The center of mass of a uniform wire, bent in the shape shown above,is located at:2LLL(0,0)LO (1.5L, 0.5L)(1.2L, 0.4L)O (L, 0.4L)(0.5L, 0.5L)O (L, 0.5L)

Centre of mass is a point where the whole mass of the body is appeared to be concentrated. The x…

Answered: The center of mass of a uniform wire,…

The center of mass of a uniform wire, bent in the shape shown above, is located at: 2L L (0,0) L O (1.5L, 0.5L) (1.2L, 0.4L) (L, 0.4L) (0.5L, 0.5L) (L, 0.5L)

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter15: Fluids

Section: Chapter Questions

Problem 7PQ

See similar textbooks

Similar questions

Find the center of mass of a laminate bounded by y=−x,y=x,y=2 with variable density modeled by \rho (x,y)=y+5. Question 3 Answer a. (0,2619) b. (35,94) c. (−23,116) d. None of the above e. (0,1) f. (0,32)
Portable (notebook) computers and digital cameras can have their housing made of magnesium. Why?
Modern commercial airliners are largely made of aluminum, a light and strong metal. But the fact that aluminum is cheap enough that airplanes can be made out of it is a bit of historical luck. Before the discovery of the Hall-Héroult process in 1886, aluminum was as rare and expensive as gold. What would happen if airplanes had to be made of steel? The fuselage of the Embraer E170, which can carry 78 passengers, is approximately a hollow aluminum cylinder without ends, 30.0 m long, 2.5 m wide, and 2.5 mm thick (see sketch at right). The fuselage of an airplane Suppose this fuselage was made of steel (density 7.87 g/cm") instead of aluminum (density 2.70 g/cm"), and let's say the average passenger has a mass of 82 kg. We'll also assume the engines can't lift any greater mass than they already do. Calculate the number of passengers that the Embraer E170 could carry if its fuselage was made of steel.
Graphite consists of planes of carbon atoms. Between atoms in the planes there are only weak forces. What kind of elastic properties do you expect from graphite?
Modern commercial airliners are largely made of aluminum, a light and strong metal. But the fact that aluminum is cheap enough that airplanes can be made out of it is a bit of historical luck. Before the discovery of the Hall-Héroult process in 1886, aluminum was as rare and expensive as gold. What would happen if airplanes had to be made of steel? The fuselage of the Embraer E170, which can carry 78 passengers, is approximately a hollow aluminum cylinder without ends, 30.0m long, 2.5m wide, and 2.5mm thick. Suppose this fuselage was made of steel (density 7.87 g/cm³ instead of aluminum (density 2.70 g/cm³), and let's say the average passenger has a mass of 79kg. We'll also assume the engines can't lift any greater mass than they already do. Calculate the number of passengers that the Embraer E170 could carry if its fuselage was made of steel.
Which of these has maximum torque? The angle between the applied force and moment arm is 30 degrees The force and the moment arm are perpendicular The force applied directed on the pivot point O The force and the moment arm are parallel input force is used to exert a large output force by making the area of the output piston larger than the area of the input piston. O Zero O Wide O Large O Small
A fisherman catches a fish and wishes to weigh it, but does not have access to a scale. He attaches a rope to the center of a 100 cm long stick. To each end, he ties his m = 2 kg tackle box and a M = 6 kg cooler. The fish balances the stick when it is attached 30 cm from the tackle box. What is the mass of the fish?
Two blocks collide. Immediately before the collision, the 2kg block A slides right at 3m/s, and the 4kg block B slides left at 5m/s. Immediately after the collision, block A slides left at 6m/s. A little glue is placed on the sides of the blocks so that they remain glued together after the collision. Determine the velocity modulus and orientation of the blocks immediately after the collision, and the percentage of kinetic energy lost during the collision. Sketch the situation.
You have been warned to set up a ladder with its base about 1/4 of its length from the wall. However, since there are some things stored next to the wall you decide to ignore the advice and set the base of the ladder out half its length from the wall instead. The ladder is sitting on slippery old snow but It still feels safe when you start up to clear your gutters after a week of storms. After you climb on you have added your weight to the ladder. Which of these is a likely result? You go about halfway up, the bottom starts to slip away from the wall as you lean forward to hold on, the ladder rotates faster and falls down completely. You go up one rung and the base slips away from the wall. Nothing happens. It cannot slip once you are on it because your weight increases the friction. It slips a little when you first get on, so a friend adds weight to the base. Once you are near the top it is very stable and cannot slip.
A metal square has a portion cut out of one of its sides the portion that was cut was a congruent triangle when the remainder of the metal piece is suspended by any position of the head p the metal piece remains balanced what is the height of the triangle
A uniform rod, 110 cm in length, is pivoted at the 40 cm mark. It is balanced when a 100 gram masspiece is hung at the 0 cm mark. Calculate the mass of the rod.
A bridge, which made of carbon-steel, is expected to subject to 100 tons. Explain how you could decide that the bridge will either deform elasticity, just deform plasticity, or or it will fracture.