Write the answer of each of the following questions in brief with respect to OSI layer model: 1. Reliable process-to-process message delivery Answer 2. Route selection Answer 3. Defines frames Answer 4. Transmission of bit stream across physical medium Answer
Q: Q3: Consider that the values of parameters for the stop and wait ARQ protocol are as given below-…
A: Useful data sent = Transmission delay of useful data bytes sent = Useful data bytes sent / Bandwidth…
Q: Figure 1 Network Subnet/Mask No. of Host Address Range Broadcast Address LAN Segment 1 LAN Segment…
A: The given network Address is = 200.201.202.0/24 The given address is class C address. The…
Q: The physical layer translates logical communication requests from the ______ into hardware specific…
A: Dear Student, The Data link layer present just above the physical layer sends the logical…
Q: Write the answer of each of the following questions in brief with respect to OSI layer model:…
A: Given: Write the answer of each of the following questions in brief with respect to OSI layer model:…
Q: The term synchronization has many meanings in Computer Science. Within the networking field, the…
A: Synchronization Synchronization is defined as the devices and events are coming all together and…
Q: Draw a block diagram of a single carrier digital transmitter and corresponding receiver for the…
A: Please upvote. I am providing you the correct answer below. Please please please.
Q: 1) Consider a Transport layer segment with size of 8000 bytes includes an IP header of 20 bytes no…
A: Given Data : ID = 555 MTU = 1500 Total Data = 8000
Q: Consider a selective repeat sliding window protocol that uses a frame size of 2 KB to send data on a…
A: Given the Frame Size as 2KB, Bandwidth=4Mbps Latency =60ms, which is also known as Propagation delay…
Q: Which layer of the ISO/OSI Reference Model would be responsible for encryption or compression during…
A: Given: Which tier of the ISO/OSI Reference Model would be responsible for delivering this service if…
Q: What are the differences and similarities between congestion and packet loss in computer networks?…
A: Packet loss means whenever the data is transmitted from one host to another host, the packets or the…
Q: Name the two host-tohost layer protocols important to remember
A: The two host-tohost layer protocols important to remember are:-
Q: Suppose two hosts (Host-A and Host-B) are connected through a shared Ethernet bus of 1 Mbps. The…
A: Note: There are multiple questions are given in one question. According to the rule, you will get…
Q: Data is sent over a network from a source to a destination. The data cannot be sent until it has…
A: Data is sent over a network from a source to a destination. The data cannot be sent until it has…
Q: Question 1 a) Give the names of the layers of the OSI standard that address the following issues:…
A: Given: Fill in the blanks.
Q: The physical layer is responsible for converting logical communication requests from the into…
A: Given: The physical layer is responsible for converting logical communication requests from the into…
Q: An ARP query is delivered inside a broadcast frame for a reason. Why is an ARP response transmitted…
A: Introduction: ARP sends a request packet to all of the computers on the LAN, inquiring as to whether…
Q: Write the answer of each of the following questions in brief with respect to OSI layer model:
A: Answer: 1. Reliable process-to-process message delivery: A transport layer is used that is reliable…
Q: In OSI model dialogue control and token management are responsibilities of Network layer O Data link…
A: Ans: In OSI model dialogue control and token management are responsibilities of : d) Session layer
Q: a broadcast framework? What is the purpose
A: ARP request is sent as broadcast because initially it don't know the particular target MAC address…
Q: 6. Match the following to one or more layers of the OSI model: a. Route determination b. Flow…
A: We need to match the columns with layers of OSI model.
Q: Suppose, through the Data link layer a message is passing from Sender to Receiver. That message…
A: What is DLL(Data Link Layer) The Data Link Layer is the second layer in the OSI model, above the…
Q: SO/OSI Reference Model would be responsible for encryption or compression during a communication…
A: SUMMARY OSI Reference ModelSession- The fifth layer of the OSI model, which is responsible for the…
Q: Describe clearly ,step by step ,and layer by layer,the operation that takes place when passing a…
A: This procedure takes place in a switching network when the datagram crosses an intermediate node:…
Q: QUESTION 9: Assume the usage of Go-Back-7 (N = 7) ARQ sliding window protocol for flow and error…
A: Here in this multiple question we have given a sliding window (GB7) .and we have asked to find no of…
Q: The physical layer is in charge of coordinating the functions required to send a bit stream via a…
A: Introduction: The physical layer is in charge of moving individual bits from one hop (node) to the…
Q: Which layer of the OSI Model is responsible for bit-bit delivery in networking?
A: 1) The OSI(Open Systems Interconnect) model explains all the individual functions that are necessary…
Q: In the Internet, the datagrams transmitted by IP datagrams are assembled at the final destination…
A: Advantages of Reassembly of IP datagrams at final destination host: Assembling IP datagrams at…
Q: 3. Fill in the blanks. a) The function of a order to provide for an orderly and efficient use of…
A: Given:
Q: Compare three classes of Medium Access Protocols (MAC) channel partitioning, random access and…
A: Channel Partitioning Protocols ========================== Time Division Multiplexing (TDM) and…
Q: Match the Protocol Data Unit (PDU) with the OSI layer. Layer 1 v [ Choose ] Segment Packet Frame…
A: Here in this question we have asked to match the osi layer with thier data unit term.
