Use nodal method to find the branch currents l1, l2, 13, l4 and Is in the network shown below.

Q: Calculate Ij and I2 in the two-port of 2Ω I I, Z11 = 6 Q Z12 = -j4 Q Z21 =-j4 2 Z22 = 8 Q 2/30° V V…

A: This question belongs to circuit theory . It is based on the concept of z parameters in two port…

Q: 10. What are the range of values for IL(Load Current) for the given circuit below? 1ka 21 25V RL 12V

A: Here the properties of zener diode has been used. The zener voltage mentioned here is 12v. The load…

Q: For the following BJT amplifier circuit whose V, = 40 mV, Rsource = 1.2 k2, A,NL = 320, and V, =…

A: We need to find out input current for given circuit

Q: bias of the first stage sets the dc bias of the second. Determine all de voltages for both stages…

A:

Q: What is the colour of neutral conductor in single -phase a.c. supply, O a. Orange O b. Red c. Black…

A: Given: In the question, the color of neutral conductor in single phase ac supply is asking.

Q: 1) Express point P(-2, 6, 3) in cylindrical and spherical coordinates. 2) Express vector A = 2.467a,…

A:

Q: How does the output voltage vary when the capacitance is doubled in integrator operational amplifier…

A: In this question, we will write about output voltage variation with capacitance In integrator…

Q: 2) Given Q1 = 0.35µC at (0, 4, 0) m and Q2 = 0.55µC at (3, 0, 0) m, a) Find E at (0, 0, 5). b)…

A:

Q: The AC motor M of figure shown in the next slide has 2300 Volts, balanced three phase voltage…

A: Power factor: It tells how much active power is utilized by the circuit from the apparent power.

Q: Sketch the final waveform of below circuit. * V1 D2 9V R1 25V

A:

Q: Consider a cell having nominal voltage 3.8V and total charge capacity Q = 25 Ah. If the BMS is…

A: Given,Vnom=3.8VQ=25AhTotal energy of the cell=VnomQTotal energy of the cell=3.8×25Wh…

Q: Q1)A 3 phase induction motor is wound for 6 poles and is supplied from 50-Hz system. Calculate 1.…

A:

Q: IBQ, ICQ, VE, VCEQ, VCfor a transistor with VBE= 0.6 and β = 50.​ Draw and label the DC load-line.​…

A: We need to find out current and voltage for given circuit

Q: An open–wire transmission line is made from two wires, each with a diameter of 2.5 mm, located 16 mm…

A: In this question we will write effect on characteristic impedance of open wire transmission line if…

Q: 4.10 Determine v3 in the circuit of Fig. 4.27. 10 Ω 20 Ω 30 V 15i1 80 V 40 Ω 30 Ω

A: This question belongs to circuit theory . It is based on the concept of kirchhoff's voltage law and…

Q: 0.5 A tone message signal given by: m(t) = 2cos(2n × (1kHz)t) is sampled using a train of pulses…

A:

Q: Q2. For the network in next Figure, determine R1: 24 2 C130 240

A:

Q: 1: Theory 1.1 Describe briefly a sinusoidal signal and ALL its properties. Give example with…

A:

Q: For the following circuit, determine the level of the input voltage in mv. Rce 600 2 Z, = 1.2 ka 10…

A: The solution is given below

Q: has both variable resistance and variable reactance. In addition, calculate the maximum power…

A:

Q: Verify the divergence theorem for the vector field F = x?i + zj + yk taken over the region bounded…

A: Divergence theorem is states that surface integral of a vector over a closed surface is equal to…

Q: Solve the given ac network below by using superposition theotem.

