The current through an element is shown in Figure 1. Determine the total charge that passes through the element at: A) t = 1s B) t = 3 s C t = 5s

Q: 19. Use nodal analysis to find vbe in the circuit of Figure 6.52. 1 sin2pi100t a 75 b HH 20 nF 82 d…

A: As per the guidelines of Bartleby we suppose to answer first question only since the remaining…

Q: For the linear, time-invariant discrete-time system given by the difference equation yn]+y[n- 2] =…

A: In this question we need to find the zero input response of the given system.

Q: 9.42 Calculate v, (t) in the circuit of Fig. 9.49. 50 (2 60 sin 2001 V Figure 30.2 www. 31 50 μF 0.1…

A: First calculate reactances of capacitance and inductance. 50 ohms resistor, 50uf capacitor is…

Q: x/ 0° V O a. -257.97 +j147.48V O b. -261.14 + j147.48V O c.-257,97 + j-4,70 V O d. -27.69 +j14.15 V…

A: Apply KCL at note connecting the inductor , capacitor and current source. Now using ohms law write…

Q: 9. If the beam width of an antenna in two orthogonal planes are 30⁰ and 60°. Then the directivity of…

A:

Q: how an induction motor starts explain with systematic diagram

A:

Q: x Z-30° A 2 Ω + Vo j4Ω 12 3V + Δ 13 -j2 Ω Question 2) Since the amplitude of the current source in…

A: We need to find the value ambient current I2 . Given X=61  Circuit:-

Q: Let v = 60 cos(200t - 10°) V. 2 ΚΩ 100 mH m ΓΚΩ 10 με ΙΚΩ

A: Supply voltage; Vs=6 cos200t-10° V Inductance value; L=100 mH Capacitance value; C=10 μF Resistance…

Q: Q₁ + 1.5ΚΩ Vcc= 2.25 V Determine the small-signal model of Q1 for the circuit above. (Is = 8 x 10-16…

A:

Q: (a) Show that minimum conductivity of a semiconductor sample occurs when no = ni√√Mp/Mn.

A:

Q: 2.641 Ω 289.665 μF 80 V 60 Hz m 6Ω 19.9 mH 221.05 με 352 10.61 mH Figure #2 a. Determine the…

A: Dear student, Since you have posted multiple questions, we will provide the solution only to the…

Q: F Consider the circuit shown above, assuming B = 75and Is = 7 x 10-16 A. If R₁ = 9.5k, determine V,…

A:

Q: VB + Ic R₁ ww KQ₁ Consider the circuit shown above, assuming ß = 75and Is = 7 × 10-16 A. If R₁ =…

A:

Q: For uncontrolled half wave rectifier, R=80ohm, L=0.15H, f=50Hz and Vm=311V. Find the point when the…

A: I have written this solution as handwritten solution. Hope you find the perfect solution.

Q: 7. In the resistive inverter below V+=2.5V, R=200k, VTN=0.6V, K₂=100μA/V² and W/L=3/1:

A: :Solution: :Given Data: V+=2.5VR=200KΩVTN=0.6vK'n=100µAV2WL=31→:DETERMINE:→find low voltage VL→Find…

Q: Use nodal analysis to find the voltage V in the circuit given below, where vs = 145 -10 V. Please…

A: In the given questions we need to calculate the node voltage V.

Q: A=7,3 â, +2,3 ây+ 3,3 â, ve B=2,6 â+ 5,2 â+ 8,5 â, ise A. B=? az if A=7,3 â+2,3 ay+ 3,3 â and B= 2,6…

A:

Q: Ка + 1.5ΚΩ Vcc= 2.25 V Determine the small-signal model of Q1 for the circuit above. (IS_ 8 x 10-16…

A: In this question We need to determine the gm  and rπ   Assume VBE on = 0.7V

Q: In the circuit shown below, Is = 8x10-17 A. Determine Vx for VA = 0, Circuit Parameters / Vcc=8.2V,…

A:

Q: Draw the root-locus graph for the closed loop system given below. Using this graph, maxi-

A:

Q: How do electrical engineers design and implement control systems for various applications, such as…

A: It is given that: How do electrical engineers design and implement control systems for various…

Q: Minimize the following boolean function- F(A, B, C, D) = Em(0, 1, 2, 5, 7, 8, 9, 10, 13, 15)

A: It is given that: FA,B,C,D=∑m0,1,2,5,7,8,9,10,13,15

Q: Which of the following is an advantage of Blu-ray over DVD technology? a. CD-R  b. Access speed c.…

A: Blu-ray technology - The Blu-ray Disc (BD), sometimes known simply as Blu-ray, is a data storage…

Q: Calculate the output current in the circuit given below, where 14io. Please report your answer so…

A:

