A 50 KVA , 2200/440V , 50hz single phase transformer has primary turns of 200. Determinea. Flux in coreb. Secondary turnsc. Rated primary currentd. Rated secondary current

Answered: Image /qna-images/answer/aa02f5a1-68d5-4d72-b638-bf9c16999dd0.jpg

Answered: single phase transformer has primary…

Engineering

Electrical Engineering

single phase transformer has primary turns

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.10P: A single-phase step-down transformer is rated 13MVA,66kV/11.5kV. With the 11.5 kV winding...

See similar textbooks

Related questions

Q: 3. The insulation used in high voltage circuit breakers of large power rating is (a) air (b) vacuum…

A: In this question, We need to determine the insulation used in high voltage circuit breaker of…

Q: Short Circuit T-L, sketch the SW Pattern for Ed sketch the Variation of Zd with distance ,d3D0,…

A: First I provided z impedance plot and then Ed plot

Q: Let εR = 3, μR = 6, and σ = 0. If Jd = 38sin(2.07 x 105t - 8x) az μA/m2, find E(t=2.1, x = 4.2).

A: The solution is given below

Q: Solve the power triangle at Z2 using the following network law below. 1.) Kirchoff's Law Given: V1…

Q: Refer to circuit in Figure 3, determine i(t) at t> 0 s. t= 0 10 60 i(t) 1 mF 30 V + 40 2.5 H Figure…

A: The solution is given below

Q: The figure represents the equivalent circuit of a single-phase transformer, if after doing the…

Q: (c) Refer to the circuit in Fig 7.2 for this part of the question: (i) Given Vs = 10 V, Ip = 15 mA,…

A: Brief description : In the above given question they want to know the DC parameters and small signal…

Q: I need to convert the drawing from a handwritten drawing to a typeface on the computer, please 스

A: I have to type the image in the computer.

Q: An AC voltage of 230 v is applied to a circuit consisting of a resistance of 10 ohms in series with…

Q: Design an unregulated power supply consisting of a center-tapped transformer full-wave rectifier and…

A: Unregulated power supplies are used where the load requires constant power with low ripple. A Centre…

Q: 3.9i A uniform volume charge density of 80 µC/m³ is present throughout the region 8 mm 10 mm, find…

A: We need to find out charge enclosed and electric flux density .

Q: Determine the values of V1, V2, and V3 for the circuit shown below. 80 WW- V1 30 V: 60 V3 30V

Q: 6. What frequency will be developed if the speed is: а. 900 грm b. 1650 rpm

Q: what voltage of battery will work in 6v solar panel? can i connect 2 pieces of 6v solar panel to…

A: The solution is provided in the following section.

Q: need to convert the drawing from a handwritten drawing to a typeface on the computer, please OPEN…

A: We have to type the image in the computer.

Q: Consider an a.c circuit supplied by 220V at 50HZ. The circuit consists of only two inductors, L1 and…

Q: It is the most commonly used stepper motor driver which is directly connected to the PC.

A: The most commonly used stepper motor driver which is connected to the pc is " ULN2003".

Q: If R1 = 120, R2 = 20. The source Voltage is 120 Volts. I, VAC R1 R2 11 12 Find the Total Current in…

Q: (b) The current through i(t) = Im cos(wt + 30°), Im = 5 mA, w = 6.283 rad/s, and the voltage across…

Q: T-L with Zo=600 2 ,ZR = 100 N. Find the length and location of the %3D single stub terminated by…

Q: Example23/ Two transformers are designed to match a line having a Z, = 300.2 , Zr = 750 find Stable…

Q: 9- Why the gain of the amplifier in the low frequency side decrease when the frequency decrease for…

A: As per the guidelines of bartleyby I need to answer first three questions only so Kindle repost…

Q: Q2: A string of 4 insulators has pin-to-earth equal to 0.2 of self-capacitance. Calculate (i) the…

Q: An alternator has 16 poles. At what speed must it be driven to develop 40 cycles

Q: 2. In the circuit shown, find the current through the capacitor using Kirchhoff's Law

Q: Example23/ Two transformers (4) are designed to match a line having a Z, = 3002 , Zr = 752 find…

Q: Example23/ Two transformers (4) are designed to match a line having a Z. 3002 , ZR = 75N find Stable…

Q: (wt + 68") amp respectively, BAC circuit. What is the impedance of a balanced wye connected load and…

A: The solution is given below

Q: Open write T-L with L=30 m , ZR = Z, = 50 N , f=50 MHZ Find Z, and Za d = 10 m

A: Given Zr=Zo implies perfectly matched condition.

Q: A second order system has damping ratio 0.2. The nature of step response will be a. straight line b.…

A: Given data, A second order system with Damping ratio, ζ=0.2

Q: In a tansistor, IC = 100 mA and IE = 100.2 mA. The value of B O50 O100 about to1 O 200

A: Given: Collector current, IC=100 mA Emitter current, IE=100.2 mA

Q: Short Circuit T-L, sketch the SW Pattern for Ed sketch the Variation of Zd with distance ,d%3D0,…

A: In figure E is denoted as V. Impedance is plotted against distance from the load end

Q: 7.) The current i(t) (in mA) through a capacitance of value C = 100uF where t is in seconds is given…

Q: need to convert the drawing from a handwritten drawing to a typeface on the computer, please

A: The given drawing is shown below:

Q: 2. What type of energy is stored up in a capacitor? In a storage cell? In an inductive circuit? Why…

Q: Completely solve and box/highlight/bold the final answers. WRITE LEGIBLY OR TYPEWRITE THE SOLUTIONS.…

Q: 2 The magnetic vector potential of two parallel infinite straight current filaments in free space…

A: Magnetic Flux Density: Magnetic Flux Density is the quantity of magnetic flux per unit area measured…

Q: 16 V 3.6 k2 470 k VC VD Joss 8 mA 1kn Figure (6) VD=? VC=?

