For a triac circuit shown in figure 5, determine the load current if the triac will turn on due to gate with Vin = 220V, 60Hz, R₁ = 40 ohms, and firing angle of 48 degree. A. 5.19A B. 4.43A C. 3.38A D. 7.21A

Q: Assume ß >> 1, VBE(on) = 0.7 volts, all npn junction areas identical, and all pnp junction areas are…

A: The given circuit is as shown below,

Q: Unit 4 During turn-on and turn-off of a power transistor, the current-time and voltage-time…

A: “Since you have asked multiple questions, we will solve the first question for you. If youwant any…

Q: What is the difference between dc-dc switching mode regulators and PWM Inverters ?

A: Switching regulators is one of the efficient way to convert one DC/DC voltage to the other.and also…

Q: 1- For single phase voltage source bridge inverter: 1- Draw the circuit. 2- With R=100 , L=50mH,…

A:

Q: why UJT is good for reverse current blocking circuits?   Explain

A: Ujt is the unidirectional device .

Q: What is the appropriate display type (common anode/common cathode) that must be used with 7447…

A:

Q: What is meant by FACTS in power systems? Discuss about SVC type FACTS device.

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: Draw the schematic diagram of CRT and label the parts.

A: CRT stands for Cathode ray Tube. The schematic for CRT is shown below.

Q: TTR 300 , what are the features (specifications) of the device ?

A: TTR 300 is known as transformer turns ratio tester it is set of three phase transformer which is…

Q: Explain how a load is wired to an MCB and how the MCB is supplied with power from the distribution…

A:

Q: What is the effect of the gate current in the operation of the TRIAC?

A: The TRIAC is defined as the triode for the alternating current. The triac is just like the set of…

Q: 2) what is aparallel circuit?what cct. Characteristics indicate that aparallel cct. Condition…

A: Since, you have posted multiple questions. We can answer only one of them. So, i solved Q. 2 for…

Q: Illustrate operational modes of TRIAC using its voltage-current characteristics.

A: The fallowing Figure shows the construction of a triac. There are two main terminals namely MT1 and…

Q: Single -phase full-bridge inverter has a resistive load of R=5 Ohm and the input voltage is 220…

A:

Q: A 3 phase bridge inverter is operated in 180 degree mode. If obtained rms value of fundamental…

A: In this question , we wil find dc supply voltage of inverter...

Q: A three-phase to three-phase, three-pulse cycloconverter operating in circulating current-free such…

A: 3-ϕ to 3-ϕ to 3-pulsec cycloconverter:Cycloconverter is device that converts AC, power at one…

Q: Draw the characteristics of SCR and explain the circuit operation with respect to forward and…

A: The characteristics of SCR is as follows: - A V-I Characteristic of SCR (Silicon Controlled…

Q: Explain the two types of MOSFETs (draw the physical structure as well). Also explain the major…

A:

Q: How to connect a resistor, a capacitor, a transistor, an IC to the bread board? Draw diagrams and…

A: A breadboard is a solderless board on which various electrical components can be mounted. The side…

Q: Explain quantization noise in PCM System, and how it can be minimized?

A: we need to explain quantization noise in PCM System, and how it can be minimised .

Q: The data sheet of a MOSFET has the following parameters: Rps ON (b) Vin 10V Ip = 5A fsw 100kHz 25m2…

A:

Q: Does this mean that 7mV is the maximum offset that can be set?

A: LM 358 is an operational amplifier Input offset voltage max =7 mV

Q: 5 Which of the following switching devices are most likely to be used in a three-phase inverter with…

A:

Q: What is the appropriate display type (common anode/common cathode) that must be used with 7447…

A: LED display can be broadly classified into two types  (i) Common Anode  In common Anode type display…

Q: c. Why is the terminology field effect appropriate for this important three- terminal device?

A: For the JFET, the drain current ID flows by the influence of the electric field because of the…

Q: Q2. A) What are the main differences between the three-phase bridge 180 and 120 degree modes of…

A: Types of converters AC AC Converter AC to DC Converter (Rectifier) DC to DC Converter (Chopper) DC…

Q: Draw the characteristics of SCR and explain the circuit operation with respect to forward and…

A: The silicon controlled rectifier ( SCR ) is a three terminal semiconductor exchanging gadget which…

Q: Q1) The RTL gates have: VCE (sat) = 0.2V, VBE (FA) = 0.6V, VBE (sat) = 0.8V, K = 0.9, and PF = 100.…

A: According to the question, for the given RTL gates, we need to provide the comparison between two…

Q: wave shapes of a three phase inverter

A: Diode- When diode is forward biased it is short circuited in a circuit ideally.When diode is reverse…

Q: write the specification of circuit breaker.

A: Given Specifications of circuits breaker.

Q: а. What is an accumulator system, explain with mathematical expression. b. Find whether an…

A: Bartleby has policy to solve only first 3 subparts of a question. For solution of rest questions…

Q: Q3. Briefly explain CISC and RISC processing unit architectures?

A: This is a simple question based on subject computer organization in electrical engineering . In this…

Q: e. Due to fabrication errors, lines d and fwere shorted to the supply voltage. What happens to the…

A: If the lines d and f were shorted to the supply voltage due to the fabrication errors. If the supply…

Q: 1- Define voltage regulator ? what is its main job? 2- How can we specify the quality of voltage…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Assume b >> 1, Vp = 0.7 volts, all npn junction areas identical, and all pnp junction areas are…

A: The given circuit is shown as below,

Q: Which IC technology has the lowest power dissipation in general?

A:

Q: v. The DC supply of single phase bridge inverter is 350V. For quasi-square wave output voltage with…

A:

Q: Q) The two power MOSFETS with a tonnage current of 10A and rDS(on)1= 0.90 and rDS (on)2= 1.10 are…

A: tonnage current, ID(ON)=10A rDS(ON)1=0.9Ω; rDS(ON)2=1.1Ω TOTAL CURRENT=16A duty cycle, D=50% to find…

Q: What is 4 IR and IoT and how both technologies related to microprocessors and microcontrollers? List…

A: The blurring of barriers between physical, electronic, and physiological worlds is referred to as…

Q: 4. What is the maximum drain current flowing to the LEDS when VDs is 5V?

A:

Q: II- Determine the Vautr from the reverence cold junction LM335 if the temperature of the environment…

A: cold junction with LM335 Temperature T=20°C=293 K It is given that VoutToTo=10 mV/K…

Q: What is meant by FACTS in power systems? Discuss about SSSC type FACTS device.

A:

Q: Single -phase full-bridge inverter has a resistive load of R=5 Ohm and the input dc voltage is 220…

A:

Q: What is an MCU and what is its function?

A: MCU stands for microcontroller unit, a microcontroller unit is a small embedded computer that is…

Q: For the ALU circuit shown below, what should be the control word (S251SO) to perform the (sl A)…

A: According to the question, for the given circuit as shown below We need to find the condition for…