The following traces are taken using an oscilloscope from an RC circuit with a 100 Ω resistor and a 165 nF capacitor. One trace represents the total voltage on the circuit, the other represents the voltage across the 100 Ω resistor. The oscilloscope is set at 500 mV/div on both channels and has a sweep rate of 20 μs/div. period = 60.0 us frequency = 16.7 khz 1- What is the peak voltage amplitude on the whole circuit? 159v 225v 795mv 113v 2- What is the peak voltage amplitude on the resistor? 1.38v 1.95v 689mv 974mv 3- What is the peak current amplitude in the circuit? 11.3 ma 22.5 ma 19.5 ma 9.74 ma

The following traces are taken using an oscilloscope from an RC circuit with a 100 Ω resistor and a 165 nF capacitor. One trace represents the total voltage on the circuit, the other represents the voltage across the 100 Ω resistor. The oscilloscope is set at 500 mV/div on both channels and has a sweep rate of 20 μs/div. period = 60.0 us frequency = 16.7 khz 1- What is the peak voltage amplitude on the whole circuit? 159v 225v 795mv 113v 2- What is the peak voltage amplitude on the resistor? 1.38v 1.95v 689mv 974mv 3- What is the peak current amplitude in the circuit? 11.3 ma 22.5 ma 19.5 ma 9.74 ma

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter30: Dc Motors

Section: Chapter Questions

Problem 6RQ: What is CEMF?

See similar textbooks

Related questions

Q: b) 10 (√2 d) √5 23) in the system given in the figure below, which of the following is the…

A: The root locus problem is basic problem in control system.

Q: Question No.11 Save A Report An RLC series resonance circuit has a resonance frequency of (5000/2π)…

A: Given- Resonance frequency, fo=50002π Hz Impedance at resonance, Z=56 Ω. Quality factor, Q=25 To…

Q: Learning Goal: To analyze and design a passive, first-order high-pass filter using a series RC…

Q: PROBLEM 1. Given the impulse response of a DT-LTI system h(n)= -3(0.8)"u(n) c.) Determine the…

Q: 23. Draw a Bode diagram for the following transfer functions: A. G(s) = 10(s+3) s(s+2)(s+8) 20 B.…

Q: 2. Find 1₁, 12 and 13. 20V +1 552 W 'Is 3522 M 12 1002 12-2 13 سنه > 1522 300 W $402 2012

Q: 6. Find v(t) for the circuit below. R=20052, L= 10 mH, C = 40 nF, it(t) = -12.25 mA, v(0) = OV MD= R

A: The given problem is from circuits. The detailed solution is given in the next step

Q: Q2. Simplify the Boolean expression F = (A.B)(B+ A + AA)

Q: For the following series resonant bandpass filter, find the center frequency of the pass band, the…

Q: Given the circuit below and the input voltage is 120 V, 20 Ω ΜΕ V j10 Ω 91-94) Find the input…

A: For given circuit, Vi =120 V We have to determine input current. For this, first we need to…

Q: >=0.. +12V 200 www 600 mF 20 ㅏ t=0 e^(-4t) 2H 80 ww 24V

Q: 7) Which of the following is correct for the root locus that starts when the gain value is K-0 ends…

A: We need to select the correct statement regarding root locus, when the root locus starts at k =0 and…

Q: 1- For the Controlled system shown in the following daystemy find the value b for which our…

Q: The normalized radiation intensity of a certain antenna is given by F(0) = -200² for 0 ≤ 0 ≤ where…

A: Given: The given details are, The normalized radiation intensity of a certain antenna is , Fθ=e-20θ2…

Q: The current in the RL circuit shown below reaches half its maximum value in 2.1 ms after the switch…

Q: (a) An amplitude and phase spectrum of signal a(t) up to the second harmonics are produced from a…

Q: Q5 20/0° V + 5Ω m j3 Ω 20ΩΣ -j6Ω Τ a b ZL For the circuit shown above, (a) determine the impedance…

Q: An LRC circuit is shown with an alternating source with a current given by i(t) = Icos(ot), with…

A: Given: In this question, the given details are, An LRC circuit is shown with an alternating source…

Q: On the given circuit Where are the following requirements located? a) four (4) independent loop…

A: The question is about electrical circuits.

Q: Problem-9 b A relay at rating 8 A, 2.2 sec IDMT and having a relay setting of 130% TMS = 0.6. It is…

A: Given- A relay at rating 8 A, 2.2 sec IDMT, Relay setting = 130%, TMS = 0.6, CT ratio = 400/5, Fault…

Q: a) 45 13) Find the angles of departure from the complex poles on the root locus graph for the unit…

A: The given problem is from control system. The detailed solution is given in the next step

Q: Evaluate 8/10° +62-20° 9280°-4250° O 0.50 +j2.24 O -0.50-12.24 O 50-j224 O -50-j224 and express the…

Q: es A 130 pF is connected to a voltage source such that vd) 11e-2tv, t20 and vd) = 11 V, t<0.…

A: The given problem is from circuits. The detailed solution is given in the next step

Q: Measurements on the circuit below produce the labelled voltages as indicated. Find the value of ß…

Q: Battery cells are connected in parallel to decrease the current capacity increase the voltage…

A: Given: The batteries are connected in parallel

Q: For the circuit shown, Vin is a step function that goes from 0 to VIN=1 at t=0. R=1k, C=10uF Vin 1 R…

Q: Find the break-in and out points

Q: Consider a RC network made of one resistor and one capacitor in series. Draw the charge stored in…

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: What is the total capacitance of a circuit with 3 capacitors of .6mF connected in series? a.…

A: Here we have to find the total capacitance.

