series RLC circuit has a bandwidth of 300 rad/sec at a resonant frequency of 3000 rad/sec when exited by a voltage source of 100 V. The inductnce of the coil is 0.1 H. The value of R and the voltage across C are respectively ?

series RLC circuit has a bandwidth of 300 rad/sec at a resonant frequency of 3000 rad/sec when exited by a voltage source of 100 V. The inductnce of the coil is 0.1 H. The value of R and the voltage across C are respectively ?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter24: Resistive-inductive-capacitive Parallel Circuits

Section: Chapter Questions

Problem 4RQ: A tank circuit contains a capacitor and an inductor that produce 30 of reactance at the resonant...

See similar textbooks

Related questions

Q: For the network of figure below, if the mid- band voltage gain is (-2.47), answer the following: a.…

A: JFET(Junction -gate field -effect Transistor) is three terminal electronic device. Three terminal…

Q: In the circuit shown, the sinusoidal voltage Vent (input voltage) is the input quantity and Vsal…

A: Given the circuit: In the circuit shown, the sinusoidal voltage Vent (input voltage) is the input…

Q: 1. The resistance and inductance of the circuit are 100Ω and 20mH, respectively.1. Find the value…

A: (1) Write the condition for a critically damped system and substitute the known values.

Q: 1) from rootlocus fig , Determine damping ratio and ( Wn ) of the closed loop system for K=10. 2)…

A: From the given root locus curve the transfer function of the given system can be written by…

Q: The inductance coil in the series resonant circuit is 0.2 H, and the resistance coil is 50 Q. At…

Q: (1) The circuit shown in Figure 1.7 is a second-order RLC circuit where a capacitor, inductor and…

Q: A yucncy iesponse transfer function of a certain electrical circuit is as given below. Simplify the…

Q: ESTION 2: For the response curve shown below of a series RLC resonant circuit, find the following…

A: For the curve, RLC series resonance circuit, Quality factor And bandwidth? The value of…

Q: With regards to the Nyquist plot, calculate the phase (in degrees) of the following transfer…

A: Given transfer function is =

Q: For the network of figure below, if the mid- band voltage gain is (-2.47), answer the following: a.…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: The bode plot is a standard approach to feedback control systems analysis and design. The transfer…

A: Given transfer function is =

Q: For the network of figure below, if the mid- band voltage gain is (-2.47), answer the following: a.…

A: "Since you have posted a question with multiple sub parts we will solve first three subpart for you…

Q: 8 A voltage v(t) = 100 sinot is applied to a series RLC circuit. At the resonant frequency of the…

A: In this question, we need to determine the resonance frequency, upper and lower cut off frequency,…

Q: Propose a transfer function, G(s), whose approximate Bode magnitude must satisfy the following…

Q: V,(t) ) ) R$ L{ C: Figure 5. The parallel RLC circuit. P4 For the parallel RLC circuit given in…

A: Given,

Q: For the network of figure below, if the mid- band voltage gain is (-2.47), answer the following: a.…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: You are given the following transfer function, 20 (s2 + 5s + 25) (s + 0.2) (s² + 5s + 2500) H(s) =…

A: Given

Q: 3. Consider the following series RLC circuit where the maximum input voltage is 500 mV. At what…

A: Since we are allowed to solve only up to three subparts of a question. Kindly upload the remaining…

Q: You are given the following transfer function, 20 (s2 + 5s + 25) H(s) = (s + 0.2) (s2 + 5s + 2500)…

A: Given

Q: coil of inductance 150 mH and resistance 38 ohms is connected in series with a 14 ohm resistor and…

A: Answer -

Q: A coil having an induction of 0.5 H and a resistance of 60 № is connected in series with a…

A: Given a coil with, Inductance, L=0.5 H. Resistance, R=60 Ω. Capacitance, C=10 μF. Supplied ac…

Q: 4- In a bode magnitude plot, which one of the following slopes would be exhibited at high…

A: We need to select correct option for given statement.

Q: thể hetwork of figure below, if the mid-band voltage gain is (-2.47), answer the following a. Draw…

Q: Q No 3 20 Q at the resonant frequency of Wo = 50 rad/sec and a quality factor of 60. Also find the…

Q: A parallel RLC network is constructed using R = 5 Ω, L = 100 mH, and C = 1 mF. (a) Compute Q0. (b)…

Q: For the network of figure below, if the mid- band voltage gain is (-2.47), answer the following: a.…

A: "Since you have posted a question with multiple sub parts, we will solve the first three subpart for…

Q: ı just need fınal aswer In the circuit in the figure, Rs = 3.8 kΩ, R1 = 82 kΩ, R2 = 22 kΩ, RC = 5.6…

A: consider the given question;

Q: series RLC circuit has R = 5 W, L = 0.2 H and C = 50 µF. The applied voltage is 200 V. Find (i)…

A: In this question series RLC circuit has R = 5 W, L = 0.2 H and C = 50 µF. The applied voltage is 200…

Q: For the network of figure below, if the mid- band voltage gain is (-2.47), answer the following: a.…

A: "Since you have posted a question with multiple sub parts we will solve first three subpart for you…

