can you answer these qustions using, true, false, greater than, less than or equal to Use the picture as a guide. P is the pressure in the pipe, and v¡ is the speed of a non-viscous|V4 is .... V5.incompressible fluid at locations i = 1,2,3,4,5.(For each statement select correctly)D-1mmD-2mm|-P4 is .... P5.P3 is .... P4.V P1 is .... P4.V4 isP1 isGreater thanTrueFalseFalse....P2.2V3.True....FalseV1 is....V1is.... V2.True

For velocity comparison:A1V1=A2V2contuinity equation:⇒V1V2=A2A1⇒V∝1A∝1r2 -(1)as A=πr2for pressure…

Use the picture as a guide. P is the pressure in the pipe, and v¡ is the speed of a non-viscous incompressible fluid at locations i = 1,2,3,4,5.(For each statement select correctly) Delmm D-2mm P4 is P3 is P1 is V V4 is P1 is V1 is P5. P4. P4. Greater than v .... True .... False False V5. P2. 2v3. .... True .... False .... E> || >|| > || >

Use the picture as a guide. P is the pressure in the pipe, and v¡ is the speed of a non-viscous incompressible fluid at locations i = 1,2,3,4,5.(For each statement select correctly) Delmm D-2mm P4 is P3 is P1 is V V4 is P1 is V1 is P5. P4. P4. Greater than v .... True .... False False V5. P2. 2v3. .... True .... False .... E> || >|| > || >

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter12: Fluid Dynamics And Its Biological And Medical Applications

Section: Chapter Questions

Problem 13PE: Water is moving at a velocity of 2.00 m/s through a hose with an internal diameter of 1.60 cm. (a)...

See similar textbooks

Similar questions

What is the greatest average speed of blood flow at 37° C in an artery of radius 2.00 mm if the flow is to remain laminar? What is the corresponding flow rate? Take the density of blood to be 1025 kg/m3.
What is the difference between flow rate and fluid velocity? How are they related?
Water is moving at a velocity of 2.00 m/s through a hose with an internal diameter of 1.60 cm. (a) What is the flow rate in liters per second? (b) The fluid velocity in this hose's nozzle is 15.0 m/s. What is the nozzle's inside diameter?
An oil gusher shoots crude oil 25.0 m into the air through a pipe with a 0.100-m diameter. Neglecting air resistance but not the resistance of the pipe, and assuming laminar flow, calculate the gauge pressure at the entrance of the 50.0-m-long vertical pipe. Take the density of the oil to be 900 kg/m3 and its viscosity to be 1.00 (N/m2) s (or 1.00 Pa s). Note that you must take into account the pressure due to the 50.0-m column of oil in the pipe.
Gasoline is piped underground from refineries to major users. The flow rate is 3.00102 m3/s (about 500 gal/ min), the viscosity of gasoline is 1.00103 (N/m2) s, and its density is 680 kg/m3. (a) What minimum diameter must the pipe have if the Reynolds number is to be less than 2000? (b) What pressure difference must be maintained along each kilometer of the pipe to maintain this flow rate?
(a) Verify that a 19.0% decrease in laminar flow through a tube is caused by a 5.00% decrease in radius, assuming that all other factors remain constant, as stated in the text. (b) What increase in flow is obtained from a 5.00% increase in radius, again assuming all other factors remain constant?
What is the pressure inside an alveolus having a radius of 2.50104 m if the surface tension of the fluid-lined wall is the same as for soapy water? You may assume the pressure is the same as that created by a spherical bubble.
Considering the magnitude of typical arterial blood pressures, why are mercury rather than water manometers used for these measurements?
A hot-air balloon consists of a basket banging beneath a large envelope filled with hot air. A topical hot-air balloon has a total mass of 545 kg. including passengers in its basket, and holds 2.55 103 m3 of hot air in its envelope. If the ambient air density is 1.25 kg/m3, determine the density of hot air inside the envelope when the balloon is neutrally buoyant. Neglect the volume of air displaced by the basket and | passengers.
(a) Using Bernoulli's equation, show that the measured fluid speed v for a pitot tube, like the one in Figure 12.7(b), is given by v=( 2gh)1/2 , where h is the height of the manometer fluid, is the density of the manometer fluid, is the density of the moving fluid, and g is the acceleration due to gravity. (Note that v is indeed proportional to the square root of h, as stated in the text.) (b) Calculate v for moving air if a mercury manometer's h is 0.200 m. Figure 12.7 Measurement of fluid speed based on Bernoulli's principle. (a) A manometer is connected to two that are close together and small enough not to disturb the flow. Tube 1 is open at the end facing the flow. A dead spot having zero speed is created there. Tube 2 has an opening on the side, and so the fluid has a speed V across the opening; thus, pressure there drops. The difference in pressure at the manometer is 12v22 , and so h is proportional to 12v22 . (b) This type of velocity measuring device is a Prandtl tube, also known as a pitot tube.
The water supply of a building is fed through a main pipe 6.00 cm in diameter. A 2.00-cm-diameter faucet tap, located 2.00 m above the main pipe, is observed to fill a 25.0-L container in 30.0 s. (a) What is the speed at which the water leaves the faucet? (b) What is the gauge pressure in the 6-cm main pipe? Assume the faucet is the only leak in the building.
How tall must a water-filled manometer be to measure blood pressures as high as 300 mm Hg?