Q: In the circuit shown, determine i for t > 0. 3 ΚΩ www 2 kn 6 mH 1=0 12 V 2 kn 6V SHOW YOUR DETAILED…

Q: what value must R be adjusted in the circuit below to make l: 40mA? Assume V-12V 30mA. 18 V

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: In the circuit given below, R = 100 kQ. Find the voltage vo 60 V 30 ΚΩ R The value of vo in the…

A: Given: In this question, the given details are, The given circuit is, And the given resistance…

Q: E) F) The convolution of x(t) with y(t) is commutative results in a function that does not have a…

A: E) the convolution of x(t) with y(t) is Commutative or results in a function that doesn't have a…

Q: lu (ex + ey), show ли j²v GOT) 32x2 дуг с угр джду that о

A: given mathematics problem.we have to calculate partial differential

Q: Let F = Vay, C = FTF and SR the Piola-Kirchhoff stress tensor. Define E = F-¹SR. This is known as…

A: Given: In this question, the given details are, Let F=∇αφ , C=FTF and SR the Piola-Kirchhoff stress…

Q: D) E) F) Which of the following is g lineHurwiar approximation for cos(x)? 1-x O 1+x X+2 1 Which of…

Q: 85. Within the elasic limit, elongation is proportional to the applied force. This law is ascribed…

A: Since you have posted multiple questions, we will provide the solution to the first three questions…

Q: Trade-offs in the choice of operands, seems that listed many design possibilities but have not…

A: Instruction consist of opcode and operands Many design can be possible based on operand style

Q: A) The convolution of x(t) with the impulse function, delta of t is xt) 1 the impulse function,…

A: As per our company guidelines we are supposed to answer only first question kindly repost the other…

Q: 16) How many poles does the system with the characteristic polynomial s³ +45³ +3s have in the left…

A: Characterstic Polynomial = P(s)P(s)=s5 +4s3+3sFind:- how many poles in Left half of s-plane

Q: In an oscillating LC circuit, the maximum charge on the capacitor is 4 x 101 C and the maximum…

A: Given data Maximum charge on the capacitor is, qmax=4×10-6 C Maximum current flowing through the LC…

Q: For the below CB amplifier circuit: C5 10u ww ww R1 101k R2 11.2k 12 VBE=0.63V 0 VCC ww Q1 www…

Q: and question 6?

A: Given: To find: Cross correlation sequence of x(n) and r(n).

Q: Design a modulo-13 counter (that counts from 0 to 12) from D flip-flops

A: Flip flop changes output only active edge of clock. Flip flop is edge sensitive device. D flip…

Q: A current I = 10230° flows through an impedance Z = 202-22°. Find the average power delivered to the…

A: We need to find out the power and power supplied by source for given circuit .

Q: An 8-bit ADC has a 25.00 V reference. A) Find the output for inputs of 13.1 v. B) What range of…

A: Given data, Reference voltage Vrf=25 V. Number of bits n = 8,

Q: 2. In Figure 1 using mesh/loop analysis, calculate the (a) current thru the 8-2 resistor, (b) the…

A: After substituting values of x= 2,y= 2,z= 9 in above circuit.

Q: Determine the current i, for the circuit shown in Figure below. 4 ΚΩ a www b φωτο 18 V 8 ΚΩ 4 ΚΩ 8…

Q: What is the dc output voltage of an unfiltered half-wave rectifier whose peak output voltage is 9.8…

Q: Consider the analog signal X(1) =3 cos 2000m:+5 sin 6000m +10 cos 12.000: (a) What is the Nyquist…

A: (a) The given signal is, xat=3cos2000πt+5sin6000πt+10cos12000πt The frequencies of the different…

Question

The following traces are taken using an oscilloscope from an RC circuit with a 100 Ω resistor and a 165 nF capacitor.

One trace represents the total voltage on the circuit, the other represents the voltage across the 100 Ω resistor. The oscilloscope is set at 500 mV/div on both channels and has a sweep rate of 20 μs/div.

period = 60.0 us

frequency = 16.7 khz

1- What is the peak voltage amplitude on the whole circuit?

159v

225v

795mv

113v

2- What is the peak voltage amplitude on the resistor?

1.38v

1.95v

689mv

974mv

3- What is the peak current amplitude in the circuit?

11.3 ma

22.5 ma

19.5 ma

9.74 ma

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Transmission Line Parameter and Scattering Parameter (S-parameter)

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.