m/sEXERCISEHINTS: GETTING STARTED I I'M STUCK!Use the values from PRACTICE IT to help you work this exercise. Suppose the spring system in the lastexample starts at x = 0 and the attached object is given a kick to the right, so has an initial speed of0.64 m/s.(a) What distance from the origin does the object travel before coming to rest, assuming thesurface is frictionless?m(b) How does the answer change if the coefficient of kinetic friction is Mquadratic formula.)m=0.120? (Use the WASTTheOFScreen Shot 2022-11-05 a...%0ⒸPRACTICE ITUse the worked example above to help you solve this problem. A block with mass of 5.79 kg is attached toa horizontal spring with spring constant k = 3.32 x 10² N/m, as shown in the figure. The surface the blockrests upon is frictionless. The block is pulled out to x; 0.0510 m and released.(a) Find the speed of the block at the equilibrium point.m/s(b) Find the speed when x = 0.029 m.m/sSearch(c) Repeat part (a) if friction acts on the block, with coefficient Mk = 0.120.m/s

Answered: Image /qna-images/answer/8455e4ad-308e-4377-8697-e916cd0e0a40.jpg

Use the values from PRACTICE IT to help you work this exercise. Suppose the spring system in the last example starts at x = 0 and the attached object is given a kick to the right, so it has an initial speed of 0.64 m/s. (a) What distance from the origin does the object travel before coming to rest, assuming the surface is frictionless? m (b) How does the answer change if the coefficient of kinetic friction is μ = 0.120? (Use the quadratic formula.) m

Use the values from PRACTICE IT to help you work this exercise. Suppose the spring system in the last example starts at x = 0 and the attached object is given a kick to the right, so it has an initial speed of 0.64 m/s. (a) What distance from the origin does the object travel before coming to rest, assuming the surface is frictionless? m (b) How does the answer change if the coefficient of kinetic friction is μ = 0.120? (Use the quadratic formula.) m

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter5: Newton's Laws Of Motion

Section: Chapter Questions

Problem 44PQ: A student working on a school project modeled a trampoline as a spring obeying Hookes law and...

