The authenticity of sodium nitrite and the presence of impurities of nitrites and nitrates in purified water are determined with? A) 8-hydroxyquinoline B) Potassium dichromate in diluted sulfuric acid C) Excess silver nitrate solution D) Antipyrine E) Diphenylamine

The authenticity of sodium nitrite and the presence of impurities of nitrites and nitrates in purified water are determined with? A) 8-hydroxyquinoline B) Potassium dichromate in diluted sulfuric acid C) Excess silver nitrate solution D) Antipyrine E) Diphenylamine

EBK A SMALL SCALE APPROACH TO ORGANIC L

4th Edition

ISBN:9781305446021

Author:Lampman

Publisher:Lampman

Chapter39: Preparation Of An Α, Β-unsaturated Ketone Via Michael And Aldol Condensation Reactions

Section: Chapter Questions

Problem 2Q

See similar textbooks

Related questions

Q: The white solid that remains in the centrifuge tube after acetone extraction fizzes when…

Q: Why was gravity filtration used instead of evaporation to isolate the calcium carbonate?

A: Calcium Carbonate is white, odorless powder or colorless crystals. Practically insoluble in water.…

Q: TLC, a powerful analytical tool, can be used to monitor the progress of reactions. The synthesis of…

A: From the above progress of the reaction we can assume the following things. The reaction for the…

Q: For standard turbidity measurements, the increase in signal is due to a.) higher amounts of analytes…

A: Its intensity ( scattered light ) can also be measured by this, Precipitate size and shape are…

Q: 1. What is the purpose of adding Na2SO4 to the dichloromethane layer prior to distillation 2.…

A: In liquid-liquid extraction, separation of compounds takes place on the basis of their relative…

Q: 1. Why is it necessary to use a buret for measuring standard AgNO3 solution in volhard method? 2.…

A: Since you have asked multiple questions we will answer the first three for you. To get the remaining…

Q: The substance to be analyzed – is white, highly soluble in water salt. Flame coloration test gives…

A: Salt can be identify from different analytical method

Q: Why is the coupling reaction of the p-nitrodiazonium salt and reaction forming piodonitrobenzene…

A: Conversion of a primary aromatic amine into the corresponding diazonium salt of the amine using…

Q: What is the chemical composition of the nitrating mixture?

A: Answer :- Nitrating mixture is mixture of concentrated nitric acid and concentrated sulphuric acid…

Q: Account for the greater amount of internal pressure in the aspirin extraction versus the ß- naphthol…

A: Given solution contain napthalene, B- naphthol and aspirin. Napthalene is a hydrocarbon and it's…

Q: Using chemical structures, illustrate the differences in weak intermolecular interactions that would…

Q: why acetic acid used as solvent in analysis of riboflavin instead of deionized water? explain

A: Interpretation- To tell about why acetic acid is used as solvent in analysis of riboflavin instead…

Q: Consider the extraction scheme below. HO 0: dissolved in DCM extract with 10% NAOH H2O layer organic…

A: Solution: To seperate organic mixture the commonly used method is acid-base extraction method. We…

Q: After a crude product is dissolved in 1.5 mL of hot solvent, the resulting solution is dark brown.…

A: Activated charcoal can be extracted colored impurities from the solution. But the quantity to be…

Q: Describe briefly on each of the following sample preparation protocols: 1. Dissolve/filtration 2.…

A: Hi, as you have posted multiple subparts in a single question and have not mentioned which subparts…

Q: GUIDE QUESTIONS 1. What type of precipitate is BaSO4? 2. Why is a filter paper preferred over a…

A: As per our guidelines only three questions can be answered . Kindly post the remaining questions…

Q: Which of the following doesnt involve chemical reactions? a.Vanillin-Sulfuric Acid Spray…

A: We have to tell among the given options which one doesnt involve chemical reactions. The given…

Q: look for at least three extraction methods for perfumery materials.

