The jet of water that spews out from the reservoir inti the open air hits the concrete block and is divided into two equal arms. Orifice cross section area at point 1 is A1= 150 cm^2. Neglecting friction losses, a) Find the flow rate (Q1) in section 1. b) Find the intensity of the reaction force (R) that will occur in the concrete block and its angle with the horizontal. (h=3.5 meters, pWater= 1 ton/m^3, yWater= 9.81kN/m^3, g= 9.81 m/s^2, angle a= 45 degree)

Q: tank has one of its side inclined inward at an angle of 30 degrees with horizontal. The free surface…

A: option A = 9.3 m/s

Q: Problem 3. A siphon, filled with water, is discharging that water. The discharge rate is 2.8 cfs. a)…

A: we have given

Q: ) A large pipe with a cross-sectional area of 1 m' descends 5 m and narrows to 0.5 m2, where it…

A: To solve this problem, we have used bernoulli's equation and equation of continuity, speed of the…

Q: The discharge of water over a spillway 12 m wide is 283 m/s into a stilling basin of the same width.…

A: Given: Discharge, Q = 283 m3/s ; Width, w = 12 m Solution: discharge for unit width, q = Q/w =…

Q: 6.69 Water flows steadily through the reducing elbow shown. The elbow is smooth and short, and the…

A:

Q: Water flows upward in a vertical 300-mm pipe at the rate of 0.222 m /s. At point A in the pipe, the…

A:

Q: If the diameter and length for pipel is (900mm, 1500m); pipe2 is (600mm, 900m) and pipe3 is (500mm,…

A:

Q: A 9-mm diameter jet of water is deflected by a homogeneous rectangular block (14 mm by 220 mm by 120…

A: According to the information, we have a diameter of jet that is 9 m and weighs 4 N. Flow rate can…

Q: Elevation = ? reservoir on the right at a rate of 0.45 m/s. The formula for the head losses in the…

A:

Q: A siphon is used to drain water from a tank as illustrated below. Assume steady flow without…

A: Given Height = 0.89 m To find Velocity of outflow

Q: Derive an expression for the time required to raise the water level in a tank of uniform C.S..A (A)…

A:

Q: A 9-mm diameter jet of water is deflected by a homogeneous rectangular block (14 mm by 220 mm by 120…

A: vertcal direction:-

Q: A 15-ft-diameter tank discharges water at 50 F through a 2-in.-diameter sharp edged orifice. If the…

A: orifice meter is used to measure the rate of flow through a narrow section Coeffcient for discharge…

Q: Question 2. B la0 mm diameter siphon draws water from the reservoir. Considering that the elevation…

A: givendaimeter of siphon d=10mmh1=2mh2=5.1mρwater =1000Patm=101.3kPa

Q: Question 4 Neglecting head losses, determine what horsepower the pump must deliver to produce the…

A:

Q: Q3: Find the diameter of a circular orifice to discharge (0.015m/sec) under a head of (2.4m). If the…

A:

Q: An orifice having an area of 0.0003 m² is located on the vertical side of a tank. The tank has a…

A: Write the given data with suitable variables. Ao=0.0003 m2At=0.4 m2h=1.2 mh1=0.6 mt1=312 st2=240 s

Q: The flow is opened to the atmosphere at point 2 and 3. Find the magnitude and the direction of the…

A:

Q: 3. Assume there is friction head loss in the siphon as shown in the Fig. 2.1, where a = 1 m, b = 4…

A:

Q: Find the cross sectional area of pipe if discharge through pipe is 333 m3/s and having flow velocity…

A: Given data : Discharge Q=333 m3/s Flow velocity V=50 m/s   Required : Cross sectional area

Q: The scoops of the Pelton turbine deflect the water jet by 25°. Geometric head 500m, absolute…

A: Turbines are hydraulic machines which converts hydraulic energy into mechanical energy. In pelton…

Q: The machine C shown in Fig. (3) Is it turbine or pump? What is the water power (kilowatt) associated…

A: Given data, Rate of discharge, Q = 200 lps Q = 0.2 m3/s Pressure at A, PA = 206 KN/m2 = 206 x103 Pa…

Q: Q5 choose A or B only: (Q5-A) The circular stream of water from a faucet is observed to taper from…

A: From the above figure we can say that Q=A1V1=A2V2

Q: Water flows through a rectangular duct of height h = 575.5 mm and width b = 100 mm. (coming off…

A: Given: U = 58 m/s Vmax = 2Vmin Find: Vmin = ?