See similar textbooks

Similar questions

A student is asked to measure the acceleration of a glider on a frictionless, inclined plane, using an air track, a stopwatch, and a meterstick. The top of the track is measured to be 1.774 cm higher than the bottom of the track, and the length of the track is d = 127.1 cm. The cart is released from rest at the top of the incline, taken as x = 0, and its position x along the incline is measured as a function of time. For x values of 10.0 cm, 20.0 cm, 35.0 cm, 50.0 cm, 75.0 cm, and 100 cm, the measured times at which these positions are reached (averaged over five runs) are 1.02 s, 1.53 s, 2.01 s, 2.64 s, 3.30 s, and 3.75 s, respectively. (a) Construct a graph of x versus t2, with a best-fit straight line to describe the data. (b) Determine the acceleration of the cart from the slope of this graph. (c) Explain how your answer to part (b) compares with the theoretical value you calculate using a = g sin as derived in Example 4.3.
A 205 g object is attached to a spring that has a force constant of 76.5 N/m. The object is pulled 7.25 cm to the right of equilibrium and released from rest to slide on a horizontal, frictionless table. Calculate the maximum speed vmax of the object. Umax = m/s Find the locations of the object when its velocity is one-third of the maximum speed. Treat the equilibrium position as zero, positions to the right as positive, and positions to the left as negative. position: cm position: cm
▾ Part B One of the greatest difficulties with setting up the baby bouncer is determining the right height above the floor so that the child can push off and bounce. Knowledge of physics can be really helpful here. If the spring constant k = 5.0 x 10² N/m, the baby has a mass m = 11 kg, and the baby's legs reach a distance d = 0.15 m from the bouncer, what should be the height h of the "empty" bouncer above the floor? (Figure 3) Express your answer in meters to two significant figures. ► View Available Hint(s) h = 15 ΑΣΦ Submit Previous Answers ? X Incorrect; Try Again; 3 attempts remaining m
A particle slides back and forth on a frictionless track whose height as a function of horizontal position x is given by y=ax2, where a = 0.81 m-1. If the particle's maximum speed is 7.9 m/s, find the turning points of its motion.
▼ A 69 g ice cube can slide without friction up and down a 30° slope. The ice cube is pressed against a spring at the bottom of the slope, compressing the spring 10 cm. The spring constant is 21 N/m . When the ice cube is released, what total distance will it travel up the slope before reversing direction? Express your answer to two significant figures and include the appropriate units. As = μA Part B Value X Incorrect; Try Again Submit Previous Answers Request Answer As = |m The ice cube is replaced by a 69 g plastic cube whose coefficient of kinetic friction is 0.20. How far will the plastic cube travel up the slope? Express your answer to two significant figures and include the appropriate units. μÀ Value M Units ?
Current Attempt in Progress Redesigning a track. The figure below shows a small block that is released on a slope, which then slides through a valley and up onto a plateau and then through a distance d = 2.03 m in a certain time At1. The whole track is frictionless, and the height difference Ah = h₁ - h2 between the release point and the plateau is 2.41 m. You want to decrease the time through d by 0.0500 s. What should the value of Ah then be? M ho Number eTextbook and Media Units
13. A block slides along a track with an initial velocity vo = 7.0 m/s from one level to a higher level after passing through an intermediate valley. The difference h from the initial position to the elevated track is 0.89 m. The track is frictionless until reaches the top. What is the velocity of the block when it reaches the top of the track?
⦁ A person (m=50 kg) is sitting on top of a wooden crate (m=100kg) on a wooden floor ( ). His friend attaches a large spring to the box and starts to pull horizontally. The spring stretches 1.2 meters, but the box doesn’t move. What is the spring constant (k) of the spring used in the problem?
DNA molecules are typically folded tightly. Stretching a strand of DNA means straightening it, and the molecules resist this straightening. Investigators can attach beads to the ends of a strand of DNA and, using "optical tweezers," measure the force required to produce a certain extension. Data for the stretch of a 3500 base pair strand of DNA approximately follow the line in the graph shown below. What is the spring constant for this strand of DNA? 1.0 pN = 1.0 x 10-12 N and 1.0 nm = 1.0 × 10-9 m. Restoring force (pN) 0.06- 0.04 0.02- 0- 4.0 N/m O 3.0 N/m 0 O 2.5 N/m O 2.5 x 10-7 N/m O 4.0 x 10-6 N/m O 3.0 x 10-7 N/m ○ 4.0 x 106 N/m 50 100 150 200 Extension (nm)
Feeling crafty/lazy, Dr. L. (mass M) wants to get up the hill without any running involved.He compresses a spring (stiffness K) some distance ∆x to start and then lets it go andlaunches himself towards a test ramp. At present the ground is frictionless. He is seen tohave a velocity of vA at point A and continues up the hill till he stops at point B. 1) As he goes back the spring is compressed to ½ of the initial compression distance.How long (L) is the sandpaper on the floor? Answer in terms of k, M, g, μK, and ∆x only. 2) What minimum length would the sandpaper need to be in order for Dr. L. tocome to a complete stop just as he reaches the end of it? Answer only in terms of vA, g, andμK
DNA molecules are typically folded tightly. Stretching a strand of DNA means straightening it, and the molecules resist this straightening. Investigators can attach beads to the ends of a strand of DNA and, using "optical tweezers," measure the force required to produce a certain extension. Data for the stretch of a 3500 base pair strand of DNA approximately follow the line in the graph shown below. What is the spring constant for this strand of DNA? 1.0 pN = 1.0 x 10-12 N and 1.0 nm = 1.0 x 10-9 m. Restoring force (pN) 0.06- 0.04- 0.02 - 50 100 150 200 Extension (nm) O 4.0 x 10-6 N/m O 3.0 N/m O 2,5 N/m O 3.0 x 10-7 N/m O 4.0 N/m O 4.0 x 106 N/m O 2.5 x 10-7 N/m
The spring has a force constant of 5000 N/m, the block has a mass of 6.20 kg, and the height of the hill is 5.25 m. A. Determine the compression of the spring such that the block just makes it to the top of the hill. Assume that there is no friction along the whole path. B. What coefficient of friction is needed along the horizontal plane (of length 2.75m) if the block is to reach only midway up the hill? C. In the same case as (B) where friction is present, at what height along the hill will the speed be 6m/s?