Answered: .What volume of 1.37 M nitric acid is…

.What volume of 1.37 M nitric acid is needed to convert 9.0 g of m-bromophenol to 3-bromo-4,6-dinitrophenol? (No excess of nitric acid is used.) Specify the units on the volume.

Macroscale and Microscale Organic Experiments

7th Edition

ISBN:9781305577190

Author:Kenneth L. Williamson, Katherine M. Masters

Publisher:Kenneth L. Williamson, Katherine M. Masters

Chapter28: Nitration Of Methyl Benzoate

Section: Chapter Questions

Problem 1Q

See similar textbooks

Related questions

Q: How do you expect the composition of cyclohexane and toluene to change over the course of a…

A: Distillation is a very important technique used to separate organic compounds. It is of four types,…

Q: The melting point of salicylic acid is higher than that of acetylsalicylic acid. Explain why this is…

A: The compounds given are salicylic acid and acetylsalicylic acid.

Q: Explain the role of trisodium citrate, Na3C6H5O7 as a component of the Benedict’s reagent for the…

A: A question based on redox reactions in qualitative analysis of organic sample, which is to be…

Q: 2. How would our experimental results change if a less polar mobile phase was used such as butanol…

A: In a reverse phase chromatography, the solid stationary phase is non-polar in nature and the liquid…

Q: Give at least three characteristics of chloroform that make it a good extracting solvent for the…

A: In nature alkaloids are found either as acidic salts or free bases.

Q: Which method would be most appropriate for accomplishing the removale of trace amounts of acetic…

A: Answer

Q: what volume of 1-pentanol is needed to convert 1.50 grams of benzhydrol to n-pentyl benzhydrol ether

A: This is the reaction that takes place

Q: Question attached

Q: In the esterification experiment, the organic phase of diethyl ether is washed with 2 portions of 5%…

A: When carboxylic acid (R-COOH) and alcohol (R-OH) reacts with each other, the production of ester…

Q: How can the Eugenol content be separated from the alkaline solution?

A: Eugenol also known as clove oil. This oil is extracted from cloves and is used to treat toothache,…

Q: Diethylacetal can be detected by gas chromatography. How does this impurity arise in fermentation?

A: The fermentation product of sugar is ethanol.

Q: Why ethanol is added to the residue in the distillation flask Why is this important

A: liquid ethanol can be separated from a mixture of ethanol and water by fractional distillation. This…

Q: How many phases did you observe when the naphthalene and p-dichlorobenzene were dissolved? What does…

Q: At normal temperature, 5-bromoacetylsalicylic acid melts at 60 °C and is inert and nearly insoluble…

Q: How could you separate a mixture of ethanol, 1-pentanol and 1-octanol. Discuss the steps in your…

A: Fractional distillation is a type of distillation which involves the separation of miscible liquids.…

Q: Determine the theoretical yield of 3-nitrobenzamide based on starting with 0.50 g of 3-nitrobenzoic…

A: We have given that reaction : 3-Nitrobenzoic acid to 3-Nitrobenzamide so we have given that mass…

Q: Impure 1,4-dimethoxybenzene was dissolved in methanol and then immediately placed in an ice-water…

A: Some time a compound need to crystalline to get in the pure form.

Q: Dehydration of 2-Methylcyclohexanol underlies the Evelyn effect, which is defined as the phenomena…

Q: In your experiment, Na2CO3 and K2CO3 were differentiated by flame test. describe the expected…

A: A flame test is an analytical procedure used in chemistry to detect the presence of certain…

Q: 2. Please explain what is A and B in the separating funnel when using NaOH to extract…

A: Extraction is a separation technique use to separate any compound from mixture. Common extraction…

Q: When we do an organic chemistry experiment, what is the explanation for a melting point below what…

A: A melting point below the literature value for a compound indicates the presence of impurities in…

Q: What type of deviation is shown by a mixture of ethanol and acetone? What type of azeotrope is…

A: Azeotrope is a mixture of two liquids having the same composition and have constant boiling points.…

Q: Why should you use a minimum amount of water to rinse the conical vial while transferring the…

A: This is a process of the collection of the crude and pure acetaminophen crystals, that are formed by…

Q: What is main objectives in extraction of lycopene from watermelon.

A: Lycopene Lycopene, a red pigment, is widely present in foods that are red in colour, including…

Q: When a solution of 1.00 g of X in 100 cm3 of water was shaken with 10 cm3 of ether, 0.80 g of X was…

A: Formula used w = W KD×VKD×V+ vn Where KD = distribution coefficient V = Volume of water = 100 cm3 =…

Q: What is the theoretical yield and limiting reagent for the reaction of benzophenone with sodium…

Q: Nitration of Phenol 1. What volume of 1.00 M nitric acid is needed to convert 4.0 g of…

A: Given:- 1.00M nitric acid is needed to convert 4.0 g of m-methylphenol to 3-methyl-2,…

Q: What is the effect of an insoluble impurity, such as charcoal, on the observed melting point of a…

Q: 5-bromoacetylsalicylic acid melts at 60 °C and is inert and almost insoluble in water at room…

A: Since you have asked multiple questions, we will solve first one for you. For any particular…

Q: if 54.9% of ethenol is in the distillate what would be the sloute and the solvent in the mixture?…

A: Given that, % of ethanol = 54.9% then,

Q: Why does the eugenol move from the water layer to the dichloromethane layer during extraction?

