What is used to clean dirt and debris from connector bodies prior to disconnection? O Solvent O Water O Brake cleaner O Dielectric grease

Q: From the Z transform of the frequency response H (z) = 1 - 2z^- 1+z^-2, calculate its Fourier…

A:

Q: 1-F capacitor is connected in series with a 6-ohm resistor. If the connection is energized from an…

A: We need to find out the voltage across capacitor for given circuit.

Q: For this circuit a) Calculate 1₂ b) Calculate V₁ c) Calculate V

A: Given:

Q: Ferramenta de Graph the amplitude and phase spectra of the functions A(z) = 1 − z¯¹ and B (z) =…

A: Given: A(z)=1-z-1,B(z)=z-z-12, To find: Graph the amplitude and phase spectra of the functions.

Q: .A 110-V dc motor draws a current of 30A and is located 500 ft from the power source. What is the…

A: Given: Length of wire (l) = 500 ft = 15240 cm Diameter of the copper, d= 0.25 inch DC motor voltage,…

Q: Find the charge on the capacitor and the current in the given RLC series circuit whose values are…

A:

Q: 12 V 3Ω 6Ω b 3 Ω 5Ω Μ W ΖΩ 10Ω ¡LOAD VLOAD ≥ RLOAD 8Ω 8 Ω

A:

Q: Circuit connected in parallel with given values of Vsupply=120V; R₁ = 2 kſ, R₂ = 4KS, R3 =6KQ; R4 =…

A:

Q: Find the expression for the output function, F. Do not simplify. Vdd- B C B bar B bar A 0 A bar A…

A: According to the question, for the given circuit as shown below We need to find the output function…

Q: Required: 1. Draw a k-map table based on the logic/truth table above. 2. Group the implicants (those…

A: The given truth table has 4 possible combinations and we can find the Boolean expression using…

Q: 1. 2. 3. BC + BC A(A + B) A(A A(A + AB)

A: Since you have posted multiple questions, we will provide the solution to the first three questions…

Q: u(t) v 10 - 4 : To - 1 -HA 2 حمل Volk ۱ t ye will u

A:

Q: What are the benefits of CHP(combined heat & power) application?

A:

Q: An op-amp has a slew rate of 10 V/μs. The largest since wave output voltage possible at a frequency…

A: Given: An opamp slew rate = 10 Vμs Frequency, f = 2 MHz Maximum possible sine wave output voltage,…

Q: In the circuit below, v1 = 10 V and i1 = -2.5 A. Use mesh analysis to find V i1 200 V₂ = 50 Ω ww 10…

A:

Q: Please solve Last time Rejected. A 230-V, 3-phase, 4-pole, 50Hz, star connected induction motor is…

A:

Q: ← OpAmp Linear Circuits Q.7 An op-amp has a slew rate of 10 V/μs. The largest since wave output…

A:

Q: Solve for the value of the capacitance (in nF unit) if R2-1017 ohms and Xc-2316 ohms. Round your…

A: Given data, Resistance R=1017 Ω. Capacitive reactance Xc=2316 Ω,

Q: Circuit connected in parallel with given values of Vsupply=120V; R1 = 2 ΚΩ, R2 = 4ΚΩ, R3 =6ΚΩ; R4 =…

A:

Q: Calculate correinte I1, I2 and I3

A: It is given that:

Q: Identify the correct statement regarding the machine whose state table is (PS-Present State, NS-Next…

A: From the given machine state table it is asked to find the correct statement

Q: How much of the USA's electricity is supplied by solar energy?   • Less than 6%    10%    20%…

A: Solar energy Solar energy is a powerful source of energy that can be used to heat, cool, and light…

Q: A pulse waveform with a frequency of 10 kHz is applied to the input of a counter. During 100 ms, how…

A: In this question We need to determine the number of pulses are counted for 100ms. If frequency f=…

Q: 400 Ω 50 Ε HE 10 MF 5 ΚΩ Vo

A:

Q: 4. Determine equivalent impedance = R₁ 2000 C = 10μF R₂ = 4000 L = 1H Assume: w = 120π R₁ www Ť C…

A: given circuit. we have to calculate Zeq

Q: Please explain step by step that how to solve the equations to get the values of v1 and v2?