Q: In an RLC circuit with a high quality factor:a. Show that the impedance at the resonancefrequency…

A: Let assume the series connection and determine the total impedance of the series RLC circuit is…

Q: Question 3 The results of an open loop frequency response test are presented in Table Q3. o (rad/s)…

Q: For the network of figure below, if the mid- band voltage gain is (-2.47), answer the following: a.…

A: "Since you have posted a question with multiple sub parts we will solve first three subpart for you…

Q: 1. For the system shown below, do the following: R(s) + E(s) K(s + 5) sis2 + 4s +25) C(s) a. Sketch…

A: Given, The block diagram of the system is shown below,

Q: For a parallel RLC circuit, if R = 40 ohm, L = 2H and C=0.5 F. the bandwidth and quality factor are…

A: we need to determine bandwidth and quality factor.

Q: 753. For the transfer function (TF) 2s/(s+3) and resulting Bode Plot, calculate the gains (dB) at…

A: Note: We are authorized to answer one question at a time since you have not mentioned which question…

Q: circuit comprises of a coil (resistance of 20W, inductance of 400mH), and a capacitor of 2.0mF…

Q: Consider RLC circuit which is connected in series. Inductance in 25 mH and resistance is 10 Ohm,…

A: The solution can be achieved as follows.

Q: 10.4. A parallel RLC circuit is driven by a variable frequency 2 mA current source and has the…

Q: Consider the RLC series circuit shown with ve(t) = 10cos(wt) V, R = 15N, L = 3mH and C = 7µF.…

Q: In the circuit in the figure, Rs = 3.8 kΩ, R1 = 82 kΩ, R2 = 22 kΩ, RC = 5.6 kΩ, RE = 1.5 kΩ and RL =…

A: Answer for this question is as follows:

Q: Q5: Simplify the following transfer function to write the magnitude equation in (dB) and the phase…

Q: Electronic In the circuit in the figure, Rs = 3.8 kΩ, R1 = 82 kΩ, R2 = 22 kΩ, RC = 5.6 kΩ, RE = 1.5…

Q: 1. A series resonant circuit will resonate at a frequency (fs) of 1 MHz with a bandwidth of 0.2 fs.…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Question 4 For RLC circuit that has Q-factor of 4.5 and inductor reactance of 22.5 Ohm, the value of…

A: We have to calculate the value of Resister if Q and Inductor Reactance is given i. e. 4.5 and 22.5…

Q: Using the graph windows below, generate Bode plots for the magnitude and phase of the transfer…

Q: A parallel RLC resonant circuit has a resistance of 250 ohms. If it is known that the bandwidth is…

Q: For the circuit at right, determine the magnitude, in decibels, of the voltage transfer function at…

Q: A parallel R-L-C circuit is fed by a constant current source of variable frequency. The circuit…

Question

A series RLC circuit has a bandwidth of 300 rad/sec at a resonant frequency of 3000 rad/sec when exited by a voltage source of 100 V. The inductnce of the coil is 0.1 H. The value of R and the voltage across C are respectively ?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

You are an electrician working in a plant. A series resonant circuit is to be used to produce a high voltage at a frequency of 400 Hz. The inductor has an inductance of 15 mH and a wire resistance of 2 . How much capacitance should be connected in series with the inductor to produce a resonant circuit? The voltage supplied to the circuit is 240 V at 400 Hz. What is the minimum voltage rating of the capacitor?
A tank circuit contains a capacitor and an inductor that produce 30 of reactance at the resonant frequency. The inductor has a Q of 15. The voltage of 277 V is connected to the circuit. What is the total circuit current at the resonant frequency?
Calculate the bandwidth in kHz Blank 1 and an inductor's Q Blank 2 at100MHz. It has an inductance of 6mH and a series resistance of 1.2k2.
A series RLC circuit contains a resistor with a true power of 18 watts, an inductor with a reactive power of 24 VARS, and a capacitor with a reac- tive power of 34 VARS. What is the circuit power factor?
A series RLC circuit has a resonant frequency of 6 KHz. When it is driven at 8 KHz, it has an impedance of 1 k? and a phase constant of 450. What are (a) R, (b) L, and (c) C for this circuit?
What capacitance value is required for each of the varactors in the following figure to produce a resonant frequency of 1 MHz? VRO- D₁ D₂ 000111 2 mH
In a series RLC circuit, the applied voltage is 108V. At resonance, the frequency is 200rad/sec, and the circuit current is 8.38 A. What is the resistance of the circuit (in Ohms)?
Describe what happens to the current in this RC series circuit as the frequency increases. Explain in general terms why the observed change should occur.
A series circuit consisting of a 302, resistor and a 4µF capacitor is connected in parallel with a variable inductor. For what value of inductance will the circuit be in resonance if the frequency of the source is 1,200cps?
A choking coil is connected in series with a 50 uF capacitor across a 959 Hz supply. What is the inductance of the coil to give resonance?
In a series RLC circuit, at high frequencies, capacitance is dominant and the phase angle approaches 90 degrees. True False
In a series resonant circuit, the resonant frequency is to be reduced. If only capacitance can be changed, then how the capacitance should be altered? Increaased or decreased?