The only instrument among the followings that is normally not connected to the aircraft electrical systems, since it can determine the magnetic north on its own. DME GPS Magnetic compass VOR ILS TCAS

Q: thin rectangular plate is uniformly deformed as shown below. Compute the  shearing strain at P…

A: Solution is attached below:

Q: a) the slope of the beam at C (positive if counterclockwise and negative if clockwise). (b) the…

A:

Q: A continuous gravity decanter is used to separate two immiscible liquids, oil (SG = 0.76) and water.…

A: Given information A continuous gravity decanter is used to separate two immiscible liquids. oil (SG…

Q: A pump rated at 700W is used to transfer water from an open tank at ground level, to another open…

A:

Q: Determine the polar radius of gyration of the shaded area about point O. 0.47a Answer: ko = i a

A:

Q: 1. A two dimensional supersonic airfoil has the cross-section shown below (base: 2.8 m, base angles…

A: Given   Mach number, M = 2.4             Pressure, P = 25 kPa                  Base, w = 2.8 m…

Q: Calculate the mass flow rate of air through the compressor.

A: Given Data The initial temperature is:Ti=20°C The volume flow rate is:V˙=120litres/minute=120×10-3…

Q: A liter of water weighs 9 N. Compute it mass in kilograms (UP TO THREE DECIMAL PLACES

A: Given W=9N

Q: Blocks A and B weighs 1800 N and 900 N respectively. Coefficient of friction under each block is…

A: Consider the FBD for the block A.

Q: SHAPER MACHINES Shaper operation Types of shaper Principal parts of a shaper

A: Shaper Machine:- Shaping is a machining operation for generating flat surface by means of single…

Q: 2. An engine operating on the air standard heat engine has a compression ratio of 18. If the maximum…

A:

Q: Before entering the engine of a BMW320D, air drawn in at 20°C and atmospheric pressure enters the…

A: Given Data The initial temperature is:Ti=20°C The volume flow rate is:V˙=120litres/minute=120×10-3…

Q: Water flows from a pressurized tank (at 150 kPa gauge) to an open tank 15m above. What is the…

A:

Q: A centrifugal pump, located above an open water tank, is used to draw water using a suction pipe (8…

A:

Q: A belt conveyor is required to deliver crushed limestone having a bulk density of 50 lb/ft3 at the…

A:

Q: 10N A(2.3, 5) B(3,1.-2) D(-4, -2,0) C(4,0, 10) In the above, B, C, D are fixed and their coordinates…

A:

Q: determine the entr0py change 0f 1.5 moIes 0f amm0nia that is heated fr0m 180°Cto750°C. The system…

A: Given,  Mole of ammonia is 1.5. And initial state and final state Find, Entropy change of process

Q: Show your steps and label units on all answers. 1.) Determine the Forces in all the members, and the…

A:

Q: Compute for the desired degrees to set in the compound rest to taper a plum bob with 4.8 large…

A: Large diameter, D= 4.8 Length of the taper, L= 9.6 Small diameter is not given. Hence, take small…

Q: 2. 0.05 kg of steam at 1.5 MPa is contained in a rigid vessel of volume of 0.0076 m³. A. What is the…

A:

Q: •5-53. The 20-mm-diameter A-36 steel shaft is subjected to the torques shown. Determine the angle of…

A: Given            Diameter, d = 20 mm For A 36 steel  Shear modulus, G = 75 GPa Find   Angle of twist…

Q: 1. An engine operating on the air standard heat engine has 13 KJ heat added at isochoric process,…

A: given; heat added at isobaric pressure (Q)=13KJheat ratio(k)=1.35initial…

Q: 9-67. Determine the principal stress, the maximum in-plane shear stress, and average normal stress.…

A:

Q: Determine the following: What is Rainfall-Run off Relation? Definition of hydrograph What is…

A: given; What is Rainfall-Run off Relation?Definition of hydrograph What is Hydrograph separation

Q: You are trying to design a vibration absorber such that its maximum amount of movement is r2.max =…

