Which of the following is the major organic product in the reaction sequence? 1. CH;CH,MGCI H3C-CECH diethyl ether 2. H;0* о н CH-CH3 O CHCH2 HO CH3 HO Туpe: MC

Q: 15. A total of 170g of sodium nitrate is dissolved in enough water to make 2.0 liters of an aqueous ...

A:

Q: QUESTION 4 The equilibrium constant, Ke for the following reaction at 698 K is 54.8. X2 (g) + Y2 (g)...

A: Given data : Kc = 54.8 [X2] = [Y2] = 0.020 M [XY] = 0.530 M

Q: Given: 2L Distilled Water 500mg Ascorbic Acid Tablet To answer: 1. Find the amount of distilled ...

A:

Q: Consider the following reaction. Pb(NO3)2(aq) + 2 KC(aq) → PBCI2(x) + 2 KNO3(y) Which species would ...

A: Spectator ions are those which present in both side of a reaction and does not take part in the reac...

Q: Synthesis gas (a mixture of ?2 and ??) can be produced by the catalytic reforming of methane with st...

A: Now in ist reaction is between methane gas and steam making it absorb energy for reaction to occur t...

Q: In an aqueous solution of potassium chloride, the solute is (1) Cl- only (2) KCI (3) K+ only (4) H;0

A: The solute is the substance which is being dissolved in the solvent to make the homogeneous mixture ...

Q: At a certain temperature the vapor pressure of pure heptane (C,H16) is measured to be 416. torr. Sup...

A:

Q: Construct the expression for Kc for the following reaction. HF(aq) = H(aq) + F(aq) 1 Drag the tiles ...

A:

Q: A 1.0 M solution is made with the imaginary polyprotic a For this acid, Ka1 = 1x 10-6 and K2 = 1 x 1...

A: Here we have to determine pH of 1.0M aqueous solution of polyprotic acid H2A. Ka1=1×10^-6 and Ka2= 1...

Q: Assuming that the yield of your amidation reaction was 100%, how many mole equivalents of diethylami...

A: In chemical synthesis, the combination of suitable reactants under the specified conditions of tempe...

Q: Given the first order reaction A(g)  -- >  B(g)  +  C(g)  + 3D(g) with a rate constant of 6.0x10-4 s...

A: Given :-  A(g) → B(g) + C(g) + 3D(g)  Reaction is first order  K = 6.0x10-4 s-1  Initial concentrati...

Q: Mass of Zinc and Iodine was taken during the reaction is - zinc - 2.06 g, iodine -2.15 g dry iodin...

A:

Q: 3. Which of the following would NOT increase the rate of reaction?   A. raising the temperature   B...

A: Given,  The parameter which is would not increases the rate of the reaction is:

Q: The percent by mass of acetonitrile (MM = 41.05 g/mol) in an aqueous solution is 11.5%. What is the ...

A:

Q: In lab, you observed and classified multiple reactions. You mix a clear blue solution and a clear ye...

A: To select the option that satisfy that a chemical reaction is not take place.,  

Q: HC-C-C-CH [이 OH If the above molecule undergoes oxidation, which functional group would be present i...

A:

Q: What happens if the solvent concentration falls below that of the silica stationary phase? What is t...

A: The chromatography technique consists of two phases mobile and stationary phase .Mobile phase is the...

Q: In a purity check for industrial diamonds, a 10.25-carat (1 carat = 0.2000 g) diamond is heated to 7...

A:

Q: How many grams are in 0.743 mol of Al? Express your answer to three significant figures.

A:

Q: 2) Calculate how you would prepare 1.000 / of a pH 9.50 buffer made from NH3 and NH,CI. You are prov...

A:

Q: atm to Pa

A:

Q: HO2C CH2N2 H H Me., Me Et20 90 & (4 steps) Me., Me Me Me

A: Diazomethane (CH2N2) reacts with carboxylic acid to form methyl ester. CH2N2 abstracts proton from t...

Q: 3. For the reaction 2NO (g) +2 H2↔ 2 H2O (g) + N2 (g) a. Write the equilibrium expression for the re...

A:

Q: 5. In our experiment, we took 5.00 ml of unknown  solution consisting of Ca2+, Mg2+ to a 250 ml flas...

A: Quantitative analysis is used to determine the amount of analyte present in the sample. Quantitative...

Q: 6) Which of the following solvents is best to use for the recrystalization of solute A? O a. Water C...

A: Recrystallization is a process in which an impure substance is purified. The process is based on the...

Q: How would you convert the following compounds into butanoic acid using reagents from the table? a. ...

