When answering this problem, report the answer with the appropriate number of significant figures. When entering units, use proper abbreviated units with proper capitalization. A beverage drink mix sample is prepared by mixing a packet of beverage powder in a gallon (3.78 L) of water. A sample for analysis is prepared by diluting 10.00 mL of this solution in a 50.0 mL volumetric flask. When measured using a colorimeter, this diluted solution has an absorbance of 0.349. The calibration curve for the experiment yielded a linear fit of y = 21655x+0.0318 and an R2 value of 0.9911. Determine the molar concentration of food dye in the analyzed sample. Answer: _____x10____ _____units

Q: 3. When solutions containing 1.0000 g of BaCl2 and 1.0000 g of NazSO4 were mixed, solid BaSO4…

A: Note - Since you have posted a question with multiple sub-parts, we are supposed to solve only the…

Q: When performing a gram stain, it is necessary to remove crystal violet stain from any gram negative…

A: Given, Total volume of decolorizer desired = 300 mL

Q: he concentration of PSA (prostate-specific antigen) in the blood is sometimes used as a screening…

A:

Q: Q3: When performing a gram stain, it is necessary to remove crystal violet stain from any gram…

A: The amount of water is needed to add if you have 98% ethanol and want to end up with 460 ml of…

Q: Newly produced beer must be checked to see if it meets predetermined standards. The percentage of…

A: We need to calculate the average percentage by volume of ethanol for the batch: The batch contains 4…

Q: A. Types of Error. A group of students is doing an analysis of copper in a 1-peso coin. They were…

A: 1) Makisig forgot to calibrate the analytical balance before weighing. Solution : Determinate error…

Q: In a lab, you're provided with a stock solution of food dye. This is a solution from which you…

A: Dilution of the stock solution: When we dilute a concentrated solution with pure water, the mole of…

Q: Use the lab introduction to answer the following question. When answering this problem, report the…

A: Volume of beverage powder sample mixture = 3.78 L Volume of sample taken for dilution (V1) = 10 mL…

Q: A sample of vinaigrette salad dressing has a total mass of 188 g188 g , a total volume of 196 cm3196…

A:

Q: You can calculate cost effectiveness using the following formula: volume of HCI neutralized per…

A: Given Brand X antacid 2 tablets/500 mg dose 40 tablets/container cost:$3.75/container To find Cost…

Q: After performing precipitation gravimetry, Asta placed the weighing form inside the crucible, heated…

A:

Q: An analytical chemist weighs out 0.083 g of an unknown monoprotic acid into a 250 mL volumetric…

A: Mass of the unknown monoprotic acid, HA taken = 0.083 g Total volume of the HA solution prepared =…

Q: A laboratory procedure calls for making 510.0 mL of a 1.2 M KNO3 solution. Part A How much KNO3 in…

A: Given, Molarity of solution = 1.2 M volume of solution = 510.0 mL = 0.51 L we are asked to calculate…

Q: calculate volume H2=Volume displaced water

A: Given Mass of Empty Beaker is 141.2g, Beaker + Water is 388.3g,  mass of water is 247.1g, volume of…

Q: If you had to prepare a 0.200 M HCl solution from 17.0 mL of a 2.60 M HCl stock solution, to what…

A:

Q: A 100 mg vitamin C tablet weighed 1.681 g. A student crushed the tablet and transferred 0.150 g of…

A: Given the weight of 100 mg Vitamic C (ascorbic acid) tablet = 1.681 g  0.150 g of the above tablet…

Q: A laboratory provides the following analysis obtained from a 50 ml sample of water. Ca²+ = 40 mg/L,…

A:

Q: You record the following data during the Qualitative and Quantitative Characterization of Aspirin…

A:

Q: On the molecular level, what does it mean for a solid sample to be pure?

A: Applying concept of pure solid / substance via molecular basis explanation.

Q: 3. When solutions containing 1.0000 g of BaCl2 and 1.0000 g of NazSO4 were mixed, solid BaSO4…

A: Given that : The mass of BaCl2 used = 1.000 g The mass of Na2SO4 used = 1.000 g The molar mass of…

Q: What is the average number of drops equivalent to 1 ml? How do you address a solution that is…

A: Solubility is the property of dissolution of a solute in a solvent to form a solution.  Misicibility…

Q: À mixture of sand, salt, and iodine was separated by first heating the mixture to drive off the…

A: The mixture contains sand, salt and iodine. Mass of dried sand and evaporating dish = 103.987 g…

Q: On the molecular level, what does it mean for a solid sample to be pure?