Q: Assuming an ideal op amp, design and draw the circuits for the following. Your resistor values must…

A:

Q: Given the following circuit: Switch A has been closed for a long time Switch B has been open for a…

A:

Q: For controlled half wave rectifier, R=80ohm, f=50Hz and Vm=280V and a=0,2 rad. Calculate the average…

A: It is given that: R=80 ohmf=50 HzVm=280 Vα=0.2 rad=0.2×180π=11.46°

Q: An infinite current sheet (a zero-thickness conductor sheet carrying a uniform current) lies in the…

A:

Q: ww jwL jwC 1 jwC

A: Given Circuit: To determine: The voltage across the capacitor V

Q: Si द्व 16/ 14 460 4.7kr qu Find I & Vo oVo 4 = V

A:

Q: SP10: Reduce the following state table NS, Z into standard form. NS, Z PS A B C D E F G PO: (a b c d…

A:

Q: : The full-load power input to a 3-phase induction motor is 50 kW and the slip is 3%. Neglecting…

A: Total full load copper losses = slip× rotor input. Per phase rotor loss=total rotor loss/3. 1BHP=…

Q: Determine the minimum value of Av. 2N5459 has values of minimum gmo = 2 ms at VGS(off) = -2 V and…

A: gm0 = 2 mS    at Vgs(off) = -2 Vgm0 = 6 mS    at Vgs(off) = -8 VWe need to find the minimum value of…

Q: 110 VRMS 60 Hz Sine Wave Vin S 10:1 N1 N2 N3 BA281 1N3492 Vout R 500

A: input voltage VIN = 110 V rms (sine wave)       frequency f = 60 HZ given circuit is…

Q: 5- a. For the series resonant circuit of Fig. (10), find I, VR, VL, and VC at resonance. b. What is…

A: In this question We need to determine the all unknown parameters.  We know Current in the impedance…

Q: What is the current through the diode?

A:

Q: P₁(-10; -5; -7) ve P₂(7; 8; 2) için P₁ P₂ aşağıda verilmiştir. Buna göre K, L, M =? The vector P₁ P₂…

A: In this question it is asked to find the distance between two vectors

Q: Vx Ix IRIVER₁ + R₂ VB D₁ Ideal In the circuit above, plot Ix and IR1 as a function of Vx for two…

A: Given: A circuit,  To do: We have to plot IX and IR1 as function of Vx.  When VB= -1.5 V, When VB=…

Q: Calcule la potencia disipada por la resistencia de 8.002 en el circuito ilustrado en la figura de…

A: The circuit diagram,

Q: Determine whether any of the root of the C.E. are in the RHP s6 + 4s5 + 3s4 + 2s³ + s² + 4s + 4 = 0

A: s6 + 4s5 +3 s4 + 2s3 + s2 + 4s+4 = 0   To determine whether any of the roots of the C.E. are in the…

Q: 1 V₁ 12.6 V D₁ 2 IDEAL_DIODE R₁ 12 kn What is the current through the diode?

A:

Q: Problem # 1. 1. Find the average power (at RMS value) absorbed by the resistor and inductor. Note…

A:

Q: Q3. Deduce the transfer function E, (s)/E(s) of the circuit shown, using the impedance method. Z₁ R₂…

A: Deduce the transfer function Eo(s)/Ei(s) of the circuit shown, using the impedance method. Here, the…

Q: Determine conditions for a system being memoryless, causal and stable through its impulse response…

A: In this question we discuss the condition for a system being memoryless , causal and stable.

Q: x-30° A I₁ O a. 23.66+j35.83 A O b. 23.66 + j155.87 A O c. 156.68 +j35.83 A O d. 76.27+ j93.43 A O…

A:

Q: Problem Five If an open loop transfer function is given by the following Determine the output Y(t)…

A: We need to find out the output for given system and given input.

Q: Problem 4: Find a Fourier cosine series for f(x) = x on (0,3). Do the same for the interval (-3, 3).…

A:

Q: The charge flowing in a wire is shown in figure 2. Calculate and sketch the corresponding current.

A: The expression for the charges in terms of electron is given by; q=ne Here q is the overall charges…

Q: The rectifier above drives a 950-Ω load with a peak voltage of 3.15V. For a 100-μF smoothing…

A: RL=950Ω Peak voltage Vp=3.15 v Capacitance C=100×10-6 F VD on=0.75 volts Frequency f=50Hz We need to…

Q: For controlled half wave rectifier, R=80ohm, f=50Hz and Vm=280V and a=0,2 rad. Calculate the power…

A: We need to find out power absorbed by load .

Type of Magnetic Material

Every material has a unique composition that defines its magnetic behavior. Some materials get attracted towards a magnet and are called magnetic materials. Based on the magnetic properties held by each material, they are classified into different types.