-Xo -Tost

Q: The characteristics equation of a system is given below. Using routh's stability criterion determine...

A: Routh Hurwitz  necessary but not sufficient  condition for stability is a)The coefficient of all ter...

Q: ind the value of R that will yield a low pass filter for C =1µF with a cutoff frequency of 3kHz R +....

A:

Q: Compute for the value of the impedance load that will absorb a maximum average power.

A:

Q: In the circuit in Figure 3, the op-amp is ideal. Find the output voltage vo- R2 3 kn R, 1 kn OUT R3 ...

A: In this question,  Find the output voltage Vo.  Op amplifier have virtual property.   

Q: Draw the complete logic diagram from the given logic equation, maximum of 2 inputs per gates used. L...

A: In this question,  Draw the logic diagram of the 2 input gates.  We know 1+A= 1 (AB)' = A'+B'  

Q: Design a D- Flip flop using 2:1 Mux.

A: Latch is asynchronous device. It is level triggered device. It check input and change output corresp...

Q: B- Calculate the efficiency of a class B amplifier for a supply voltage of Vec = 24V with peak outpu...

A:

Q: 4.70 Determine the maximum power delivered to the variable resistor R shown in the circuit

A: It is given that:

Q: a. Graphical location of Poles and Zeros in the z-plane. b. Unit step-response assuming initially re...

A: A transfer function is a mathematical description of the relationship between a linear time-invarian...

Q: 27. A 4-pole 1200 rpm generator with a lap wound armature has 65 slots and 12 conductors per slot. T...

A:

Q: 2. Which element dictates the maximum level of source voltage? R. Ans: Izm 220 A Vz- 20 V 1.2 kn IZM...

A: In the question,  Find the element dictates the maximum level os source voltage?  We know Is = Iz + ...

Q: Use mesh analysis to calculate the voltage Vo, if R = 72 and Is = 37. %3D

A: a mesh is a loop that does not enclose other loops. KVL, states that “in any closed loop network, th...

Q: B- Calculate the efficiency of a class B amplifier for a supply voltage of Vcc = 24V with peak outpu...

A:

Q: The carrier frequency is 600 Hz, and the modulating signal is a single-tone sinusoidal signal. The x...

A: In this question,  Amplitude of the modulating signal  Vm= 1V Carrier signal amplitude Vc= 2V Find t...

Q: h3(t) = {e, 0, 1<t< 3 elsewhere

A: Find the energy and power of the given signal ?

Q: 1. Use Kirchhoff's laws to find the current flowing in the 60 resistor of Fig. and the power dissipa...

A: Find current through 6 ohm resistor and power dissipated by 4 ohm resistor ?

Q: Generate the state table and diagram of the circuit.

A: Consider the given circuit,

Q: The open-circuit voltage of a storage cell is 2.4 volts. The terminal voltage, measured when the cur...

A: In this question given The open-circuit voltage of a storage cell =2.4 volts. The terminal voltage, ...

Q: 1. For the system with the impulse response h(n) =(0.25)" u(n), derive a solution for y(n) within th...

A: Impulse response is h(n)=(0.25)nu(n) Input is x(n)=(0.4)nu(n) y(n)=x(n)*h(n) when x(n)*h(n) is conv...

Q: 6. Consider a directional antenna that has a gain of 10 dB and radiates 20 Watts. How much power an ...

A: EIRP is used to measure the effective power in one direction from an ideal isotropic source. The Dir...

Q: Consider the Z-transform of the impulse response h(n) shown below. If we define y(n) as the output o...

A: To solve above problem, one should know about transfer function of a system. Transfer function of a ...

Q: How many identical collectors would we need to get overall efficiency of 95% if each collector has e...

A:

Q: Determine the current flow is a circuit having a resistance of 5Ω on 110 volts and 240 volts supply.

A: If n number of resistor having resistance R1,R2.....................Rn is connected in parallel then...

Q: 1. Determine the total Z,RT, XT, total current, and total power in the circuit. Z1 Z2 Z3 (3 + j4) (2...

A:

Q: In the circuit shown below, the external resistance connected across the terminals of the battery is...

A:

Q: Determine the current if a 20 coulomb charge passes a point in 0.25 seconds. a) 10 A b) 20 A c) 2 A ...

