive Force) into direct current, where it based on stationary magnetic field and revolving conductor which rolls on the armatures with slip rings and brushes riding against each other. Alternator: It has rotating magnetic and stationary armature for high voltage and stationary magnetic field and a rotating armature for low voltage
Due to mutual inductance between two coils, there is an induced emf in one coil due to a change in current in the other coil. O True O False O Hard to say