Write a program to multiply the contents of the PINC by 10 and store the lower byte at the RAM location Ox500 and the higher byte at PORTD LDI R16, OUT DDRC, R16 LDI R16, DDRD, R16 PINC R16, MUL R10, R16 STS Ox500. RO OUT PORTD. R1 Ox601 IN LDI R1 Ox00 OUT OXFF RO LDS MUL STS R16 10 R10

Q: Write a program to multiply the contents of the PINB by the contents of the RAM location 0x600 and…

A: The complete program is given below fill the blanks in accordance with it. IN is used to take input…

Q: Write a program that transfers 6 bytes of data from memory locations with offset of 0010H to memory…

A: It is defined as a low-level programming language for a computer or other programmable device…

Q: Write program to add (5) bytes stored at memory location start at offset [0500H), then stored at…

A: To do: Write a program to add(5) bytes stored at memory location start at offset[0500H] then stored…

Q: Write a program to set (bit 7) and clear (bit 0) of a byte wide number stored in address 0200-2460H,…

A: Actually, assembly program is a low level programming language.

Q: Write a program to set (bit 7) and clear (bit 0) of a byte wide number stored in address 0200-2460H,…

A: The answer is given below:-

Q: Q2. (30%) Write a commented 8085 assembly language program to replace the already stored 05…

A: Question :-

Q: What will be the value stored in address 0007H when the given code is executed. Given value at…

A: Assembly language program storing value of addition in memory location 007H

Q: What will be the value stored in address 0007H when the given code is executed. Given value at…

A: Required:- What will be the value stored in address 0007H when the given code is executed. given…

Q: What will be the value stored in address 0007H when the given code is executed. Given value at…

A: We are asked the value that stored in the address 0007H. LDA is a 3 byte instruction, that load the…

Q: What will be the value stored in address 0007H when the given code is executed. Given value at…

A: Solution:

Q: Write a program to set in 8060 (bit 7) and clear (bit 0) of a byte wide number stored in address…

A: Solution: For setting the msb bit we first use the bitwise operator OR ,that is OR with 80 since AX…

Q: write a program that compare two blocks of 64 consecutive bytes, the first block starting at address…

A: the solution is given below

Q: Write a program to sub a block of (100)10 consecutive bytes of data string at offset address 3000H…

A: I attached your answer below.

Q: Write a sequence of instructions to read a word of data from an input port at the memory-mapped…

A: answer is  option b  B. MOV AL,FFH ---> MOV [B0H],AL

Q: Q1/ write a program that compare two blocks of 64 consecutive bytes, the first block starting at…

A: The answer is given below:-

Q: rite a program in 8085 to find a summation of positive numbers for a set of numbers stored at memory…

A: Move 00 to B register immediately for the purpose of carry. Load the information of memory [3000]…

Q: Write a program to store six bytes of data in the memory location 0600h. Find the average of the…

A: The stream outline for the program is displayed in given figure. In the wake of instating the…

Q: Question2: Write an ALP that load the content of BX reg (1A1AH) to memory location That addressed by…

A: Algorithm –   Load the first number from memory location 2050 to accumualtor.  Move the content of…

Q: Assume that the followings are the outputs of ps and jobs commands and answer the following…

A: Given: Assume that the followings are the outputs of ps and jobs commands and answer the following…

Q: 1 Consider the following Intel Hex file :1000000075805575905575A0557DFA111C7580AA9F…

A: Answer 1: value of 6th part is 35. Figure 1

Q: Write a program which adds the values D8H, F5H and E9H. Put the sum in file register 15H for (low…

A: Code for the above question is given as: Write a program that adds the values D8H, F5H, and E9H. Put…

Q: Write a MIPSZY program to load 2 ordered pairs of integers from memory, the compute delta y and…

A: Given: Write a MIPSzy program to load 2 orderedpairs of integers from memory, thecompute delta y and…

Q: Given the following output similar to inclass10 but with hexadecimal output: doubles 7274152(long) =…

A: Answer: I have given answered in the handwritten format

Q: write a program in ( assembly language (8086) )that compare two blocks of 64 consecutive bytes, the…

A: The assembly level programming 8086 is based on the memory registers. A Register is the main part of…

Q: 3. Implement a 32-bit subtraction of two numbers X and Y that are stored in memory as: X = (DS:…

A: Hi there, Please find your code below, I tried as fast as i can to answer the question, I hope you…

Q: The index registers are the(a) AX, BX, CX, DX (b) SP, BP, IP (c) DI, SI (d) CS, DS, .2 ES, SS What…

A: I have given an answer in step 2.