A: Both the compounds are alkenes. An alkene can be transformed into a carboxylic acid by oxidation.

Q: n lab two different mobile phase compositions (acetone and hexanes) were used for column chromatogra...

A: The solution of the question is given below:

Q: As mentioned previously, molecules attract each other. The forces of attraction between molecules ar...

A:

Q: Reaction conditions are 400 K and 2 bar Determine the equilibrium constant K for this reaction at 4...

A:

Q: A chemist measures the amount of fluorine gas produced during an experiment. She finds that 635. g o...

A:

Q: Considering LeChatelier's Principle, list 4 different ways in which you could shift the following en...

A: According to Le Chatelier's principle , If there any change happens to a system that is in equilibri...

Q: For the cell represented as Al(s)∣Al3+ (aq)∥Sn2+ (aq), Sn4+ (aq)∣Pt(s), how many electrons are trans...

A: We would first write reduction half reaction and oxidation half reaction.  From this we can check nu...

Q: Now it's your turn to practice retrosynthesis and forward synthesis using the reactions from Ch. 7 a...

A: Hydroboration-oxidation of alkene gives Anti-marknonikov's product(terminal alcohol).  Oxidation of ...

Q: Structural Diagram with Approximate Bond Angles Formula Lewis Structure NO2* NO2- NH4+ NO3- 4 – 4

A: The detailed explanation of the given question is given below.  The given concept has been taken fro...

Q: The last slide of the video on applications of the Boltzmann distribution describes the behavior of ...

A: Hydrogen gas molecule are diatomic molecule and the gas is at thermal equilibrium.

Q: 2-ethyl-3-hexyne 4-chloro-2-pentyne 4-heptyne QUESTION 2 In the addition of hydrogen bromide to alky...

A:

Q: Measurements show that the enthalpy of a mixture of gaseous reactants increases by 140. kJ during a ...

A: Enthalpy of a mixture of gaseous reactants increases by 140. KJ  It means enthalpy change (∆H) = + 1...

Q: 10.00 mL of 5.07 M H2SO4 is pipetted into an Erlenmeyer flask in preparation for a titration. How ma...

A: Note : Since you have posted multiple questions, we are entitled to answer the first only. Please re...

Q: On what amino acid do caspases specifically cleave their substrates? (Choose p20/p10 dimers cleave c...

A: The correct matching is as follows:  

Q: Construct the expression Kc for the following reaction. Sn(s) + 4 Cl:(g) = 2 SnCl-(1) 1 Drag the til...

A: Equilibrium constant : 

Q: Me CHO Me OH (COCI)2, DMSO, Et3N Ph3P .CO2Et + CH2CI2 Me Me -78 °C Me Ме Me See the Swern Oxidation ...

A:

Q: How many mL of a 6.16 M HCl solution would it take to make a 250.0 mL of a 2.10 M solution? mL

A:

Q: Draw a stepwise mechanism. CH3 ... edit structure...

A:

Q: Determine the value of K, for this reaction at the same temperature. The gas constant, Ris 0.0821 L ...

A: Given, Kp = 41.0 at 400K Gas constant, R = 0.0821 L.atm.mol-1.K-1. Temperature, T = 400K

Q: QUESTION 7 0.9699 moles of NaOH and 24.93 mL of the same NaOH solution are used during a titration. ...

A: Since you have posted multiple questions so I am solving first one for you.if you want to be solved ...

Q: What is the molality of ions in a 0.365 m solution of AICI3 assuming the compound dissociates comple...

A: • The values provided in the question are:-    i) Molality of AlCl3 solution = 0.365 m 

Q: For each system listed in the first column of the table below, decide (if possible) whether the chan...

A: Entropy is a measure of randomness of a molecule or compound or a system.  If there is greater motio...

Q: Ме Me KH, n-BU3SNCH21 Н Me Me. SnBu3 THE 13 Me Me Ме Ме

A:

Q: please explain along the answer. rate K2CR2O7 H2SO4 / H2O heptanal

A: Reaction of heptanal with K2Cr2O7 in presence of H2SO4 / H2O

Q: Review of Concepts & Facts 13.1.1 Write a balanced equation for a gas-phase reaction whose rate is g...

A:

Diol

In chemistry there are so many chemical compounds that have a hydroxyl group but a chemical compound having two hydroxyl groups (-OH) is termed as a diol. It also implies the presence of two alcohols whereas polyols contain two or more than two hydroxyl groups (-OH). Glycol or 1,2-diol is an aliphatic diol that has two alcohol groups on adjacent carbon atoms. In industries, the most commonly used diol is ethylene glycol.