A:

Q: For the beam and loading shown, use the double-integration method to determine (a) the equation of…

A:

Q: Steam at 5.2 MPa, 4000C expands in a Rankine turbine to 0.036MPa.  (a) For 136 kg/s of steam,…

A: Given: The steam pressure at turbine inlet, P1 = 5.2 MPa The steam temperature at turbine inlet, T1…

Q: hydroelectric power generating system is shown in the figure. Water flows from an upper reservoir to…

A: Given:Discharge, Q=286 L/sQ=0.286 m3/sPipe length, L=186 mPipe diameter, d=346 mm or 0.346 mHazen…

Q: A railroad tie (or sleeper) is subjected to two rail loads, each of magnitude P = 165 kN, acting as…

A:

Q: Consider the heat equation dtu = əx2u with solutions defined on 0 s x s 1 and boundary conditions…

A:

Q: What is the benefit of the jet extrusion impact experiment

A: Impact extrusion is a manufacturing method that uses a metal slug to create items comparable to…

Q: Water is flowing is to be pumpel for 1000 m alory 50 mm intonal odameku pipe. at the rcete of 3:0kg…

A:

Q: 5 ft3 /s oT air is conmpressed in an adiabatic compressor from an initial state of 14.7 psi and 60…

A:

Q: Please answer the exact problem. Thank you An adiabatic steam turbine operates with a superheated…

A:

Q: . What is the net head?

A: To find Net head

Q: General Shear Formula For Problems 8-1 through 8–20, compute the shearing stress at the horizontal…

A: Given data as per the question  V =850 lb Calculations We know…

Q: 3. A force P is applied to the rigid lever arm ABC as shown. The arm rotates counterclockwise about…

A: An axially loaded bar undergoes change in length, becoming longer when in tension and shorter when…

Q: These instruments determine the distance to an airport where the ground station is installed. VOR…

A: Instruments determine the distance to a n airport where the ground station is installed? Instruments…

Q: Determine the entropy change of 1.5 moles of ammonia that is heated from 180°C to 750°C. The system…

A:

Q: A liquid food (p = 900 kg/m³, µ= 2 cP) flows from a 15 m long pipe of 3-in. diameter to a 25 m long…

A: Given data Density of liquid = 900 kg/m3Viscosity = 2 cP = 0.002 Ns/m2Length of pipe 1 = 15…

Q: In simple and clear explanation. What is polygeneration system in refrigeration systems?

A: The polygeneration system is used in refrigeration for more efficient cooling . There is no specific…

Q: The allowable stresses for the splice shown are the following: 150 MPa for shear of rivets, 1.35Fy…

A: Given Dataσs=150MPaFy=250MPat=20mmw=300mmσt=0.6Fy=150MPa

Q: Q3: For Fig.3, determine the tension in cable ABD and the reaction at suppor C 125 mm 175 mm -225 mm…

A:

Q: A helical spring is in contact with a 600 mm long steel leaf spring as shown in the figure below.…

A:

Q: The compression ratio in an air-standard Otto cycle is 10. At the beginning of the compression…

A:

Q: In a large student house in Sheffield, cold water is supplied by the mains water supply at a…

A:

Q: Home work 2 Locate the centroid of the plate area shown in 2 ft 1ft 1 ft 2-14

A:

Q: An annulus has an inner diameter of 100mm and an inner diameteief 250mm. Determine its hydraulic…

A: Given: Inner diameter, Di= 100 mm Outer diameter, Do= 250 mm   To find: Hydraulic radius

Q: Solve for the exit velocity.

A: Solve for the exit velocity.

Q: Calculate the velocity of the fluid at point 2 as it flows through the tube. 9 m 5 m Water Select…

A:

Conduction and Convection

When energy travels from one object to another it is said to have undergone heat transfer. Heat transfer is nothing but the transfer of thermal energy or internal energy from one thing to another, like e.g., when a vessel with water, kept on top of a burner, heats up because of the flame underneath it.