Q: A 60 mm diameter Orifice is discharging water under a head of 9 meters. Calculate the actual…

A: Given Data: d0=60 mm=0.06 mh=9 m,  Cd=0.625Cv or Cc=0.98a0=π4d12=π4×0.062=2.827×10-3 m2

Q: QI A stream line of water out from orifice at y=0.6 from the bottom of a big tank and open the…

A: Given data, x = 1.5 m y = 0.6 m H = 1.5 m A = 650 mm2 Actual discharge, Qact = 0.117 m3/min =…

Q: The tube has a diameter of 0.4m, suddenly expanding to a diameter of 0.8m, and the flow rate is 0.4…

A:

Q: Please find the question attached.

A: Given data as per question Conical flask height = 36.8 mm Flask diameter = 29.4 mm Rounded hole…

Q: The jet of water of a pelton wheel is 80mm diameter. The jet strike's the bucket on the tangential…

A: We have given The jet of water of a pelton wheel is 80mm diameter. The jet strike's the bucket on…

Q: Given data : Flow velocity=2 m/s Cross sectional area of channel=D3 m2 Find discharge

A: Given data : Flow velocity=V Cross sectional area of channel=A   Required : Discharge

Q: Problem 1 Water flows through a small opening located at depth h in a large reservoir. Find water…

A: The given problem is an application of Bernoulli's equation.

Q: A ventunmeter having throat diameter 5.3 cm is provided on a pipe of 10 cm diameter. If oil of…

A: Given that, Throat diameter, d2=5.3 cm=0.053 m Pipe diameter, d1=10 cm=0.1 m Specific gravity of…

Q: Assume di = 1.5 cm, d2 = 2 cm, z = 8.5 m, and h = 3.5 m. Determine the level of the %3D tip of the…

A:

Q: The water jet exiting from a stationary tank through a circular opening of diameter 300 mm impinges…

A: The velocity of water jet can be determined as,

Q: A fire hose discharges water through a nozzle having a diameter of 2.5cm. The head lost in the…

A: Given data as per question Diameter of the nozzle =2.5 cm Head loss =4% Gauge pressure of the nozzle…

Q: diameter, branches into two pipes B and C. Pipe B is 15 cm in diameter and pipe

A:

Q: A lawn sprinkler can be used as a simple turbine. As shownin Fig. , flow enters normal to the paper…

A: The velocity diagram for the turbine is as follows: Here,Vrel is velocity of flow when leaving the…

Q: Water flows upward in a vertical 300-mm pipe at the rate of 0.222 m /s. At point A in the pipe the…

A:

Q: A summer camp is located near a 16.7 m waterfall. Tests show that the stream delivers a minimum of…

A:

Q: In this system, d = 6 in., D = 12 in., A-1 = 6 ft, and A=2 = 12 ft. The discharge of water in the…

A:

Q: Find the diameter of a circular orifice to discharge (0.015m '/ sec) under a head of (2.4m). If the…

A: Discharge through orifice=0.015 m3/s Head available, H=2.4 m Coefficient of discharge(C d) =0.6

Q: Problem 4 Show that the quantity of water flowing across a triangular V-notch of angle 20 is Q =…

A:

Q: The machine C shown in Fig. (3) Is it turbine or pump? What is the water power (kilowatt) associated…

A:

Q: From a very large tank with an absolute pressure of 3 bar, the water is discharged to the atmosphere…

A:

Q: a) Two pipes have a length ? each. One of them has a diameter D, and the other a diameter d.if the…

A: As per Bartleby's policy in case of multiple questions I can solve only first one. Please repost…

Q: Water flows from a large, pressurized tank through a 6 in diameter pipe and rises 20 ft above the…

A:

Q: H.W.: In the figure shown, the flow rate is 0.05 m/s, determine: (a) pressure at A and B, (b) the…

A:

Q: A 50 mm diameter siphon discharges oil (SG=0.88) from a reservoir (elev. 20m) into open air (elev.…

A:

Fluid Dynamics

The study of the flow of gases and liquids, usually in and around solid surfaces, is known as fluid dynamics in physics and engineering. Fluid dynamics, for example, can be used to evaluate the movement of air through an airplane wing or the surface of a vehicle. It can also be used in ship design to increase the speed at which ships pass through water.