A: There are several methods which are used for extraction of the perfumery materials from different…

Q: Discuss the significance of the following processes and what constituent is being determined: a.…

A: The significance of the processes and presences of constituent is given below.

Q: . Sodium thiosulfate is identified by reaction with? A) Hydrochloric acid B) 8-hydroxyquinoline С)…

Q: What would be the result if copper (I) chloride were added to the diazonium salt prepared in the…

A: Given: Copper (I) chloride is added to the diazonium salt.

Q: The presence of a stabilizer of sodium benzoate in a medicinal product, a 3% hydrogen peroxide…

A: A) is correct option

Q: What is the melting point of Penguinone and how is it extracted?

A: Please find your solution below : Penguinone is an organic compound. Its IUPAC name is…

Q: Determination of the impurity of peroxide compounds in medical ether is carried out using a reagent:…

A: Impurity of peroxide compounds in ether can be determine by using a reagent Potassium iodide.

Q: Illustrate the chemical reaction on the use of sodium bicarbonate in the purification of isoamyl…

A: Isoamyl acetate (or isopentyl acetate) is prepared by Fischer esterification of acetic acid…

Q: Describe the difference between an oil-in-water and a water-in-oil emulsion, and explain the use of…

A: An emulsion is formed by combining two liquids which don't mix in to each other.

Q: What adsorbents can be used to remove impurities from benzoic acid? Explain the molecular basis for…

A: Benzoic acid is an organic compound. Therefore, the impurities that remain dissolved in benzoic acid…

Q: 田 TI Look up the expected melting point for the recovered acetanilide. Saved Normal BIIU X2 X| fxl 三…

Q: The reaction for the magnesium cation with 8-hydroxyquinoline is carried out in the presence of: A)…

Q: Propose a suitable process flow sheet in accordance with the required equipment (such as smelter,…

A: Solution: We know nylon 6 is prepared from caprolactam by ring opening reaction. Therefore, it is…

Q: What is the appropriate solvent that would be used to recrystallize cis bis(glycinato)…

A: Crystallization is the process in which a solution of liquid is converted into solid crystalline…

Q: Why does the eugenol move from the water layer to the dichloromethane layer during extraction?

A: In separation process, aqueous and organic layer gets separated.

Q: If you were given a soil sample to analyze for its levels of herbicide, 2,4-D, escribe how you would…

A: 2 4 dichlorophenoxyacetic acid , is a herbicide that's a serious threat to environment.

Q: lodine (I2) is a solid at room temperature. Which solvent below would be best in preparation of an…

A: Given: I2 molecule.

Q: Explain and describe iodination of benzene using cupric chloride

A: when iodine react with cupric chloride ,iodine cation form which then reacts with benzene to form…

Q: Why is the refluxing time required for the synthesis of methyl salicylate is quite long?

A: Methyl salicylate is prepared using the following reaction:

Q: Why is distillation of cyclohexanol using acid catalyst phosphoric acid a better technique to purofy…

A: The reaction of cyclohexanol using acid catalyst phosphoric acid is directed in a distillation…

Q: What is Chemical form and structure of phenazopyrdine? And common salts? specify the ionisable…

A: Phenazopyridine is a drug that is used as local anaesthetic. It is also used in urinary tract…

Q: Why is it so important to use only dry glassware and solvents when you hope to perform a…

A: Solution (a) when we proceed any reaction we must have to ensure that reactant must have no impurity…

Q: For what purpose is ChloridePolyvinyl Chloride used?

A: Polyvinyl chloride is a plastic polymer. Its basic unit is = [CH2-CH2]n

Q: Explain how the reaction between 1,10-decanediocdiacid chloride in hexane solution and…

A: The mixture of two immiscible liquids forms a layer between two liquids which is known as the…

Q: Is it possible to prepare a 17% dye solution from a 4% stock dye solution? Explain your answer.

A: Given : Stock solution with concentration = 4 % (Assuming by mass) And concentration of solution to…

Q: Consider the mordant dyes and alizarin red S results, specifically focusing on the use of copper…

A: The substance mordant dye can be described as the dyes that will be utilized for the dyeing of the…

Q: Why does the nylon form at the interface of sebacoyl chloride and hexamethylene diamine?

