What is the torque about the origin of the force F (8.0i - 3.0j + 2.0k) N if it is applied at the point whose position is: r= (-5.0i + 9.0j) m? 3. What is the torque about the origin of the force F (8.0i -3.0j + 2.0k) N if it is applied at the point whoseposition is: r = (-5.0i + 9.0j) m?29°C

Torque is given as:τ→=r→×F→Where F→= Force vector in Nr→= position of the point with respect to…

Answered: What is the torque about the origin of…

What is the torque about the origin of the force F (8.0i - 3.0j + 2.0k) N if it is applied at the point whose position is: r= (-5.0i + 9.0j) m

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter10: Rotational Motion And Angular Momentum

Section: Chapter Questions

Problem 19CQ: When there is a global heating trend on Earth, the atmosphere expands and the length of the day...

See similar textbooks

Related questions

Q: A horizontal aluminum rod 3.3 cm in diameter projects 7.2 cm from a wall. A 1000 kg object is…

Q: A U-shaped tube is open to air on both ends and filled with water (blue) and an unknown liquid as…

Q: I 12-0 V ww R₁ = 12 O 19 ohm IZR₂ IR3 bon 22 Given the above circuit connected to emf of 12.0.…

Q: A Carnot refrigerator operating between 772 K and 306 K uses 52.9 kJ of work. Determine the COP (use…

A: Given, T1 = 772 K T2 = 306 K

Q: A ball of mass m is fastened to a string. The ball swings at constant speed in a vertical circle of…

Q: A 39.0 N force pulls horizontally on a m1 = 1.3 kg block that slides on a rough horizontal surface.…

A: Given, mass of block = 1.3 kg mass of second block = 2.7 kg coeffecient of kinetic friction = 0.24

Q: A particle of momentum P1 collides with a particle at rest. After the collision, the particle…

A: Let an angle α from P3 to horizontal direction and then the angle θ-α will be from P4 to horizontal…

Q: A car starts at the origin and travels 5 km to the north, then 3 km to the west, then 4 km to the…

Q: Assume that you have an RC AC Circuit with one resistor, R RC Circuit phasor diagram below. VR Vps Y…

A: In this question we have to use the law of cosines to determine the phase angle Gamma in degrees.…

Q: In the Figure shown below, what is the net electric potential at the origin due to the circular arc…

A: Solution: Given: k = Coulomb's constant = 8.99 x 109 N.m2/C2 O = origin of the coordinate system Q1…

Q: Coulomb's Law is a mathematical representation of the electric force between two objects. When…

A: According to Coulomb's Law: F=KQ1Q2r2 where, K=Electric constantQ1=First chargeQ2=Second…

Q: One of the waste products of a nuclear reactor is plutonium-239 (239pu). This nucleus is radioactive…

Q: Two charged particles are a distance of 1.82 m from each other. One of the particles has a charge of…

Q: A horizontal aluminum rod 3.3 cm in diameter projects 7.2 cm from a wall. A 1000 kg object is…

A: Determine the cross-sectional area of the rod.

Q: What is the resistance of a NichromeTM wire at 0.0 ∘C∘C if its resistance is 105.60 ΩΩ at 12.1 ∘C∘C?…

A: GivenInitial temperature is Ti=12.1°CFinal temperature is Tf=0°CInitial resistance is Ri=105.60ΩThe…

Q: wo "Crush Gear" toys in a "battle arena" collide elastically as one approaches the other directly…

Q: A sample of blood plasma occupies 0.599 L at 0°C and 1.03 bar, and is compressed isothermally by…

A: Given Vi=0.559 L external pressure (Pext)=95.2 bar Compression =0.57% Required work done

Q: Shown in the figure are gaussian surfaces ( S1, S2, and S3 ) and three point charges. Which of the…

A: To identify : The gaussian surface which has zero net electric flux through its surface

Q: A solenoid of radius 3.5 cm has 800 turns and a length of 25 cm. (a) Find its inductance. mH (b)…

A: Given: The radius of the solenoid is 3.5 cm = 0.035 m. { 1 cm =…

Q: A water balloon's radius is reduced by one fourth due to pressure. What is the pressure on the…

A: Given:- The radius of the water balloons is reduced by one-fourth due to the pressure The bulk…

Q: A jet plane moving at constant speed of 80. m/s horizontally drops a box at a height of 9500 m.…

A: Apply the second kinematic equation in the vertical motion to determine the time taken by the box to…

Q: Find the potential energy of 10 kg mass kept at height of 8 m. Take g = 10 m/s²

A: Given data, Height = h Mass = m Acceleration due to gravity = g Required, Potential…

Q: An object has a mass of 4kg. Calculate its potential energy 3m above the ground.

