1Study the below response which obtained from HVACexperiment to find the following:SetpointUpper LimitLower Limit =Digital ScopesChamber Temp 23.0CSetpointAmbient21.4 22.5 CTemperature (C)MeasuredAV23.5-Signal Generator 223.4-Signal Type23.3-23.2-23.1-Amplitude0.0023-Frequency0.0080Hz22.9-Offset0.5022.8-22.7-Control Parameters22.6-Vh amp2.50V22.5-0.05.010.015.020.0 25.030.035.040.045.050.055.060.0Vh off2.50VATh0.25

Study the below response which obtained from HVACexperiment to find the following: Setpoint Upper Limit =- Lower Limit = Digital Scopes Chamber Temp 23.0 Setpoint Ambient 21.4 22.5 C Temperature (C) Measured 23.5- Signal Generator 2 23.4- Signal Type 23.3- 23.2- 23.1- Amplitude 0.00 23- Frequency 0.0080 Hz 22.9- Offset 0.50 22.8- 22.7- Control Parameters 22.6- Vh amp 2.50 V. 22.5- 0.0 5.0 10.0 15.0 20.0 25.0 30.0 35.0 40.0 45.0 50.0 55.0 60.0 Vh off 2.50 V ATh 0.25 C.

Study the below response which obtained from HVACexperiment to find the following: Setpoint Upper Limit =- Lower Limit = Digital Scopes Chamber Temp 23.0 Setpoint Ambient 21.4 22.5 C Temperature (C) Measured 23.5- Signal Generator 2 23.4- Signal Type 23.3- 23.2- 23.1- Amplitude 0.00 23- Frequency 0.0080 Hz 22.9- Offset 0.50 22.8- 22.7- Control Parameters 22.6- Vh amp 2.50 V. 22.5- 0.0 5.0 10.0 15.0 20.0 25.0 30.0 35.0 40.0 45.0 50.0 55.0 60.0 Vh off 2.50 V ATh 0.25 C.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Consider the closed loop system with response shown in following figure. What is the 10%-90% rise time of the response? Give your answer in seconds to the nearest third decimal place. Do not enter the units. Amplitude 1.4 1.2 1 0.8 0.6 0.4 0.2 OF 0 A H | ¦¦ H 0.05 H H A H I -14 LA 0.1 A 18 0.15 Time (seconds) 0.2 0.25 t 0.3 0.35
5 Problem Match the following two frequency response diagrams: -0 0.4 |G(i w)| 0.2 10 |G(i w)| 5 Response A 2 3 4 5 6 7 8 Frequency, (rad/s) Response B 5 6 7 8 Frequency, w(rad/s) 1 2 3 4 6 6 10 10 10 to two of the following ODES 1. +x+100x = u(t) 5. +100x = u(t) 9. +100x = u(t) 3. x+x+5x= u(t) 4. x+x+x= u(t) 2. x+x+25x = u(t) : 6. x + 25xu(t) 10. +25x = u(t) 7. x+5x= u(t) 8. u(t) 11. +5x= u(t) = 12. xu(t)
An experiment was carried out on a SDOF system to estimate the natural frequency and damping. The time history plotted below has the response in centimetres and the time in seconds, as shown in Figure Q10 below. Estimate values for the following and choose the nearest values from the list given below: the damped natural frequency in Hz; the damping ratio using the logarithmic decrement method; and the natural frequency in rad/s. Ju(t) 2.00 AMA 1.00 0.00 0.00 Figure Q10 0.80 1.60 Select one or more: O a. 4.92 b. 0.781 c. 0.625 O d. 0.330 O e. 0.052 2.40 3.20 4.00 t
(c) An electronic Pl temperature controller has an output p of 15 mA when the set point equals the nominal process temperature. The controller response to step change in the temperature set point of 3 mA is shown below. t(s) 0- 0+ 20 60 80 Determine the controller gain K, and the integral time.r p (mA) 8,0 6,8 6.0 4.4 3.6
H.w 2: The open loop response, that is, the speed of the motor to a voltage input of 20V, assuming a system without damping is dw 20 = (0.02) + (0.06)w. dt If the initial speed is zero (w(0) = 0) ,and using the Runge-Kutta 4th order method, what is the speed at t = 0.8s? Assume a step size of h = 0.4s.
1 Problem You are given the following data (below) showing the steady-state output response, x(t), of a mass-spring-damper (stable, LTI) system to a sinusoidal input u(t) = A sin(wt). This snapshot is the response after all the transients have decayed (the time is shifted to start at zero for conve- nience). x 0.5225 Displacement pu(t) Sinusoidal force input x 0.1041 1.5 1 Y2 х 0.2783 Y1.372 0.5 h ok -0.5- -1 -1.5 x(t) M Assume: bl u(t) x(t) Horizontal Plane (no gravity) 0 0.1 0.2 0.3 0.4 0.5 0.6 0.7 0.8 0.9 Time (sec) www k Using only the data provided above (the blue line is the input u(t) and the red line is the output x(t)), determine: 1. The frequency of the input in rad/s 2. The amplitude of the input, A 3. The frequency of the output in rad/s 4. The output-input ratio |G(iw)| = max(x(t)) max(u(t))' at the particular input frequency shown. 5. The phase (also called phase lag) of the output, $, at the particular input frequency shown in degrees. Note the phase is generally…
Amplitude Given the system unit-step response, determine maximum overshoot, settling time and steady-state error * 1.4 1.2 0.8 0.6 0.4 0.2 0,35 0.05 0.1 Step Response 0.15 0.2 Time (sec) 0.25 0.3 0.35
For the pole plot given below, which pole will have the fastest decrease in exponential transient response? jw O Save X X X X k z y x k
10- The laplace transform of output variable to laplace transform of input variable is called as control system. Select one: True False
2- Using Matlab, what are the step response curves of the closed-loop system, as shown in fig.1. the feedback represents the second-order dynamic system. (fill in the following table) For=0.4 Wn 1 3 6 9 10 R(S) 0.1 0.3 0.6 0.9 1 For w 5 rad/sec 3 Settling time Peak response 2 Wn s(s+23wn) Settling time Peak response C(s) Discuss the follow Which parameters or w occur on the rise time of the response? Which parameter increases the speed of response? Which parameters can be decreases the response amplitude? Which parameter decreases the steady error state? fig.2
Match the transfer function with correct Bode phase plots. G(s) = 5 $+7 G(s)=s+5 G(s) = s+10 S S G(s) = S+ 10 QUESTION 10 90 deg 00 0 deg -90 deg 180 deg B. D 90 deg @ 0 deg -90 deg 180 deg 90 deg @ 0 deg -90 deg 180 deg 90 deg @ 0 deg -90 deg 180 deg
1 Problem 5 4 State, x(t) SAWNO-Nw. ● ● Case 1 O 2 6 Time, sec. underdamped critically damped State, x(t) • overdamped 54321 ONS TY Case 2 2 ▷ Time, sec. 8 10 State, x(t) 5 2 + 3 4 Case 3 2 ▷ 6 Time, sec. 5432 State, x(t) & A & No. 2 Match each of the resposes above to one of the following second-order system types: • undamped Case 4 ▷ Time, sec.