Answered: Why is the Geometric Mean Distance…

Why is the Geometric Mean Distance (GMD) of two different conductors the same in a transmission line while the Geometric Mean Radius (GMR) of the t wo concductors are not +h

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.16MCQ: A stranded conductor is an example of a composite conductor. True False

See similar textbooks

Related questions

Q: Calculate the weight due to ice on a transmission line where the Total weight of conductor = 3.2…

Q: Explain what will happen to the characteristic impedance when the spacing between the center of two…

A: We know direct formula of two conductor transmission line.

Q: An air co-axial transmission line has a solid inner conductor of radius ‘a’ and very thin outer…

A: In the given question co-axial cable is having an inner radius "a" and outer conductor radius "b"…

Q: Q5:A terminated transmission line with Z0 = 60 has a reflection coefficient at the load of r = 0.4…

A: Given Zo = 60 Reflection coefficient at load = 0.4 ,60°

Q: A lossless transmission line has an inductance of 125 nH/m. Find the velocity factor for this line…

Q: A lossless transmission line has a capacitance per unit length of 64pF/m and an inductance per unit…

Q: find the inductance per km of a three-phase transmission line using 0.2 cm diameter conductors when…

A: Given Data: D = distance between the condutor = 1m Radius of the conductor r = 0.2 / 2 = 0.1 cm = 1…

Q: The capacitance per unit length and the inductance per unit length for a lossless transmission line…

A: Characteristic impedance (Z0) of a transmission line is defined as the impedance of the transmission…

Q: A lossless transmission line has a distributed inductance of 10 pH per meter and a distributed shunt…

A: Given data : Distributed inductance L=10×10-6H/m For 4m length L=10×10-6×4 =40×10-6 Distributed…

Q: A rectangular waveguide is terminated with an unknown load. By using a slotted line, load VSWR is…

A: VSWR : VSWR stands for voltage standing wave ratio is directly proportional to reflection…

Q: The observed standing wave ratio on a 100 Ω lossless line is 8. If the first voltage maximum occurs…

A: Given: Z0=100 Ω Standing wave ratio, S = 8 First maximum (n = 1) occur at dmax=0.3λ

Q: The 0.1A length line has a characteristic impedance of 502 and is terminated with a load impedance…

A: Given data: load impedence ZL=5+j25 ohm. characteristic impedence Z= 50 ohm With the help of smith…

Q: A straight cylindrical interconnect line is 2 mm long and 200 um in diameter. What is the fastest…

Q: A loss less transmission line of length 3.125m with characteristic impedance 502, is operating on…

A: Note :- As per guidelines we are supposed to answer only three subparts at a time. So, I request you…

Q: A 3-phase transmission line using 20 mm diameter conductor. When these conductors are placed at the…

A: As per the guidelines of Bartleby we supposed to answer first question for remaining questions we…

Q: Derive an expression for sag in a transmission line of equal height poles

A: Consider the diagram for the transmission line between two supports of of equal height as point A…

Q: Compute the following parameters inductance, Capacitance, resistance, and conductance, if you have…

Q: Why is the Geometric Mean Distance (GMD) of two different conductors the same in a transmission line…

A: We have given the following problem

Q: The capacitance per unit length and the characteristic impedance of a lossless Transmission line are…

A: It is given that, the capacitance per unit length and the characteristic impedance of a lossless…

Q: A 376-2 lossless air transmission line is connected to a complex load composed of a 749-N resistor…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: A shielded, twin-wire line has a dielectric of relative permittivity 2 and a characteristic…

Q: A loss-less 200N line is terminated on a load given by (200-j200)№. Given that the propagation…

A: the Given loss-less 200Ω line is terminated on a load 200-j200Ω The Propagation constant is…

Q: A 376-2 lossless air transmission line is connected to a complex load composed of a 749-2 resistor…

Q: A lossless 60-2 line is terminated by a 60 + j60-N load. If Z, = 120 - j60 , how far (in terms of…

A: Reflection coefficients determine how much wave is reflected at discontinuity of medium.It is given…

Q: A lossless 500 transmission line was terminated with a load of = 17.7 + j11.80. The length of the…

A: we need to calculate the reflection coefficient at the entrance.

Q: Calculate the weight due to ice on a transmission line where the Total weight of conductor = 3.6…

Q: A lossless air-filled transmission line with Z0 = 50Ω is terminated in a load with ZL = (150 - j100)…

A: Lossless air-filled transmission line with Zo=50Ω is terminated withZL=150-j100Ω.Reflection…

Q: Derive an expression for sag in a transmission line of equal hight poles.

A: We have to derive formula of sag for equal height poles in a transmission line.

Q: A transmission line has two aluminum conductors in bundle. The self GMD of each conductor is 8.90…

A: Solution !!