Q: QUESTION 16 Select the correct statement(s) regarding Frame Relay (FR). a. FR is a connectionless…
A: Frame Relay is a highly efficient WAN protocol that operates on physical and data interface layers…
Q: Which layer manages the transmission of data across a physical link and is primarilyconcerned with…
A: The layer that manages the transmission of data across a physical link and is primarily concerned…
Q: Design a MAC protocol for an access network where N nodes generate data continuously at a constant…
A: 1st is thar each node transmit at constant rate x bit/sec
Q: 6- Bits can be sent over guided and unguided media as analog signal by a) digital modulation b)…
A: 6)Bits can be sent over guided and unguided media as analog signal by -‐-------------…
Q: a) Give the names of the layers of the OSI standard that address the following issues: • Handling of…
A: The OSI model layers are:- Physical layer Datalink layer Network layer Transport layer Session…
Q: 1.5.1 Show the sequence of start, data, and stop bits that are generated during asynchronous…
A: 1.5.1 Show the sequence of start, data, and stop bits that are generated during asynchronous…
Q: 3.4-8 Channel utilization with pipelining. Suppose a packet is 10K bits long, the channel…
A: Correct answer - (C) 0.1
Q: An ARP query is delivered within a broadcast frame for a reason. Why is an ARP response transmitted…
A: Introduction: For the purpose of explaining how to submit an ARP request as a broadcast message,…
Q: 1) A protocol data unit on Layers 5 to 7 is generally referred to as a a) Segment b) Frame c)…
A: The OSI Model (also known as Open Systems Interconnection Model) can be understood as a conceptual…
Q: The lower layers of the OSI network model provide datagram service, with no delivery guarantees for…
A: Below are the advantages and disadvantages of supporting reliable message delivery at the lowest…
Q: Write the answer of each of the following questions in brief with respect to OSI layer model: 1.…
A: 1. Reliable process-to-process message delivery => Transport layer Transport layer: Transport…
Q: Compare the different streaming data delivery protocols with respect to the following points: I.…
A: Compare the different streaming data delivery protocols with respect to the following points: I.…
Q: Use again the network architecture provided in the figure above, were Rs, Rc and Ri for i =…
A: Given :- Use again the network architecture provided in the figure above, were Rs, Rc and Ri for i =…
Q: Given that the data connection layer is capable of detecting mistakes between hops, why do you…
A: Because the data link layer can find some errors, we need a different way to check for them at the…
Q: How big would the window size have to be for the channel utilization to be greater than 98 percent…
A: As given:- The transmission rate of the link (R) = 1Gbps = 109 bits/sec. The round-trip…
***Please don't use handwirting***
Step by step
Solved in 2 steps with 1 images
- Write the answer of each of the following questions in brief with respect to OSI layer model: 1. Reliable process-to-process message delivery Answer 2. Route selection Answer 3. Defines frames Answer 4. Transmission of bit stream across physical mediumChannel utilization with pipelining. Suppose a packet is 10K bits long, the channel transmission rate connecting a sender and receiver is 10 Mbps, and the round-trip propagation delay is 10 ms. What is the channel utilization of a pipelined protocol with an arbitrarily high level of pipelining for this channel? 1.0 0.1 0.001 0.01 10.0 Not quite. Your answer is incorrect.Write the answer of each of the following questions in brief with respect to OSI layer model: 1. Reliable process-to-process message delivery Answer 2. Route selection Answer 3. Defines frames Answer 4. Transmission of bit stream across physical medium Answer
- Consider the figure below. The IP and MAC addresses are shown for nodes A, B, C and D, as well as for the router's interfaces. Consider an IP datagram being sent from node D to node A. Give the source and destination Ethernet addresses, as well as the source and destination addresses of the IP datagram encapsulated within the Ethernet frame at points (5), (4), (2), and (1) in the figure above.Explain the OSI layer's operation and its seven protocols.Assume a small communication network, consisting of two user stations and a base station (BS). The users are recording and transmitting data collected by sensors and are transmitting the data frames using frequency band BW, (uplink). BS only collects data and acknowledges them. It uses a different band BWBs (downlink) for transmissions. The uplink and downlink channels are assumed perfect; no packets are lost due to bit errors. An Aloha protocol is used to access the medium by the BS and users. The users generate traffic following Poisson distribution, with frame generation rate lu. The time duration of data frames is Tf whereas the duration of acknowledgements is TAck: Determine the probability that the frame generated by a user will be lost.
- 4. In this problem, you will derive the efficiency of a CSMA/CD-like multiple access protocol. In this protocol, time is slotted and all adapters are synchronized to the slots. Unlike slotted ALOHA, however, the length of a slot (in seconds) is much less than a frame time (the time to transmit a frame). Let S be the length of a slot. Suppose all frames are ofIn term of encapsulation, please explain how a message from Source can be transmitted toDestination. Please explain what happen in each layerGive a brief review of the pros and cons of using connectionless protocols instead of connection-based ones.
- Suppose a new CSMA/CD protocol is designed for a 100 Mbps bus network with topology similar to 10Base2. The minimum frame length is 40 bytes. What is the maximum length of the longest cable connecting two nodes so that the collision detection mechanism still works? Write symbolic equations (e.g. using d=distance, R=data rate, etc.) and derive the solution. Explain with words what is going on.The term synchronization has many meanings in Computer Science. Within the networking field, the term is usually used to describe making asynchronous communication synchronous (A coordination of activities; running at the same rate) We see synchronization occurring in different layers, but we are mostly concerned with the physical layer and the data link layer (L1 and L2). a) In what ways is synchronization in these two layers similar? b) In what ways is synchronization in these two layers dissimilar?Consider an application which transmits data at a bursty rate (e.g., the sender generates data for short burst of time and the sender is idle almost all the time)Would a packet-switched network or a circuit-switched network be more appropriate for this application?Why?