A: Given: Charge, Q = 20 coulomb Time, t = 0.25 sec

Q: In the circuit shown, a 6-Ohm resistor connected in series to a parallel combination of two resistor...

A: In the the circuit shown, a 6-Ohm resistor connected in series to a parallel combination of two resi...

Q: Describe/draw each applicable term: 1. Draw Encoder,Decoder, Multipleser and their application. 2. A...

A: Encoder In general an encoder is a device or process that converts data from one format to another. ...

Q: Question 4. For the entire circuit in Fig. 4, calculate: (a) The power factor (b) The true power (c)...

A: In this question we will find power factor ,true power and reactive power....

Q: 1 (mA) t(us) 2 3 4 5 6 7

A: We need to calculate effective value means RMS value

Q: Given two independent 1st order recursive systems with complex constant coefficients as described in...

A:

Q: Q-1: A- A CS amplifier has Cc = Cc2 Cs luF, R. = Rg1//Rg2 10 MQ, Rsig = 100k2, 9m = 2 mA/V, Rp = R =...

A: 1) mid gain of Cs amplifier given by Amid = - gm×RD||RL  

Q: Referring to the circuit shown below, determine the following: (a) The voltage between points e and ...

A:

Q: A n-p-n bipolar transistor has impurity co 1ons of in the emitter base, and collector, respectively....

A: Since you have asked multiple questions, we will solve the first question for you. If you want any s...

Q: In the given Boolean function F(A,B,C,D,E)) = E (0,1,4,5,16,17,21,25,29) %3D +d(20,24,26,28), what i...

A: As per company guidelines we are supposed to answer only one question. Kindly repost other questions...

Q: The carrier frequency is 600 Hz, and the modulating signal is a single- tone sinusoidal signal. The ...

A: Time axis of the graph shows the time period of modulated AM  If we do diffrence in time at two peak...

Q: 七 8) What is the total resistance between node A and node B? (: B. a) 452 42 A 0.5SL b) eM 8. 2ohm A...

A: If two resistors RA , RB are connected in series than equivalant series connected resistance is(RA +...

Q: Determine the total impedance, current and voltage to each of the three impedances. Z1 = 6-j8 ; Z2= ...

A:

Q: Two resistors R1 and R2 of 12 Ω and 6 Ω(the current through the 6-ohm resistance is 0.8 Amperes) are...

A:

Q: 2. Draw the spectrum of Xo1(f), Xo2(1) and X(f) 10 Xo1(1) -700 Hz 700 Hz 5 cos(3000nt) X(t) 15 Xo2(t...

A: We need to find out frequency response for given signal .

Q: If the natural frequency of a PLL is 5 MHz, and the upper pull-in range is 5.1 MHz, determine the wi...

A: Given: The natural frequency of a PLL is 5 MHz, and the upper pull-in range is 5.1 MHz. fn=5 MHzfc=5...

Q: Longitudinal Submarine Dynamics Velocity The dynamics of a controlled submarine are significantly di...

A: Control systems 

Q: what is meant by sensor bias voltage

A: what is meant by sensor bias voltage

Q: se superposition to solve for the voltage Vo if Is =14 and R = 90. %3D Is 2Ω ww 10 Vo 4Ω 20 V 40 V +...

A: We will use krichoff's current law to calculate output voltage.

Q: Determine I1, I2 and I3 using SOURCE TRANSFORMATIONS

A: The solution can be achieved as follows.

Q: 3.2 Analyse the following figure and answer the given questions + 9V 220uF 100nF 10uH 105mw 10nF 98....

A: 1) 100n it is coupling capacitor and also used to separate AC and DC   

Q: Se sabe que sin importar si el interruptor se encuentre en a o en b, la corriente I que fluye es la ...

A:

Q: Branch 1 Branch 2 R, = 1.2 kN R3 = 180 N + V = 15 VE R2 = 1.8 kM R4 = 820 N %3D a. What is the total...

A: Find all the parameters like current through resistors and voltage across resistors ?

Q: Q What is the difference between NAND gate and negative AND gate'

A: A Not gate is a logic gate whose output  is invert of input applied. OR gate is a logic gate whose o...

Q: Why do two switches connect to the paddle fan? Slow/Fast Speeds One for Light/O...

A: We are authorized to answer three subparts at a time. Since you have not mentioned which part you ar...