Q: Find the characteristic impedance and signal velocity for a transmission line consisting of two…

A: Given: A transmission line consisting of two parallel strips with a width ω and a separation d.…

Q: Question#01: A piece of RG-59B/U Coaxial cable has a nominal capacitance of 0.9 Farad/meter, and 8…

Q: A lossless transmission line has a capacitance per unit length of 64pF/m and an inductance per unit…

Q: A three phase transmission line has conductors arranged in the corners of an equilateral triangle of…

A: Inductance per phase for three phase is given Spacing between condcutors D=0.03 radius=1.5…

Q: What do you understand by impedance matching? Also write the formula of characteristic impedance for…

A: For maximum power transfer in transmission line, impedance of transmission line is equal to surge…

Q: A 90 N lossless line is 0.6A long, If S = 1.9 and 6, = -68°, use the Smith chart to find the load…

Q: In medium transmission line, capacitance is considered as O a. Lumped parameter O b. Distributed…

A: Given : Generally depending on the type of the medium we classify them parameters. Distributed…

Q: A 3-phase transmission line using 20 mm diameter conductor. When these conductors are placed at the…

A: Given that d = 20mm r = 10mm = 0.01 m D = 2.5 m 3 phase

Q: Q3. For the Figure below, find the inductance per km of a transposed double circuit three- phase…

Q: Why the Capacitance effect is neglected in Short Transmission Line.

A: The explanation is as follows.

Q: A loss less transmission line of length 3.125m with characteristic impedance 500, is operating on…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: Find the Inductance per meter of a Three-Phase Transmission Line using 1.32 cm diameter conductors…

Q: A dispersionless transmission line is one which the wave velocity is not constant as a function of…

A: In this we will write about dispersionless transmission line...

Q: A three phase overhead transmission line has its conductors arranged at the corners of an…

A: According to question: The capacitance 'C' of each line per km is calculated as

Q: A lossless 60-2 line is terminated by a 60 + j60-2 load. If Zin = 120 - j60 N, how far (in terms of…

A: The wave is function of space and time. The EM wave is formed when electric field is in contact with…

Q: A piece of RG-59B/U Coaxial cable has a nominal capacitance of 0.9 Farad/meter, and 8 Henry/m…

Q: : A single circuit three-phase transmission line is composed of four ACSR conductors per phase with…

Q: Return loss for a transmission line in terms of its reflection co efficient is given by:

A: The return loss is a parameter that is used to measure the amount of energy that is reflected back…

Q: [Q6] Determine the primary constants, R, L, G, and C for a distortion-less line working at 300 MHz.…

Concept explainers

Fiber Optics

Fiber optics is a technology used to transmit the facts such as light or pulses with fiber or plastic over long distances. Visual fibers are about the width of a human hair strand and, when tied directly to a fiber-optic cable, can transmit multiple long-distance records and faster in different ways.

Question

Why is the Geometric Mean
Distance (GMD) of two different
conductors the same in a
transmission line while the
Geometric Mean Radius (GMR)
of the two conductors are not the
same in the same transmission
line?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Conductor spacings, types, and sizes do have an impact on the series impedance and shunt admittance. True False
For a single-phase two-conductor line with composite conductors x and y, express the inductance of conductor x in terms of GMD and its GMR.
A 60-Hz, three-phase three-wire overhead line has solid cylindrical conductors arranged in the form of an equilateral triangle with 4-ft conductor spacing. The conductor diameter is 0.5 in. Calculate the positive-sequence inductance in Wm and the positive-sequence inductive reactance in /km.
In a three-phase line, in order to avoid unequal phase inductances due to unbalanced flux linkages, what technique is used?
A stranded conductor is an example of a composite conductor. True False
In terms of line-to-line capacitance, the line-to-neutral capacitance of a single-phase transmission line is Same Twice One-half
Transmission line conductance is usually neglected in power system studies. True False
For a three-phase three-wire line consisting of three solid cylindrical conductors each with radius r and with equal phase spacing D between any two conductors, the inductance in H/m per phase is given by 2107ln(Dr)4107ln(Dr)6107ln(Dr) where r=e14r=0.778r
Alumoweld is an aluminum-clad steel conductor. True False
4/ Which parameter is neglected or ignored in Short Transmission Lines? A. SHUNT CAPACITANCE ONLY B. SERIES CONDUCTANCE AND SHUNT CAPACITANCE C. SHUNT CONDUCTANCE AND SHUNT CAPACITANCE D. SHUNT CONDUCTANCE ONLY
A three-phase transposed line is composed of one ACSR Bobolink conductor per phase with a horizontal spacing of 11 meters as shown in the figure. phase with a horizontal spacing of 11 meters as shown in the figure. The conductors have a diameter of 3.625 cm and a RMG of 1.439 cm. Calculate the inductance and capacitance to the neutral of the line.
(a) A three phase transposed transmission tower comprises of three-bundled conductor and double-circuit configured in vertical position as shown in Figure 2. Each sub-conductor in each circuit and each phase is an ACSR type, size 477,000 cmil and stranding 26/7. Given the GMR of each sub-conductor is 0.8809 cm and diameter is 2.1793 cm, analyze: i. Inductance in mH/km ii. Capacitance in µF/km 0.75m 7.5m b' 4m 4m 45cm Figure 2