3 You are an avid rock collector and you are polishing your latest finds in a tumbler (Figure 1.1). Thecontents of the tumbler become unbalanced during polishing with an eccentricity of 2 cm.System Paramcters:C= 15 Ns/mk = 150 N/mkz = 50 N/mM = 2 kgm = 0.5 kge = 2 cmw = 50 rad/s(a) Derive the steady-state response of the tumbler with the given system parameters.(b) What is the magnitude of the force transmitted to the ground?Total Mass: Mmk1Figure 1.1: Rock turmbler ystem for Problem t.Peablem 1 Wirktww

Answered: Image /qna-images/answer/8a52682c-f65a-4ba6-b853-1e9914c1b062.jpg

You are an avid rock collector and you are polishing your latest finds in a tumbler (Figure 1.1). The contents of the turmbler become unbalanced during polishing with an eccentricity of 2 cm. System Parameters: C= 15 Ns/m k = 150 N/m kz = 50 N/m M = 2 kg m = 0.5 kg e = 2 cm = 50 rad/s (a) Derive the steady-state response of the tumbler with the given system parameters. (b) What is the magnitude of the force transmitted to the ground?

You are an avid rock collector and you are polishing your latest finds in a tumbler (Figure 1.1). The contents of the turmbler become unbalanced during polishing with an eccentricity of 2 cm. System Parameters: C= 15 Ns/m k = 150 N/m kz = 50 N/m M = 2 kg m = 0.5 kg e = 2 cm = 50 rad/s (a) Derive the steady-state response of the tumbler with the given system parameters. (b) What is the magnitude of the force transmitted to the ground?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