A: There are four sources in circuit. we have to find response by each source first. Voltage source is…

Q: 6.34. What is the conductivity of AWG #32 tungsten wire with a resistance of 0.0172 2/cm? The…

A:

Q: CMI + Cgs = (1+gm(r,l|RpL))Cgd + Cgs, so C, is clearly >> %3D Cgd. This means that fol << f» since…

A:

Q: A 2400/2200 volt auto transformer delivers a load of 90.5 Kw at a pf of 0.75. Solve for the current…

A:

Q: 1.2 ka 10 uF 10 uF Vo B = 45 VI 100 - 9 V ww

A:

Q: An industrial plant is charged a penalty if the plant power factor drops below 0.85. The equivalent…

A:

Q: Find I3 if l1=5 mA, I2=7 mA, la=6 mA and Is=8mA. Currerts In Node Is 12 Currents Out I3 I4

A: In this question we will find unknown current I3 using KCL...

Q: For the network shown, determine A,. 12 V 2.2 220 k2 B- 60 .-40 2 Z,

A:

Q: LM 117 VIN Vout VIn=28V - VOUT R2 is half as much as R1 and Vref is 2V. ADJ R1 240 Vref ladj 11 C2…

A: We will find out current and resistance value for given circuit

Q: 1KO V BE Rs 5.1V Vout 1W 12V out (b) (a) Figure 4 www

A: We need to find out voltage for given circuit

Q: A uniform line charge pe= 2 nC/m lies in the z =0 plane parallel to the x axis at y=3 m. Find the…

A: Potential difference: It is the difference between the two voltages and its unit is also volt.

Q: 3-phase slip ring motor gives a reading of 35 V across slip rings on open circuit when at candstill…

A:

Q: I2(s) Suppose N(s) = 6 steady-state value of the output current i2(t) when the input is I1(s) = .…

A:

Q: In a zener regulator circuit, find the voltage regulator percentile factor with the circuit diagram…

A:

Q: 1) Determine the input power in dBm received by an antenna with a gain of 45dB if the measured power…

A: As per the guidelines of Bartley we supposed to answer first question only since remaining question…

Q: C(s) R(s) G2 G3 G, G4 Gs G6 H1

A: We need to find transfer function for given diagram

Q: 12.11 An air-filled hollow rectangular waveguide is 150 m long and is capped at the end with a metal…

A: Please refer the attached images for the complete answer..

Q: Explain the successive approximation type ADC with neat schematic diagram.

A: Successive approximation ADC: The successive approximation Analog to Digital Converter is a type of…

Q: 1. When gre the p-n junctions of the n-channel FET blocked?

A: Note: We are authorized to answer the first question since the exact one wasn’t specified. Please…

Q: . Assuming that the following input data each can be encoded by 5 bts, including a sign bit:…

A: It is given that: xn=10, 8, 10, 12

Q: 1. A pulse is transmitted down a cable that has a velocity of propagation of 0.8c. The reflected…

A: We need to find out range and time for given details .

Q: Determine the Thevenin's and Norton's uivalent circuits at terminals a-b. 12V ミuう (2V びり: 12V + (+)

A:

Q: Q2) A d.c. shunt motor has the armature and field resistance is 0.012 and 50 Q, when the input power…

A: This question belongs to electrical machine . It is based on the concept of armature power developed…

Q: (CLO-2] A given sequential circuit made up of one positive-edge triggered J-K flip-flop. The circuit…

A:

Q: ) Determine the input power in dBm received by an antenna with a gain of 45dB if the measured power…

A: We are supposed to be answer of first question as per guidelines.

Q: Jse mesh-current analysis to find the branch currents indicated in the network show pelow. I1 )820°v…

A:

Q: A magnetic coils made up 500 turns wound around a magnetic circuit of 2.15 x 10-2 reluctance. A…

A: Given data, Magnetic coil with N=500 R=2.15×10-2I=0.32 A

Q: 3+2s² +5s+175 $3+4s²+25s+100 F(s) :

A:

Q: Two transformers with equal turns have impedances of, Unit A (0.5 +j3) ohms and Unit B (0.6 +j10…

A: This question belongs to electrical machine . It is based on the concept of load sharing by…

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.