A: In separation process, aqueous and organic layer gets separated.

Q: Using the end-group analysis to find molecular weight, 6 mol of 1,4-butanediamine reacted with 6 mol…

A: The polymer formed from the given monomers: H2N-(CH2)4-NHOC-(CH2)4-COOH

Q: How many grams of cyclohexene should be produced in this experiment, if 20.0g of cyclohexanol are…

Q: Why is it important to collect the distillate into a test-tube that is immersed in an ice-bath? To…

Q: why is fractional distillation a better method of separating 1-chlorobutane and toluene than simple…

A: Simple distillation method is used for the separation of compound having 1 volatile compound. If…

Q: Would an organic liquid with a density of 1.006 g/mL make a good extraction solvent? Explain.

A: Density is very important characteristic to keep in mind while choosing the solvent for extraction…

Q: 1) Calculate the volume of the concentrated sulfuric acid required. 2) What precautions are required…

A: Above equation is necessary for calculate the volume of concentrat H2SO4

Q: Why is it more difficult to recrystallize benzil when using hexane as a solvent instead of ethanol?

A: Recrystallization is a process of purifying compounds by dissolving the crude sample of the given…

Q: Why is eugenol steam-distilled rather than purified by simple distillation?

A: Eugenol, also called clove oil, is an aromatic oil extracted from cloves that is used widely as a…

Q: How many moles of monofunctional A must be added to a mixture of one mole of B2 and one mole of A3…

Q: Why is dilute ethanol used as a slovent for the assay of salicylic acid?

A: Here we have to determine the reason of using dilute ethanol as a solvent for the assay of…

Q: What is the dominant intermolecular force that governs the solubility of 9-fluorenone in methylene…

A: Like dissolves like principal said that polar compounds including ionic compound should be more…

Q: A chemist desires to dehydrate 1-octanol. What is the expected product, and would a higher or…

A: When 1-Octanol is treated with c. H2SO4 at an elevated temperature (> 170°C) then 1-octene is…

Q: What are the intermolecular forces present in acetone?

A: Note: As per company policy we are supposed to attempt first question only , please repost other…

Q: 4. Why do you suppose a mixture of ethanol and water instead of simply water itself is used for…

A: Saponification reaction involves the reaction of hydrolysis of triglyceride Eester of fatty acids…

Q: How many millimoles of Na3PO4 are contained in 800 mg of this reagent?

A: Given The mass of Na3PO4 is 800 mg.

Q: How do you rationalize the fact that the cyclohexane A value for phenyl (2.8) is bigger than that…

A: The A values explains the bulky nature of substituents in a cyclohexane. The energetic preference of…

Question

.What volume of 1.37 M nitric acid is needed to convert 9.0 g of

m-bromophenol to 3-bromo-4,6-dinitrophenol? (No excess of nitric acid is

used.) Specify the units on the volume.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Give an example of an azeotrope and give one method/technique that people have used to separate an azeotropic mixture. a) Are cyclohexane and toluene an azeotropic mixture? Why or why not?
Is chlorophyll soluable in 2-propanol? Why or why not?
Is distillation a good method for separating a mixture of heptane and 1-propanol? Why or why not?
You have a mixture of an aryl halide and a carboxylic acid that you wish to separate(both are solids). Both are soluble in diethyl ether. Explain ALL the steps you would take to obtain the two compounds in pure form from your sample.
You have a mixture of an aryl halide and a carboxylic acid that you wish to separate (both are solids). Both are soluble in diethyl ether. Explain ALL the steps you would take to obtain the two compounds in pure form from your sample.
How can we predict if 1- propanol is mixed with distilled water? Are the mass and volume conserved? When you mix two gases what can we predict about the conservation of volume in this case?
A) the possible methods to purify cyclohexene from cyclohexanol and other materials produced in the reaction. B) explaining why distillation is an ideal choice
Give the products formed when benzaldehyde and benzoic acid are treated with the given reagents. a. Tollen’s reagentb. phenylhydrazine, H+c. HCNd. NH2OHe. 1 mole H2, Nif. 1 mole CH3OH, H+g. LiAlH4 then H2O, H+h. 2 moles CH3OH, H+i. CH3MgCl, then H2O, H+j. H2O
a) If 14.5g of 2-propanol was used along with an excess of NaOCl, what would be the theoretical yield? b) If 6.5g of product is collected, what would be the percent yield?
1. What boiling point of the following mixture of compounds. Then, which would boil first? And Finally, indicate what type of distillation will you use to separate them.
4. Why do you suppose a mixture of ethanol and water instead of simply water itself is used for saponification?
1. Draw structural formulas for 1-bromobutane, 2-bromobutane, 2-bromo-2- methylpropane, 1-bromo-2-methylpropane, and 1-bromo-2,2-dimethylpropane. Classify each compound as a primary halide, secondary halide, or tertiary halide. 2. Draw structural formulas for acetone and ethanol. Which solvent is more polar? Explain. 3. A student wishes to determine the rate law for the reaction A +B → C. The student doubles the concentration of A while holding the concentration of B constant and finds that the rate of the reaction doubles. The student then doubles the concentration of B while holding the concentration of A constant and finds that the rate is unchanged. Write the rate law for this reaction. (Refer to a general chemistry text, if necessary.) Experimental Procedure S a