A: As per bartleby guidelines i answered only first question so please don't mind thanks in advance.

Q: A pycnometer is a glass flask with a tight fitting glass stopper that can be used to determine the…

A: Mass of clean pycnometer = 25.151 g Mass of clean pycnometer plus water = 42.481 g  Initial mass of…

Q: Which is a correct statement about methods for separating mixtures?A. Distillation results in the…

A: Separation of mixtures involves various techniques and methods used to segregate the mixtures based…

Q: The fundamental difference between gravimetric and volumetric analysis: a gravimetric analysis…

A: Yes you are absolutely right

Q: An analytical chemist weighs out 0.109 g of an unknown triprotic acid into a 250 mL volumetric flask…

A:

Q: When you perform the following operations, how many significant figures should your answer have?…

A:

Q: (d) Complete the following statements: (i) The three are solid, liquid and (ii) The three scales are…

A: Please find the answers here in serial wise  manner.

Q: When answering this problem, report the answer with the appropriate number of significant figures.…

A: Solution - According to this question - Given - Formula - no of mole = molarity x volume thus, no of…

Q: You record the following data during the Qualitative and Quantitative Characterization of Aspirin…

A: A numerical problem based on concentration terms, which is to be accomplished.

Q: For accurate measurements of unknown quantities, which concentration range - dilute or concentrated…

A:

Q: Is the mixture described in the table homogeneous or heterogeneous? Explain how you can tell.

A: A substance which consists of two or more elements or compounds which are not chemically reactive is…

Q: Which of the following is incorrect: a. General steps in quantitative analysis include: Method…

A: Chemical analysis are of two types : 1. Quantitative analysis 2. Qualitative analysis

Q: A student dissolves a Jefferson nickel to make 100.00 mL of solution in a volumetric flask. The…

A: Mass of Copper in Jefferson nickel used for making the first solution is taken as ‘x’ g.Hence,…

Q: Be sure to answer all parts. Fluoridation is the process of adding fluorine compounds to drinking…

A: One person consumes 140gallon  1 gallon is equal to 3.785L  The density of water = 1g/ml which will…

Q: 2.) Five standardized dilutions of aqueous lead(II) chromate solution were prepared by adding a…

A: The concentration of the [CrO42-] in 100 mL deionised water can be detrmined by using the formula.…

Q: In an experiment a student used a 50 mL volumetric flask to prepare her copper solution but in…

A: step 1:  For making standard solutions, one must take care of the quantity that is to be taken…

Q: (d) Complete the following statements: (1) The three are solid, liquid and (i) The three scales are…

A: (1) The three states of matter are solid, liquid, and gas (2) The three Temperature scales are…

Q: Filtration is the most appropriate method for separating a solution of water and which substance? A.…

A: Filtration is the most appropriate method for separating a solution of water and which substance?

Q: A student pipetted 10 mL of a sample solution into a 250 mL volumetric flask and diluted it to the…

A: At first 10 mL of original solution is taken in 250 mL flask and the rest 240 mL of water is added…

Q: An analytical chemist weighs out 0.085 g of an unknown monoprotic acid into a 250 mL volumetric…

A:

Q: gas (pure or mixture) 1 solute P/P(o) solvent c/c(o) pure solid or liquid

A:

Q: irections: Match the following terms in column A to the description that matches them in column…

A: Match the given column:

Q: Iodine was contaminated with salt. When the mixture was heated the iodine vapourized and the violet…

A: All matter can be classified as solid, liquid and gases mainly. In these physical states of matter,…

Q: 2.) Five standardized dilutions of aqueous lead(II) chromate solution were prepared by adding a…

A: For the given question, we have to determine the number of moles of PbCrO4 present by using the…

Q: 1 of 4 Find the best match between the following terms with its correct definition phase homogeneous…

A:

Q: To what volume (in mL) should 0.67 mL of an 5.21 M acetic acid solution be diluted in order to…

A: During dilution solvent is added so moles of solute before and after dilution is same i.e M1V1 =…

Q: An acid is dissolved in another acid. Acid has a specific gravity of z.46 and a mass of 50 grams.…

A: 50 grams of acid 1 is dissolved with 50 ml of acid 2 specific gravity of acid 1 is 2.46 g/ml…

Stoichiometry

Stoichiometry is a chemical division that evaluates the quantitative content of the chemical process with the help of the reacting molecules or products taking part in the reaction. The term “stoicheion” in “Stoichiometry”, is an old Greek term for "element" whereas “metron” means "measure".