Q: The final set of this lab has you hanging an unknown mass on a spring (for which you have determined…

A: The values given in the problem are as follows The spring constant k = 24.0N/m Displacement in the…

Q: Q6. Two blocks are of identical size. One is made of lead and sits on the bottom of a pond; the…

Q: a car with a mass of 1300 kg is westbound at 45km/h. It collides at an intersection with a…

Q: A 0.2 cm tall object lies 10 cm from a 25 cm focal length magnifying glass. Find the location,…

A: The light deviates from its path when travelling from one medium to another. The phenomenon is well…

Q: A river is 55 m wide. There is a current flowing at a velocity of 1.9 m/s [E]. You try and swim…

A: in this question we use relative velocity equation.

Q: The figure below shows three edge views of a square loop with sides of length = 0.425 m in a…

Q: Consider a clear liquid in an open container. We determine that the liquid-air critical angle is…

A: We have a open container with a liquid of refractive index say u and a the critical angle of the…

Q: 11. A toy race car travels through a loop-the-loop (a circle in a vertical plane) on a track.…

Q: Read the length of various objects using the Vernier Caliper. Please be mindful of the precision of…

A: Required Reading of the vernier calipers.

Q: The figure below shows a circuit consisting of a 24.0 V battery in series with an inductor with…

A: a) Determine the maximum current in the circuit after the switch is closed.

Q: Explain the meaning of the following statement. 1kgf = 9.8 N

A: In this question we have to explain the meaning of the statement. Please give positive feedback if…

Q: A block with mass m sits on a frictionless plane inclined at angle θ, as shown in the figure. If the…

A: in this question we use free body diagram.

Q: A river flows due south with a speed of 2.30 m/s. A man steers a motorboat across the river, his…

Q: A river is 55 m wide. There is a current flowing at a velocity of 1.9 m/s [E]. You try and swim…

Q: A tesla starts from rest on an unbanked circular track of radius 100m and speeds up at a steady rate…

Q: A proton and an electron are held 15 cm apart. What is the magnitude and direction of the electric…

Q: 6. Person A with a mass of 100 kg weighs nearly thrice as much on Earth as on Planet Mercury. What…

Q: Two bodies A and B having same mass is moving with velocities v and 2v respectively. Compare their…

A: 1) Since two bodies has same mass m1 = m m2 = m Ratio of inertia m1 / m2 = 1 m1 = m2 Inertia of…

Q: A +5.0-µC point charge is placed at the 0 cm mark of a meter stick and a -4.0-µC charge is placed at…

A: Given Charge at 0 cm = q1 = + 5 × 10-6 C Charge at 50 cm = q2 = -4 × 10-6 C We have to calculate the…

Q: The rate of water flow is 17.5 L/s through a horizontal pipe with a constant diameter of 3.4 cm. A…

Q: Calculate the force acting on a particle

A: Given, Figure shows the time-velocity graph of a particle, mass,m= 100gor, m= 0.1 kgCalculate the…

Q: 1. (1) What potential difference is needed to stop an electron that has an initial velocity v = 5.0…

Q: The drawing below is of three separate bar magnets. The north and south poles of each magnet are…

Q: et's take the Earth's magnetic field BE = 1.70 x 10-4 T pointing north. A metal cable attached to a…

Q: 3. The Figure below shows a parallel-plate capacitor of plate area A= 10.5 cm² and plate separation…

Q: Two identical springs, of spring constant k, are joined in parallel. What is the energy stored in…

A: In parallel, net spring constant K = k + k = 2k

Q: A pile of 1000 sheets of paper has a mass of 5kg. The pile is 4OOmm long, 200mm wide and 50mm thick.…

A: No of sheets=1000 Total mass=5 kg Length of pile=400mm =40 cm Width=200 mm=20 cm Height =50 mm=5 cm

Concept explainers

Torque

Torque is the rotational equivalent of linear force in physics and mechanics. Based on the course of study, it is also known as the moment of force, rotational force, or turning effect.