A: We need to find out the voltage at drain and collector terminal of the given circuit

Q: Example: The rectangular coil in Figure below is in a field B = 0:05 +a,) T (a) Find the torque…

Q: 1. Determine I, in the circuit shown by mesh analysis jan -jir

Q: -jon 1, jen

Q: jen -jir

Q: The equivalent (i.e. total) impedance seen by the power supply in this circuit is: 8Ω 5 cos 2t A (1…

A: We need to calculate inductive reactance and capacitive reactance corresponding to given angular…

Q: For a two-port reciprocal network, the three transmission parameters are A = 4, B=7 and C = 5. What…

A: The solution is given below

Q: When Binary number A=1010 and B=1010, what is the output x in the following diagram? A,A,A, В, В, В,…

Q: T-L with Zo=600 0,ZR = 100 Q. Find the length and location of the single stub terminated by short…

Q: 8. Resins and vamishes are mainly used for (a) transformer coil impregnation (b) Generator and motor…

A: Resins and varnishes are mainly used for Generator and motor coil impregnation.

Q: 4. A single phase load draws a current of 30 / 35 deg A. The voltage across the load is 220 / 75 deg…

Q: There are two loads connected in parallel and powered from a 7200-V source. The first load is 50-kVA…

Q: (b) (b) Refer to Figure 7.1, Given that R1=2kQ, R2=1kQ, R3=2kQ, Vs=9V, Vg=3.5V. (i) Determine the…

A: Given, The diode is ideal. R1=2 kΩR2=1 kΩR3= 2 kΩVs=9 VVB=3.5 V

Concept explainers

Single Phase Transformer

A single-phase transformer is a type of power transformer. It is an electrical device that accepts converts the single phase alternating power into single phase alternating power. In this power conversion the voltage is stepped up or down. If the voltage is stepped up, the current will be stepped down and if the voltage is stepped down, the current will be stepped up.

Question

A 50 KVA , 2200/440V , 50hz single phase transformer has primary turns of 200. Determine
a. Flux in core
b. Secondary turns
c. Rated primary current
d. Rated secondary current

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

With the American Standard notation, in either a Y-or-Y transformer, positive- sequen quantities on the high-voltage side shall lead their corresponding quantities on the low-voltage side by 30. (a) True (b) False
A single-phase step-down transformer is rated 13MVA,66kV/11.5kV. With the 11.5 kV winding short-circuited, rated current flows when the voltage applied to the primary is 5.5 kV. The power input is read as 100 kW. Determine Req1andXeq1 in ohms referred to the high-voltage winding.
A single phase 50 cps transformer is required to have a no load voltage ratio of 3300/440 volts. The total maximum flux in the core is to be about 50 mwb. Find the number of turns in the secondary.
The ratings of a single-phase three-winding transformer are as follows:*primary winding: 300 MVA, 14kV*secondary winding: 300MVA, 200kV*tertiary winding: 40MVA, 20kV. The leakage reactances are:*Xps = 0.1 at 300MVA, 14kV*Xpt = 0.16 at 40MVA, 14kV*Xst = 0.14 at 50MVA, 200kV Neglecting the winding resistance and exciting current, calculate Xp, Xs and Xt using 300 MVA and 14kV as the base for the primary winding.
The core loss of a single phase, 230/115 V, 50Hz power transformer is measured from 230 V side by feeding the primary (230 V side) from a variable voltage variable frequency source while keeping the secondary open circuited. The core loss is measured to be 1050 W for 230 V, 50 Hz input. The core loss is gain measured to be 500 W for 138 V, 30 Hz input. The hysteresis and eddy current losses of the transformer for 230 V, 50 Hz input are respectively
In the single-phase, three- winding, transformer, the primary current is equal to lo at the condition of ints there is no load on tertiary windings the current in secondary windings equal to zero the resistances (R1, R2, and R3) in transformer windings are equal the inductances (L1, L2, and L3) in transformer windings are equal.
Find the following : 1.Ripple Voltage (vpp) 2. Zero-to peak ripple(Vop) 3.secondary winding of the transformer high line and low line
1- When 400 volts, 60HZ is applied to the transformer primary winding maximum flux in the core is--
Q7/ Complete the blank The copper loss of a transformer at 4/5 of the full load is 4000 W, full load copper loss will be..........................................?
In no load phasor diagram of practical transformer, the magnetizing current is with flux 4. In phase 90 Degree out of phase Lagging by 60 Degrees Leading by 60 Degrees
Q6 Complete the answer : If connected .................... to the transformer changes, copper loss varies.
A core type transformer operates on 405 / 225 volt, 55 Hz supply. If the cross-sectional area of the core is 30 cm² and maximum flux density is 1.3 Wb/m² , then the number of turns in primary winding will be A 4 pole lap wound enerator has 36 slots with 20 conductors/slot and the average emf generated in each conductor is 1.78 volts. Then the Total EMF generated in volt is