Q: Question/ program give below run on 8086 used to add two 32-bit number. Fill the missing code to…

A: The correct answer is given below:

Q: Homework 1. Write a machine program to add data at 5005H & 5006H memory location and store the…

A: Given: Write a machine program to add data at 5005H & 5006H memory location and store the result…

Q: Write a complete program that continually sends the alphabet (uppercase) to the device attached to…

A: The serial port is the hardware port which will be acting as a medium of communication with or from…

Q: wnite the output of the program! * nclude Ih+ mam () Int a=2,b33, C; înt * p1 , * P 2, P3; mt DESJ=…

A: - We have to show the output and the table for addresses.

Q: Write a program to compare two numbers which stored in memory locations ( 203A H) and (2040 H).…

A: Algorithm Load value in the accumulator Then, copy the value to any of the register Load next…

Q: Question/ program give below run on 8086 used to add two 32-bit number. Fill the missing code to…

A: Given code:- MOV AX,3000H MOV DS,AX MOV AX,4000H MOV ES,AX MOV SI,0000H MOV DI,0000H MOV CX,04H…

Q: Consider the string of data '#. The ASCII value of data # is 23 H which has to be moved from source…

A: The memory is divided into four segments: Code Segment (CS) Data Segment (DS) Stack Segment (SS)…

Q: write an ALP to copy 4 bytes of data from memory location 2500h to 3500h?

A: To execute a program written in high level language must be translated into machine understandable…

Q: Question/ program give below run on 8086 used to add two 32-bit number. Fill the missing code to…

A: Task:  An assembly code is given is the question in which some lines are missing so our task is to…

Q: Question/ program give below run on 8086 used to add two 32-bit number. Fill the missing code to…

A: Task:  Our task is to fill the missing block of codes.

Q: There is a short part of an ASM85 assembly program. Which are the memory bytes whose content is…

A: The processor may access one or more bytes of memory at a time. Let us consider a hexadecimal number…

Q: Using Emu8086, write an ALP that will print the sum of two (2) variables X and Y to memory OBSSH if…

A: answer is below:-

Q: 3. Write a program to add multi bytes (16-bit wide), the source address in SI = 0500H and the…

A: Numbers vs. Data The main idea is to perceive the distinction between a number and the information…

Q: 3. Write a program to add multi bytes (16-bit wide), the source address in SI = 0500H and the…

A: Given:

Q: Write a program in assembly language to compares the elements of two arrays, A(1) and B(1), each…

A: Comparing elements of array A(I) and B(I) After comparing, if two arrays are unequal, store the…

Q: Write a program that adds 250 unmarked 8-bit numbers stored in consecutive SRAM cells from the…

A: SRAM: Static RAM, memory contents do not need periodic refreshing, SRAM cell is typically…

Q: A program declares a variable that is 8 bytes long at address 0x0C. A .align 2 is written after that…

A: ANSWER:

Q: نقطة واحدة let AX=1235H,SS=1233H and SP=1234H and after the execution POP AX the SP is 1234H O 1238H…

A: 1. The SP(stack pointer) is at 1234H. In POP instruction, after each execution of the instruction,…

Q: 2. Use the defined GPR of TMP (it is a DATA) and RST (It is an ADDRESS), present your ASM codes that…

A: Answer :  a).  TMP - 0XDF -> Result in W  Operation: SP-2→SP,  PC+2→@SP dst→PC. Temp→ 0X  (.W)…

Q: Which of the following is example of loopback address?

A: The correct answer of the questions is option("d") "127.0.0.1"

Q: The following block of data is stored in the memory locations from XX55H to XXSAH. Transfer the data…

A: Requirements:-   Do it on https://www.sim8085/ .. Code with output is needed   Approach:- Run a…

Q: Write a program for 8051 microcontrollers to copy 20 numbers from location 45 to 64, add 94 with it…

A: We need to Write a program for 8051 microcontrollers to copy 20 numbers from location 45 to 64, add…

Q: Consider the program given below. RETMON EQU OFO00H EQU OFOH ORG 100H START MOV A,#35H MOV R1,#46H…

A: Explanation;- MOV A, #35H => A <- 0x35 MOV R1, #46H => R1 <- 0x46 ORL A, R1 => A…

Q: Suppose we have two arrays A[10] and B[10]. Write a MIPS code that does the following: It compares…

A: Please find below the MIPS code for swap numbers with given condition:         swapElements(int*,…