Question

What is the torque about the origin of the force F (8.0i - 3.0j + 2.0k) N if it is applied at the point whose position is: r= (-5.0i + 9.0j) m?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A cylindrical drum 2 m in radius is held by a rigid bar AB hinged at A and a flexible wire BC. The drum weighs 1500 N. Neglect friction in all contact surfaces. wire B 2m 10 m 60" Which of the following most nearly gives the normal reaction at D? 2500 N 3500 N с. 3000 N d. 2000 N a. b. Which of the following most nearly gives the vertical reaction at A? c. 185.3 N d. 164.2 N a. 146.8 N b. 125.9 N Which of the following most nearly gives the tension in wire BC? 2768.3 N 2255.4 N а. c. 2143.9 N b. d. 2854.1 N
2. A sphere with mass m and radius r is spinning with an angular speed ω = 2 rad/s. The mass has stayed the same, but now the sphere contracts so that the radius of the sphere is 1/3 of its original radius. What is the angular speed of the sphere after the expansion? Explain.
For the section shown, find the second moment of area about axis XX 25.0 mm 3.0 mm 18.0mm 5.0 mm
3. Two uniform disks and two cylinders are assembled as indicated. Disk A weighs 32.2 lb and disk B weighs 24.15 lb. When the system is released from rest, then a moment couple of 8.05 lb-ft is applied as shown. Determine the acceleration of cylinder C, if the cylinders are attached to a single cord that passes over and does not the disks. Assume that no slipping occurs between the cord and the disks. с 16.1 lb "9='4 M B O, r₂ = 4" D 32.2 lb
A smooth circular hoop with a radius of 0.500 m is placed flat on the floor. A 0.400-kg particle slides around the inside edge of the hoop. The particle is given an initial speed of 8.00 m/s. After one revolution, its speed has dropped to 6.00 m/s because of friction with the floor. (a) Find the energy transformed from mechanical to internal in the particlehoopfloor system as a result of friction in one revolution. (b) What is the total number of revolutions the particle makes before stopping? Assume the friction force remains constant during the entire motion.
When there is a global heating trend on Earth, the atmosphere expands and the length of the day increases very slightly. Explain why the length of a day increases.
Review. A mixing beater consists of three thin rods, each 10.0 cm long. The rods diverge from a central hub, separated from each other by 120, and all turn in the same plane. A ball is attached to the end of each rod. Each ball has cross-sectional area 4.00 cm2 and is so shaped that it has a drag coefficient of 0.600. Calculate the power input required to spin the beater at 1 000 rev/min (a) in air and (b) in water.
2. Find the y-coordinate of point A so that the 361-lb force will have a clockwise moment of 400 ft-lb about O. Also determine the X and Y intercepts of the action line of the force. F#361 ib
5. Question : Determine the volume of the solid body generated by revolving the shape shown below. The rotation is about to y axis an through 360°. y 40 mm 40 mm 40 mm 80 mm 80 mm
e. Determine the internal moment at A caused by the vertical loading. Figure
Global warming is a cause for concern because even small changes in the Earth’s temperature can have significant consequences. For example, if the Earth’s polar ice caps were to melt entirely, the resulting additional water in the oceans would flood many coastal areas. Model the polar ice as havingmass 2.30 × 1019 kg and forming two flat disks of radius 6.00 × 105 m. Assume the water spreads into an unbroken thin, spherical shell after it melts. Calculate the resulting change in the duration of one day both in seconds and as a percentage.
1. A uniform sphere of lead (ρ = 11 300 kg / m3) and one of aluminum (ρ = 2 700 kg / m3) have the same mass. What is the relationship between the radius of the aluminum sphere and that of the lead sphere?