The circuit below is an AC circuit and is in steady state. The three independent sources all have = 10 rad/s. You measure the waveform ia(t) = A₁ cos(10t + B₁). Now the circuit is changed: the inductor L is replaced by capacitor C. In this changed circuit, what will be the reading of the ideal volt- meter? red V-meter black ia L +1 answer R₁ R₂ √340 www R₂ R4 R1: 20 R2: 20 R3: 30 R4: 20 A1: 10 A B1: L: C: 60 degrees 300 mH 40 mF

The circuit below is an AC circuit and is in steady state. The three independent sources all have = 10 rad/s. You measure the waveform ia(t) = A₁ cos(10t + B₁). Now the circuit is changed: the inductor L is replaced by capacitor C. In this changed circuit, what will be the reading of the ideal volt- meter? red V-meter black ia L +1 answer R₁ R₂ √340 www R₂ R4 R1: 20 R2: 20 R3: 30 R4: 20 A1: 10 A B1: L: C: 60 degrees 300 mH 40 mF

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

The inductive reactance (XL). be affected by the harmonics of non-sinusoidal .wave all-of-them O could O cannot O will O
The rms value of the resultant current in a wire carries a dc current of 10 A and a sinusoidal alternating current of peak of value 20 A is-
A voltage wave of 250 kHz has a Vmax-5 V and Vmin=-35 V. The duty cycle of this wave is 0.875. This voltage waveform has been applied across a 2.5 µH inductor for a very long time so that steady state has been achieved. Diagrams of the wave parameters and circuit are shown in this figure: L What is the average voltage of this wave? Average voltage = 35 V Voltage (arb, unit) 1.25 Minimum current: -3.5€ Amps 1 0.75 0.5 0.25 0 4.25 05 Have you integrated the wave over full cycle? 4.75 4 -1.25 Vmax 0.5 Vmin What is the average current flowing through the inductor? Average current = 3.56 A 15 Period/s On average, there is no power consumed by the inductor. Have you considered this? What are the maximum and minimum currents that flow through the inductor? Maximum current: 0.50 Amps D= 25 TH TH Have you used the relationship for current and voltage in an inductor? Have you considered the slope of the current wave?
Any non-sinusoidal wave can be represented by a . . with harmonic frequencies. * ... of sine waves ..... ..... O non-of-them O add O difference sum
How do I find the phase of this sinc function?
can you please give me the comple solution for this question, thanks. A certain voltage function contains a constant term, a fundamental and third harmonic. The maximum value of the fundamental is 85 % of the constant term and the maximum value of the third harmonic is 55 % of the constant term. If the effective value of this function is 180.3V, find the magnitude of the two harmonics. A.IstHarmonic = 75 V , 3rd Harmonic = 120V B. Ist Harmonic = 80 V , 3rd Harmonic = 125V C. IstHarmonic = 120 , 3rd Harmonic = 75V D. Ist Harmonic = 125 V , 3rd Harmonic = 80V E. NOTA
Shown in the figure below is an "RC" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 11.58 Volts and is running at a frequency of f = 1.326e+04 Hz. resistor has a resistance of R = 3750 2 and the capacitor has an capacitance of C = 3.17e-09 Farads. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Write the FORMULA for the phase of the total impedance of the circuit tot = Determine the numerical value of Ztot = Determine the numerical value of Pztot= Determine the current through the circuit: • I(PEAK) = • I(RMS) = Determine the voltage across the resistor: Amps Amps S2 C degrees
Find the effective value of a sinusoidal voltage with a maximum value of 110 V.
The sinusoidal current waveform having the R.M.S value of 55 A, then the maximum value is
Describe the resulting waveforms when the capacitors (initially 20uF and then replaced with 100uF) were connected in parallel with the load
An alternating current has an rms value of 50A and a frequency of 60HZ.Find the time taken to reach 50A for the first time.
Shown in the figure below is an "RL" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 9.84 Volts and is running at a frequency of f = 8.585e+04 Hz. The resistor has a resistance of R = 2170 and the inductor has an inductance of L = 3.54e-03 Henries. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Determine the numerical value of Ztot = 2890.5 Determine the numerical value of $z= = 41 Determine the current through the circuit: • I(PEAK) = 4.81E-3 • I(RMS) = 3.404E-3 Determine the voltage across the resistor: • VR(PEAK) = 7.387 • VR(RMS) = 5.22 ✔✔ Amps ✔Amps Write the FORMULA for the phase of the total impedance of the circuit z... = | tan-1 2701 R x Volts X Volts Determine the voltage across the inductor: • VL(PEAK) = 9.184 • VL(RMS) = 6.49 ✔ Volts Volts L R²+ WL- ✔ degrees 2 If a second circuit were connected in parallel with the inductor, this circuit would be considered as: O a low-pass filter O a capacitive switcher…