A: We have to discuss the reason as to why nylon is formed at the interface of sebacoyl chloride and…

Question

The authenticity of sodium nitrite and the presence of impurities of nitrites and nitrates in purified water are determined with?
A) 8-hydroxyquinoline
B) Potassium dichromate in diluted sulfuric acid
C) Excess silver nitrate solution
D) Antipyrine
E) Diphenylamine

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

How to prepare the following given a free choice of normal laboratory reagents or any equipment: (a) a single crystal rod of very high purity, GaAs (b) a single crystal wire of Zr (c) sapphire crystal
The presence of a stabilizer of sodium benzoate in a medicinal product, a 3% hydrogen peroxide solution, is proved by reactions by formation: A) White precipitate with hydrochloric acid B) Discoloration of potassium permanganate solution B) Yellow staining with a solution of potassium iodide D) Blue staining with a solution of potassium dichromate in a mixture of sulfuric acid and ether E) Solid sediment with iron (III) chloride solution
1. Research on and discuss the basic properties and uses of MIC (methyl isocyanate). What type/s of precautions should be taken when working, dealing and storing MIC?
Acidified potassium bromate(V), KBrO3, reacts with hydrogen sulfide, H2S, to give a yellow solid and an orange solution. On shaking the solution with trichloroethane, the trichloroethane layer turned orange-red. (a) Suggest the identity of yellow solid and the orange solution. Describe the type of reaction taking place. (b) Construct a balanced equation for the reaction between KBrO3 and H2S. (C) BrO3- is the conjugate base of HBrO3. Draw the dot and cross structure of HBrO3. (d) HBr is a stronger acid than HCl. However, HBrO3 is a weaker acid than HCIO3. Explain the difference in acidities.
(i) Write the composition of bleaching powder.(ii) What happens when NaCl is heated with conc. H2SO4 in the presenceof MnO2. Write the chemical equation.
this experiment is all about the synthesis of phthaleins, where phthalic anhydride is added to a 0.1 gram of phenol crystal and 2 drops of sulfuric acid. this was heated and and mixed. the product was added into two different test tubes (a) Test tube containing diluted hydrochloric acid (b) Test tube containing diluted NaOH for the result (a) colorless liquid was observed (b) a pink solution was observed QUESTION: what does the result implies? explain your answer
1) Describe the color and appearance changed you observed when you dissolved NiSO4 · 6H2O in distilled water and then added NH3 solution. 2) Describe the color and appearance changes you observed when you dissolved Ni(NH3)nCl2 in distilled water and then added NH3 solution. 3) Suggest an explanation for the changes you described in 1 and 2.
Write the principle behind the following methods of refining :(i) Hydraulic washing(ii) Vapour phase refining
The substance to be analyzed – is white, highly soluble in water salt. Reaction with NaOH gives white precipitate, soluble in reagent surplus. When interacting with dithizone – changing of color of organic layer to red is observed. Addition of iron (III) chloride leads to changing of solution's color to reddish-brown. What kind of substance is this? Zn(CH;COO), NaBr Al(NO3)3 MgCl2 KSCN
1.) A 0.1278-g sample of primary standard Na2C2O4 required exactly 60.04 mL of permanganate solution to reach the end point. What is the molarity of the KMnO4 reagent? 2.) A 50.00 mL sample containing La3+ was added with sodium oxalate to precipitate La2(C2O4)3, which was washed, dissolved in dilute H2SO4, and titrated with 18.09 mL of the standard KMnO4 solution (in #1). Calculate the molarity of La3+ in the unknown sample.
what is the solubility of phenazopyridine hydrochloride in the basic and acidic medium? with illustration, and chemical structure and its melting point .
The method of assay for sulfonamides is? Kjeldahl method Diazotization method Gravimetric analysis Titrimetric analysis Volumetric analysis