Which of the following statements is true for single-slit diffraction?The intensity of interference on either side of the pattern decreases slowlyThe intensity of interference on either side of the pattern decreases rapidlyThe intensity of interference on either side of the pattern remains the same.

Which of the following statements is true for single-slit diffraction? The intensity of interference on either side of the pattern decreases The intensity of interference on either side of the pattern decreases The intensity of interference on either side of the pattern remains th

Which of the following statements is true for single-slit diffraction? The intensity of interference on either side of the pattern decreases The intensity of interference on either side of the pattern decreases The intensity of interference on either side of the pattern remains th

University Physics Volume 3

17th Edition

ISBN:9781938168185

Author:William Moebs, Jeff Sanny

Publisher:William Moebs, Jeff Sanny

Chapter4: Diffraction

Section: Chapter Questions

Problem 32P: The width of the central peak in a single-slit diffraction pattern is 5.0 mm. The wavelength of the...

See similar textbooks

Related questions

Q: 2. A rectangular loop (a = 0.15 m, b = 0.46 m) is pulled from a space where there is a uniform…

A: Givena = 0.15 m b = 0.46 mSpeed of loop = v = 4.20 m/s Resistance of the loop = 60 ohmStrength of…

Q: Group Work What is the terminal voltage of a large 1.54-V carbon-zinc dry cell used in a physics lab…

Q: The distance from the Sun to Venus is approximately 108200000 km. Assuming Venus has a circular*…

A: Assuming Venus has a circular orbit around the Sun. The distance from the Sun to Venus is…

Q: The transmitters emit the same 120 kHz signal as before, and the signals overlap when they reach the…

Q: hi the simple solution below was this taken directly from a book?

Q: ki-15Ω h=10Ω 10Ω

Q: Problem 7: A conducting rod spans a gap of length L = 0.075 m and acts as the fourth side of a…

Q: Coherent light of frequency 6.33x1014 Hz passes through two thin slits and falls on a screen 87.0 cm…

A: Frequency of light is Distance of the screen from slits is Position of the third bright fringe is…

Q: -μC particle moves through a region of where an electric field of magnitude 1250 points in the…

Q: Monochromatic light of wavelength 720 nm is incident on parallel slits, of width 0.520 mm, separated…

Q: 51. A cylinder with moment of inertia I (about its center) that is initially not rotating, falls…

Q: assume the acceleration of the object is a(t)=-32 feet per second per second. (neglect air…

Q: Problem 4: A rectangular conducting loop has sides a = 0.045 m, sides b = 0.15 m, and resistance R =…

Q: Two children pull a third child backwards on a snow-saucer sled exerting forces F1 = 9.5 Nand F2 =…

Q: Two charges are placed between the plates of a parallel plate capacitor. One charge is +q; and the…

Q: Problem 19: A 4600-pF capacitor is charged to 95 V and then quickly connected to an inductor with…

Q: The circuit in the figure (Figure 1) includes a battery with a finite internal resistance, r = 0.55…

Q: 27. A person in a spaceship passing Earth observes her own heart rate to be 75 beats / minute and…

Q: ..7 SSM www A stone is dropped into a well. The splash is heard 3.00 s later. What is the depth of…

A: The speed of the sound in the air is .The equation of the motion is

Q: A man on a motorcycle plans to make a jump as shown in the figure. If he leaves the ramp with a…

Q: A bunjee jumper has an elastic cord attached to his feet. The cord whose unstretched length is 10 m…

Q: A typical wind turbine extracts 40% of the kinetic energy of the wind that blows through the area…

A: Given Data:The mass of the wind passing the blades each second is Speed Kinetic energy is given by…

Q: A traveling sinusoidal wave is modeled by the expression of; y(x,t) = 0.1sin(25.1x-48.7t) where all…

Q: (a) What is the angular speed w about the polar axis of a point on Earth's surface at a latitude of…

Q: 45. (II) A parallel-plate capacitor with a mica sheet as dielectric has a capacitance of 50 pF. If…

Q: Suppose a 32 mH inductor has a reactance of 95 Ω. What would the frequency be in Hz?

A: KnownsUnknowns

Q: A 1.91 kg mass is initially at rest upon a frictionless, horizontal surface. An applied force of…

A: The mass of the object is 1.91 kg.The initial speed of the object is 0 m/s.The surface is…

Q: Athena is planning a flight from Toronto to Montreal, which lies due east of Toronto. Her aircraft…

Q: (numbers 47-48) A uniform solid sphere (I = 0.4MR2) of radius 0.200 m and mass 3.00 kg rolls without…

A: The moment of inertia of sphere is Radius of sphere is The mass of sphere is Angle of inclination is…

Q: What charge (in Coulombs) is on a 0.58-F capacitor when it is connected across a 71-V source?.…

Q: ectangular loop of 250 turns is 35 cm wide and 19 cm high. Part A What is the current in this loop…

A: Number of turns, N = 250 Width of rectangular loop, w = 35 cm Height of rectangular loop, h = 19…

Q: 6 A man strikes one end of a thin rod with a hammer. The speed of sound in the rod is 15 times the…

Q: A toaster oven is rated at 1900 WW for operation at 120 VV, 60 HzHz. Part A What is the resistance…

Q: A thin film of oil with an index of refraction n = 1.5 and thickness t = 55 nm floats on water. The…

A: Write the given values with the suitable variables.Here, n is the thickness.

