The wavelength of maximum absorbance for crystal violet is 595 nm. A solution absorbing light of this wavelength is expected to be what color? The color wheel below shows how the wavelength of visible light corresponds to color. red 640-700 nm violet 400-450 nm a) purple b) green c) red orange 600-640 nm d) yellow e) orange yellow 560-600 nm green 450-560 nm

The wavelength of maximum absorbance for crystal violet is 595 nm. A solution absorbing light of this wavelength is expected to be what color? The color wheel below shows how the wavelength of visible light corresponds to color. red 640-700 nm violet 400-450 nm a) purple b) green c) red orange 600-640 nm d) yellow e) orange yellow 560-600 nm green 450-560 nm

Chemistry & Chemical Reactivity

9th Edition

ISBN:9781133949640

Author:John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Publisher:John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Chapter4: Stoichiometry: Quantitative Information About Chemical Reactions

Section4.8: Stoichiometry Of Reactions In Aqueous Solution-titrations

Problem 2RC

See similar textbooks

Similar questions

What procedures are utilized in optical analysis to determine a solution's concentration based on colorimeter absorbance measurements?
A solution has a %T value of 48.2% at 600 nm. What is the absorbance of this solution at this wavelength?
If a solution has an absorbance value of 0.518 at a wavelength of 460 nm, what is the percent transmittance of this solution at this wavelength?
2. Calculate the absorbance value (A) for a solution that absorbs 68.5% of the light striking it. (Hint: What is the percent transmittance?)
2. You add 10.00 ml of a 0.630 M methyl red solution to a 100.00 ml volumetric flask. You then add small volumes of sodium acetate and acetic acid solutions to adjust the pH, and then fill the 100 mL volumetric flask to the mark with deionized water. You then make a spectroscopic measurement and obtain absorbance values of 0.253 at 520 nm and 0.079 at 420 nm. What is the concentration of [HIn] in the solution. Remember to use M;V1 = M2V2 as the first step in the calculation process. Hint: see eq. 6 in the lab manual A$20, = 0.367 A520, = 0.010 A420, - 0.012 A420, = 0.275 O 4.30 x 102 O 0.430 O 4.18 x 102 O 0.418
5) Given the absorbance spectrum shown below, what wavelength of light would you use for nickel(II) ion? Explain your answer. Absorbance 0.8 0.6 0.4 1 0.2 0 350 400 Absorbance vs. Wavelength for Nickel(II) ion 450 500 550 600 650 Wavelength (nm) 700 750 800 850
A solution of copper(II) sulfate is observed to be blue in color. The maximum absorbance is expected to occur in what wavelength range? 500-560 nm (green) 380-435 nm (violet) 610-750 nm (red) 580-595 nm (yellow) 435-480 nm (blue)
Solutions that contain the FeSCN2+ ion are blood red (you will see this at the end of the second quarter of lab). Consider the regions of the visible spectrum in which the compound should absorb light and prepare a rough sketch of absorbance vs. wavelength for each solution. Label λ max on the graph. (Is this question asking for the graph of my data at the end)
2. Discuss the different factors that affect the absorbance of a solution.
2. Calculate the absorbance value (A) for a solution that absorbs 89.5% of the light striking it. (Hint: What is the percent transmittance? Review the background reading)
1. What color does sunlight appear to the naked eye without passing through a prism, diffraction grating. or spectrometer?
If the absorbance of the sample is1.00 at a specific wavelength, what is the percentage amount of light that is absorbed by the sample and what is the percentage amount of light that istransmitted? The absorbance of a Co++ solutioncontaining 1 mg Co2+/mL was reported as 0.500 at 732 nm. What willbe the absorbance if the solution is diluted to twice its original volume?