. Look at the circuit to the right. The EMF=25V, L=150mH, R₁=1000, and R₂=500. a. What is the current in the inductor the moment the switch is closed? b. What is the current in the inductor after the switch has been closed for a long time? c. What is the energy in the inductor 5.12ms after the switch is closed? rooo L ·E R₁ R₂

. Look at the circuit to the right. The EMF=25V, L=150mH, R₁=1000, and R₂=500. a. What is the current in the inductor the moment the switch is closed? b. What is the current in the inductor after the switch has been closed for a long time? c. What is the energy in the inductor 5.12ms after the switch is closed? rooo L ·E R₁ R₂

Physics for Scientists and Engineers with Modern Physics

10th Edition

ISBN:9781337553292

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter31: Inductance

Section: Chapter Questions

Problem 8P

See similar textbooks

Similar questions

(a) What is the characteristic time constant of a 25.0 mH inductor that has a resistance of 4.00 ? (b) If it is connected to a 12.0 V battery, what is the current after 12.5 ms?
The healing coils in a hair dryer are 0.800 cm in diameter, have a combined length of 1.00 m, and a total of 400 turns. (a) What is their total self-inductance assuming they act like a single solenoid? (b) How much energy is stored in them when 6.00 A flows? (c) What average emf opposes shutting them off if this is done in 5.00 ms (one-fourth at a cycle for 50 Hz AC)?
Your RL circuit has a characteristic time constant of 20.0 ns, and a resistance of 5.00 M (a) What is the inductance of the circuit? (b) What resistance would give you a 1.00 ns time constant, perhaps needed for quick response in an oscilloscope?
A large research solenoid has a self-inductance of 25.0 H. (a) What induced emf opposes shutting it off when 100 A of current through it is switched off in 80.0 ms? (b) How much energy is stored in the inductor at full current? (c) At what rate in waits must energy be dissipated to switch the current off in 80.0 ms? (d) In View of the answer to the last part, is it surprising that shutting it down this quickly is difficult?
A transformer is used to supply a 12-V model train with power from a 110-V wall plug. The train operates at 50 W of power, (a) What is the rms current in the secondary coil of the transformer? (b) What is me rms current in the primary coil? (c) What is the ratio of the number of primary to secondary turns? (d) What is the resistance of the tram? (e) What is the resistance seen by the 110-V source?
One application of an RL circuit is the generation of lime-varying high voltage from a low-volt age source as shown in Figure P32.82. (a) What is the current in the circuit a long time after the switch has been in position a? (b) Now the switch is thrown quickly from a to b. Compute the initial voltage across each resistor and across the inductor. (c) How much time elapses before the voltage across the inductor drops to 12.0 Y?
(a) What is the voltage output of a transformer used for rechargeable flashlight batteries, if its primary has 500 turns, its secondary 4 turns, and the input voltage is 120 V? (b) What input current is required to produce a 4.00 A output? (c) What is the power input?
Unreasonable Results A 25.0 H inductor has 100 A of current turned off in 1.00 ms. (a) What voltage is induced to oppose this? (b) What is unreasonable about this result? (c) Which assumption or premise is responsible?
A solenoid 50 cm long is wound with 500 turns of wire. The cross-sectional area of the coil is 2.0 cm2. What is the self-inductance of the solenoid?
(a) Calculate the self-inductance of a 50.0 cm long, 10.0 cm diameter solenoid having 1000 loops. (b) How much energy is stored in this inductor when 20.0 A of current flows through it? (c) How fast can it be turned off if the induced emf cannot exceed 3.00 V?
Two ideal inductors, L1 and L2, have zero internal resistance and are far apart, so their magnetic fields do not influence each other. (a) Assuming these inductors are connected in series, show that they are equivalent to a single ideal inductor having Leq = L1 + L2. (b) Assuming these same two inductors are connected in parallel, show that they are equivalent to a single ideal inductor having 1/Leq = 1/L1 + 1/L2. (c) What If? Now consider two inductors L1 and L2 that have nonzero internal resistances R1 and R2, respectively. Assume they are still far apart, so their mutual inductance is zero, and assume they are connected in series. Show that they are equivalent to a single inductor having Leq = L1 + L2 and Req = R1 + R2. (d) If these same inductors are now connected in parallel, is it necessarily true that they are equivalent to a single ideal inductor having 1/Leq = 1/L1 + 1/L2 and 1/Req = 1/R1 + 1/R2? Explain your answer.