Q: ball is thrown from the ground at an angle of 30 degrees above the horizontal with an initial speed…

A: V = 15 m/s θ = 30 °

Q: A laser emits a narrow beam of light. The radius of the beam is 9.3 mm, and the power is 4.1 mW.…

A: The radius of the beam isr=9.3 mm=0.0093 mThe power isP= 4.1 mW = 0.0041 W

Q: An object is launched with an initial velocity of 20 m/s at an angle of 26.1 degrees relative to the…

A: Initial velocity of the object is u = 20 m/sProjection angle of the object is = 26.1

Q: laser produces light waves with a beam intensity of 22 Wm-2. What will be the intensity if the…

Q: 34 Application of torque (a) Four forces are acting on an object that is free to rotate. The…

A: Here,

Q: A mass/spring system is set into simple harmonic motion having a period of 0.62 s. If the mass…

A: In general, a body is said to be in simple harmonic motion when its restoring force is in proportion…

Q: Where a, in cm-¹, is the absorption coefficient for the medium at a particular frequency. The table…

A: Absorption coefficients :

Q: What is the index of refraction of a speed of light in a certain medium A traveling at 1.77 x 108…

Q: Now, find the angle 4 shown in the figure (Figure 3)in terms of 0₁ and a. Express your answer in…

Q: Find the useful power output (in W) of an elevator motor that lifts a 2200 kg load a height of 40.0…

Q: wo oscillating systems have periods T1 and T2 , with T1 < T2. How are the frequencies of the two…

A: T12And we know frequency is given by :

Q: A small ball with mass 1.10 kg is mounted on one end of a rod 0.570 m long and of negligible mass.…

Q: 04. a. A control volume is an arbitrary volume of space through which fluid can flow. Let the…

Q: initial speed of 4 m/s. The ball travels a distance of 10 meters before coming to a stop. How long…

Q: The flywheel of a steam engine runs with a constant angular velocity of 230 rev/min. When steam is…

Q: A diffraction grating with 420 lines per millimeter produces a visible spectrum angular width of…

Concept explainers

Diffraction of light

In physics, the term diffraction is defined as the bending of light around the corners of the obstacle. As a light ray passes by an aperture, it bends around the edges or through slits, it spreads out through a narrow opening. The diffracted light will produce fringes of bright and dark or colored bands which are labeled as a diffraction pattern.

Question

Which of the following statements is true for single-slit diffraction?
The intensity of interference on either side of the pattern decreases slowly
The intensity of interference on either side of the pattern decreases rapidly
The intensity of interference on either side of the pattern remains the same.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Determine the given statement

VIEW

Step 2: Explanation of true statement for single slit diffraction

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

$Diffraction of light$

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A monochromatic light of unknown wavelength is incident on a slit of width 20 m. A diffraction pattern is seen at a screen 2.5 m away where the central maximum is spread over a distance of 10.0 cm. Find the wavelength.
Both sides of a uniform film that has index of refraction n and thickness d are in contact with air. For normal incidence of light, an intensity minimum is observed in the reflected light at λ2 and an intensity maximum is observed at λ1, where λ1 > λ2. (a) Assuming no intensity minima are observed between λ1 and λ2, find an expression for the integer m in Equations 27.13 and 27.14 in terms of the wavelengths λ1 and λ2. (b) Assuming n = 1.40, λ1 = 500 nm, and λ2 = 370 nm, determine the best estimate for the thickness of the film.
Why is it much more difficult to see interference fringes for light reflected from a thick piece of glass than from a thin film? Would it be easier if monochromatic light were used?
A beam of monochromatic green light is diffracted by a slit of width 0.550 mm. The diffraction pattern forms on a wall 2.06 m beyond the slit. The distance between the positions of zero intensity on both sides of the central bright fringe is 4.10 mm. Calculate the wavelength of the light.
A single slit of width 2100 nm is illuminated normally by a wave of wavelength 632.8 nm. Find the phase difference between waves from the top and one third from the bottom of the slit to a point on a screen at a horizontal distance of 2.0 m and vertical distance of 10.0 cm from the center.
Consider a single-slit diffraction pattern for =589 nm, projected on a screen that is 1.00 m from a slit of width 0.25 mm. How far from the center of the pattern are the centers of the first and second dark fringes?
Consider a wave passing through a single slit. What happens to the width of the central maximum of its diffraction pattern as the slit is made half as wide? (a) It becomes one-fourth as wide. (b) It becomes one-half as wide. (c) Its width does not change. (d) It becomes twice as wide. (e) It becomes four times as wide.
For 600-nm wavelength light and a slit separation of 0.12 mm, what are the angular positions of the first and third maxima in the double slit interference pattern?
A film of oil on water will appear dark when it is very thin, because the path length difference becomes small compared with the wavelength of light and there is a phase shift at the top surface. If it becomes dark when the path length difference is less than one-fourth the wavelength, what is the thickest the oil can be and appear dark at all visible wavelengths? Oil has an index of refraction of 1.40.
Into one arm of a Michelson interferometer, a plastic sheet of thickness 75 m is inserted, which causes a shift in the interference pattern by 86 fringes. The light source has wavelength of 610 nm in air. What is the index of refraction of this plastic?
Check Your Understanding Although m, the number of fringes observed, is an integer, which is often regarded as having zero uncertainty, in practical terms, it is all too easy to lose track when counting fringes. In Example 3.6, if you estimate that you might have missed as many as five fringes when you reported m=122 fringes, (a) is the value for the index of refraction worked out in Example 3.6 too large or too small? (b) By how much?
Is it possible to create a experimental setup in which there is only destructive interference? Explain.