1 An object of mass 125 kg is released from rest from a boat into the water and allowed to sink. While gravity is pulling the object down, a buoyancy force of times the weight of the object is pushing the object up (weight = mg). If we assume that water 40 resistance exerts a force on the object that is proportional to the velocity of the object, with proportionality constant 10 N-sec/m, find the equation of motion of the object. After how many seconds will the velocity of the object be 90 m/sec? Assume that the acceleration due to gravity is 9.81 m/ sec2. Find the equation of motion of the object. X(t) = %3D
(Q-4) Balance the meter stick with two weights and a rock. 0 cm 100 cm Jrock 100g position (cm) weight (gwt) lever arm (cm) torque (gwt cm) Rock 10.60 XXXXXX XXXXXXXX Weight 1 구군, 60 150 cw Weight 2 93.5 100 (Q-5) Assume that the torques balance and use this fact to calculate the weight of the rock. Z Tecw Złcw = Wrack
1. Find: Vs, wa/c, and wa/A Use relative motion analysis OR Instantaneous center of rotation Given: 0= 58° @=39° BC=3m AB=9m V₁ = 12 m/s your choice mak 437 B
(b) A system of mass rotation rod has been run at = 40 rad/s as shown in Figure Q1. The system has the following data, (i) (ii) Mass Mass A Mass B Mass C Weigh 1.2 kg 1.8 kg Mc Radius 1.135 m 0.822 m Re Angle 113.4° 48.8° вс Find counterweight mass-radius product and its angular location needed to balance the system. Distinguish the relationship between mass, radius and angle for counterweight mass system.
(2) Please write out the Equation of Movements of the following system using matrix. (Figure 2) 1 Note: Lagrange's approach is recommended. „P₂(t) ks ww P₁(t) k₁ wwm, www k₂ m₂ k6 www P3(t) k₁ k3 www m3 www Figure 2: N Degree Vibration System
A four-bar mechanism is used to transmit power to slider E. Link AC rotates counterclockwise at 100 rpm. A and B are fixed points. The following linkages are measured in cm: AC=35, AB=70, CD=45, BD=45, DE=40. Find the instantaneous velocity of slider E in cm/s 1.Draw the mechanism in appropriate scale on your paper2. Find the instantaneous linear velocity of C3. Find a point on your paper to draw the velocity polygon and scale the magnitude of the computed linearvelocity4. Use the relative velocity equation for finding the linearvelocity of D; ? = ? + ?? ? ?/?5. Remember that although the magnitudes are unknown, their directions can be identified6. Obtain the magnitudes of the unknown velocities from the velocity polygon7. For Link DE, repeat the process by using ? = ? + ??the line as much as needed8. Remember that E is a SLIDER therefore it can only goin the direction where its movement is not constrained? . Add the vector ? to the head of ? and extend?/? ?/??
Classwork for PHYS220-A-Ali Sabbah-SP2021 Beirut Sec-A Beirut (MW 09:30-10:45) google.com/u/0/w/Mjc5NTQzMDc5NTgz/t/all PHYS220 Spring/20-21 Practice Sheet-1 Keys 1) A0.1 kg object oscillates as a s At a position X,, the object has a kinetic energy of 0.7 J and a potential energy 0.3 J. The amplitude of oscíllation, A, is: (a) 0.12 m (b) 0.22 m aple harmonic motion along the x -axis with a frequency f 3.185 Hz. (c) 0.31 m (d)0.42 m EJE the
Chapter 07, Problem 027 Z Your answer is partially correct. Try again. A spring and block are in the arrangement of the figure. When the block is pulled out to x = +4.0 cm, we must apply a force of magnitude 370N to hold it there. We pull the block to x = 11.0 cm and then release it. How much work does the spring do on the block when the block moves from x, = +5.0 cm to (a) x = +4.0 cm, (b) x = -4.0 cm, (c) x= -5.0 cm, and (d) x = -10.0 cm? x=0 Block F= 0 attached elleeee to spring (a) x positive F, negative (b) ugen/shared/assignment/test/aglist.uni?id=.. x negative 9:34 PM search A ENG 4/4/2021 ASUS 13) 1ghome f10 snd 17 4 7. 00 16 3.
My question and answer is in the image. Can you please check my work? A 2 kg mass is attached to a spring with spring constant 50 N/m. The mass is driven by an external force equal tof(t) = 2 sin(5t). The mass is initially released from rest from a point 1 m below the equilibrium position. (Use theconvention that displacements measured below the equilibrium position are positive.)(a) Write the initial-value problem which describes the position of the mass. 2y"+50y=2cos(5t) (b) Find the solution to your initial-value problem from part (a). (1+(1/2)tcos(t))cos(5t)-(1/2)tcos(t) (c) Circle the letter of the graph below that could correspond to the solution. B (d) What is the name for the phenomena this system displays? Resonance
ull JAWWAL ? 6:20 PM @ 50% A moodle.najah.edu МOODLE Recent - For the following system, answer the following assuming each tension in cable = 10 kN 1) Express tensions in Cartesian coordinate system 2) Find moment due to both cables and weight of door= 1 kN about point A 3) Find moment due to both cables and weight of door= 1 kN about z-axis 960 mm 450 mm 90 mm 675 mm B 90 mm 690 mm 270 mm Fig. P4.113 II
ki= 15 N/m; k2 = 10 N/m; m, k3 = 12 N/m; %3D ci = 1 N.s/m; m2 k,Z c C2 = 2 N.s/m; C3 = 2 N.s/m; m3 mı = 25 kg; 7 kg; m2 = m3 = 15kg; solve the mathematical model.
1:19 P N{ l 100% I A docs.google.com A block of mass m = 2 kg is attached to a spring with spring constant k = 200 N/m, and is set to oscillate on a friction-less horizontal surface. At time t = 0 its position is xO = 0 and its velocity is vo = +5 m/s. If the displacement is a cosine function, x(t)=A cos(wt+p), then which answer is correct about the oscillation amplitude A and the phase constant,p,: A = 0.25 m, and p = - T/2 A = 0.5 m, p = 0 A = 0.5 m, and p = r/2 A = 0.5 m, p = -T/2 A = 0.25 m, and p = t/2 Other: A body oscillates with simple harmonic frictionless motion along the x-axis. Its displacement varies ith time according to x(t)=0.5 cos(Tt). The ues of the velocity (in m/s) and acceleration (in m/s^2) of the 8 II