The 1.9-Mg car increases its speed uniformly from rest to 17 m/s in 28 s up the inclined road. Part A Determine the maximum power that must be supplied by the engine, which operates with an efficiency of € = 0.8 (Figure 1) Express your answer with the appropriate units. Figure 10 ? ΜΑ Pmax = Value Units 1 of 1 Submit Request Answer Part B Also, find the average power supplied by the engine Express your answer with the appropriate units. HA Pavg = Value ? Units

The 1.9-Mg car increases its speed uniformly from rest to 17 m/s in 28 s up the inclined road. Part A Determine the maximum power that must be supplied by the engine, which operates with an efficiency of € = 0.8 (Figure 1) Express your answer with the appropriate units. Figure 10 ? ΜΑ Pmax = Value Units 1 of 1 Submit Request Answer Part B Also, find the average power supplied by the engine Express your answer with the appropriate units. HA Pavg = Value ? Units

Sustainable Energy

2nd Edition

ISBN:9781337551663

Author:DUNLAP, Richard A.

Publisher:DUNLAP, Richard A.

Chapter18: Energy Storage

Section: Chapter Questions

Problem 4P

See similar textbooks

Similar questions

The motorcycle has a mass of 0.5 Mgand a negligible size. It passes point A traveling with a speed of 15 m/s, which is increasing at a constant rate of 1.5 m/s2. Determine the resultant frictional force exerted by the road on the tires at this instant. PA= 200 m WAD ALAMS
) A 5-gal, cylindrical open container with a bottom area of 120 in²is filled with water and rests on the floor of an elevator. If cylindricalcontainer is accelerated upward at 3 ft/s², what resultant force doesthe container exert on the floor of the elevator during thisacceleration? The weight of the container is negligible. (Note: 1 gal= 231 in³)
The assembly consists of a 0.8 kg collar attached to a bent rod of negligible weight. The assembly rotates freely about the vertical axis with the angular velocity of 10 rad/s when the braking couple M is applied at time t = 0. If M varies with time as shown, how long will the assembly continue to rotate? M 0.8 kg 12 N.m † (s) 1.0s ارحة Im SM 0
The 250-lb concrete block A is released from rest in the position shown and pulls the 400 lb log up the 30° ramp. Plot the velocity of the block as it hits the ground at B as a function of the coefficient of kinetic friction ug between the log and the ramp. Let µk vary between 0 and 1. Why does the computer not plot results for the entire range specified? 400lb 250lb A 30 deg 20' Hints: -- Model the system as a dependent motion analysis and derive acceleration equations in terms of the unknown quantities -- Use MATLAB to solve this system of equations (you'll need one equation for each unknown!) Define uk as a range in MATLAB from 0 to 0 in 0.01 increments -- Plot the function of the velocity for the block as it hits the ground
The torque (N-m), T, delivered by a water turbine depends upon the discharge (m³/s), Q, head (m), H, specific weight (N/m³), y, angular velocity (rad/s), w, and efficiency (dimensionless), e. Which of the following is the appropriate set of repeating variables to be used? O a. y, T, Q O b. y, w, H O c. T, H, w O d. e, H, w
QUESTION 3: The radius of the flywheel given in the figure is 600 mm. Mass 144The rotation (inertia) radius of the flywheel, which is kg, is 450 mm. To a mass of 18 kgBody A is suspended on a rope wrapped around the flywheel. The system is sluggishHe is released in the (still) state. Body A 1.8 meters downFind the acceleration and velocity of the block when it moves towards.
|1 rad The heavy flywheel of a large engine is accelerated -, from rest. (a) What is the speed in- rev after 20 sec? min 2 sec2 (b) In what time will it reach a speed of 180 ? (c) How many revolutions does it turns before reaching min that speed?
Problem 14-27 The conveyor belt delivers crate each of mass M to the ramp at A such that the crate's velocity is vA, directed down along the ramp. If the coefficient of kinetic friction between each crate and the ramp is uk. determine the speed at which each crate slides off the ramp at B. Assume that no tipping occurs. Given: M = 12 kg V4 = 2.5 Hk - 0.3 g = 9.81 a =- 30 deg %3D a = 3 m 日|s
A 70-kg person paradropped from an airplane at 22000 ft. Given that the air drag that he will experience has a force F= 0.13575v2 Newtons, where v is in meters per second. Determine his terminal velocity. Easy - 10 pts. A- В I II
A sphere is fired downwards into a medium with an initial speed of V= 33m/s . If it experiences a deceleration of a=(-6t)m/s^2, where t is in seconds.(a) Determine the distance traveled before it stops.(b) Total time before it stops.
Convert: (a) 200 lb-ft to N-m, (b) 350 lb/ft3 to kN/m3, (c) 18 ft/h to mm/s.
A 100 J of work is done on a flywheel. Determine its moment of inertia if its angular velocity increases from 60 rpm to 180 rpm.