A:

Q: Calculate the TF of the following circuits: Vin(s) circuit A Vout(s) Vin(s) mmmm circuit B Vout(s) O

A:

Q: The circuit shown is at steady state before the switch opens. Find the expressions of voltage v(t)…

A:

Q: Suppose a circuit has a transfer function of the form A(w) = A₁(1) For A = -10 V/V and wo = 100,…

A: Note DC gain of any system is defined at zero input frequency  DC gain is also called as the DC…

Q: Q4/ Determine the Fourier series expansion of the waveform x(t) shown below: -2rt -10 3 -3 Good Luck…

A:

Q: Minimize the logic function  Y(A,B,C,D) =  ∑(0,1,2,3,5,7,8,9,11,14) . Use Karnaugh map. Draw logic…

A:

Q: A 75 KVA, 240/7970 V, 60 Hz single phase transformer has the following parameters referred to the…

A: For the given transformer we need to find the voltage regulation and efficiency.

Q: AA-A three transformer bank, each of 10 KVA SL transformer become, disable and hence the circuit…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: What is the closed-loop bandwidth of the amplifier shown in Fig. R₁ own Vin AOL = 150,000 fc(OL) =…

A:

Q: 1. Determine and sketch the following signal if : a. x[-n] b. x[n+2] c. x[-n + 3] x[n] = { 3, 2, -2,…

A:

Q: 1. (a) Derive the transfer function of the following circuit. (b) Plot the Bode plot of magnitude.…

A:

Q: E₂ - 11-2 W 12 2.5. R₁ R₂ 13 R3 E₁= E₂= ET= R₁= R₂= R3= RT= IT= |1= 12= 13= V₁= V2= V3= 5 V 9 V 14 V…

A: In this question We need to determine the unknown currents , resistances and voltage across the each…

Q: A circuit with series and parallel connection has, Vsupply = 24 Volt, resistors, R₁= 600 , and two…

A:

Q: 24. Compute the discrete-time Fourier transform of the following signal: x[n]=u[n+3]-u[n-2] (Write…

A: We need to find out the discrete Fourier transform for given sequence .

Q: • Current is similar to the following property to the fluid flow: 1. b) e c) d) OO discharge…

A: It is asked to state the property of current similar to fluid flow

Q: Given the following circuit V₁ = 20 V R, = 10 μΩ R₂ = 5 µQ V₂ = 2 V a. What is the current and…

A:

Q: Consider the sinusoidal voltage (t) = 48 cos(32t+10°) V. NOTE: This is a multi-part question. Once…

A: Given: Sinusoidal voltage, v(t)=48 cos(32t+100) V, To find: The period T of the sinusoidal signal.

Q: Electrical engineering

A: Given data:Three phase induction motor, f=50 HzP=4Speed of motor, Nr=1293 rpm

Q: The received signals can be modeled by x(t)=s(t)+w(t), where s(t) is the desirable signals modeled…

A:

Q: A 200 V shunt motor has armature and field resistance of 0.2 Ω and 220 Ω respectively.  The motor is…

A: In this question we need to find the new speed and armature current if an external armature…

Q: Find the equivalent resistance. * VT = 30 V + 1.06 ΚΩ Ο 2 ΚΩ Ο ΚΩ 0.97 ΚΩ V, = 5.4 V 180 Ω R₁ Μ = R₁…

A: Note: Equivalent resistance across any target terminal or soyrce is equal to ratio of terminal…

Q: The system real-time capacity can betemporarily over the Shannon limit

A: False

Q: The single-phase half-wave controlled rectifier supplies a resistive load drawsan average current of…

A: Given data, Average current i0=1.62 A. Supply voltage V = 240 V. Frequency f = 50 Hz. Average output…

Q: IN Jvcc I OUT GND PMOS NMOS Active Gate Contact Metal

A: The circuit given is that of a CMOS Inverter. Following is the layout of a CMOS Inverter with one…

Q: [2] s(t) is square wave J-1, -< t < 0 1. 0<t<T s(t) = (a) plot f(t)=s(t)* sin(2t) (b) Find Fourier…

A:

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.