1. A solution containing 5.0 g of n-butyric acid in a 100 mL of water was extracted two times with 25-mL portions of chloroform. Given the distribution coefficient, K, for chloroform-water, is 5.0, calculate thetotalamount of n-butyric acid extracted from the water. Show all calculations.

1. A solution containing 5.0 g of n-butyric acid in a 100 mL of water was extracted two times with 25-mL portions of chloroform. Given the distribution coefficient, K, for chloroform-water, is 5.0, calculate thetotalamount of n-butyric acid extracted from the water. Show all calculations.

EBK A SMALL SCALE APPROACH TO ORGANIC L

4th Edition

ISBN:9781305446021

Author:Lampman

Publisher:Lampman

Chapter81: Extractions, Separations, And Drying Agents

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Consider 15 mL of an aqueous solution containing 2.0 g of an organic solute. If the distribution…

Q: What effect would the following have on the value of your Ksp value (Increase, decrease, or no…

A: Ksp value is the solubility product of any salt when it is dissolved in an aqueous medium. a.) While…

Q: 2.1g of sample are dissolved in methylene chloride and the sample is extracted with an aqueous…

Q: What will be the composition of the vapor when a mixture containing 0.30 of A was subjected to…

Q: For a two-solvent recrystallization, you should have one solvent (solvent # 1) in which your desired…

A: In the process of crystallization first the solid compound is dissolved (In solvent 1) at boiling…

Q: 1.Describe other melting point apparatus that are available for routine analysis. 2. Explain the…

A: Melting point apparatus that are available for routine analyis:-

Q: Why is water not a good recrystallization solvent for sodium benzoate? a. Sodium benzoate is…

A: Water is not a good recrystallization solvent for sodium benzoate.

Q: Is there a difference when the needle or metal clip is placed on the surface of distilled water with…

Q: 0.100 g sample of phthalic acid was dissolved in 100 mL of water. When 25 ml of diethyl ether was…

A: Introduction- Solvent extraction is a process where 2 immiscible solvents are separated along with…

Q: Write the balancing equations for C,H, and O.:)

A: Since you have asked multiple questions, we will solve first one for you. For remaining question…

Q: Alkaloids present in 20.0 grams of dried leaves containing 0.20% w/w of alkaloids was completely…

A: Mass of alkaloid can be evaluated as: Mass of dried leaves=20.0 gramsMass of alkaloid in dried…

Q: omega-3/g oil, respectively. Calculate the omega 3 extraction efficiency for each temperature based…

A: Weight of kernels crushed for extraction of omega-3 = 5 g (i) From the % yield, calculate the amount…

Q: To determine the soil distribution coefficient (Kd), 10 g of dry soil is spiked with 100 mg of…

A: The distribution coefficient Kd can be calculated using the expression: Kd=Atrazine present in…

Q: Enumerate at least two important things to do to maximize yield when using vacuum filtration in the…

A: Aspirin is produced chemical synthesis from salicylic acid, through acetylation with acetic…

Q: Assuming a concentration distribution ratio of 20, make calculations to show which is more…

Q: The distribution constant for iodine between an organic solvent and water is 75. Find the…

A: Given the distribution constant, KD = 75 Volume of aqueous layer(water), Vaq = 100 mL molarity of…

Q: An analyst wanted to separate an essential oil which is partially immiscible in water and a boiling…

A: to separate an essential oil which is partially immiscible in water and a boiling point higher than…

Q: Why is the washing of crystals on the filter paper not as effective a process of purification as…

A: Since there are multiple questions, we will answer only the first one. If you require the answers to…

Q: Accurately prepare a 50cm stock solution of (approx.) 0.003M potassium permanganate solutic Very…

A: Given that: the volume of potassium permanganate solution = 50 cm3 the volume of potassium…

Q: Derive the formula for the critical extent of reaction. Using the percent conversion at the gel…

Q: Suggest methods (aside from recrystallization) that can increase the purity of aspirin in the final…

A: The question is based on the concept of qualitative aspects of the experimental chemistry. we have…

Q: at Levothyroxine dissolves in water, at least to the extent necessary for this problem.) Use…

A: Given : volume of solution to be made = 50 mL Hence volume of solution in L = 50 / 1000 = 0.050 L…

Q: Five grams of Compound A is dissolved in 100 mL of water. The distribution coefficient for Compound…

A: Let x g of Compound A will be in the hexanes (5−x) g of compound A will remain in water. Given, KD…

Q: Why do we not need "spitless" injection to measure the toluene content of gasoline using gas…

A: Given : Splitless injection. To find : Reason for using Splitless injection in gas chromatography.…

Q: What is the correlation between distribution coefficient and polarity? There is 0.17 g of benzoic…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: After the extraction of benzoic acid from 0.5g impure sample, the weight of pure benzoic acid in the…

A: The given data- The weight of the impure sample = 0.5 g The weight of the pure benzoic acid = 0.4 g…

Q: Write TRUE if the underlined word/phrase makes the statement correct. Otherwise, write the correct…

A: According to Q&A guidelines of Bartleby, we are supposed to answer only the first 3 sub-parts of…

Q: In this experiment, you will take a 25.00 mL aliquot of vinegar and dilute it to 250.0 mL. You will…

A: Suppose, concentration of acetic acid in diluted vinegar solution is S1 M To determine S1 the…

Q: When is a PTFE buret used? _________________________________________________________ _…

A: PTFE: Polytetrafluoroethylene is a material from which stopcock is made and fitted into the glass…

Q: Give the molar concentration of HCl with a specific gravity of 1.18 and has 37.0 % (w/w) purity. (

A: Give the molar concentration of HCl with a specific gravity of 1.18 and has 37.0 % (w/w) purity.

Q: Why would it be possible to get less than 100% recovery for a recrystallization?

A: The question is based on the concept of recrystallization. recrystallization is a purification…

Q: In a chromatographic analysis, a solution containing 0.0837M toluene and 0.0666M xylene resulted in…

A: Response factor can be represented as

Q: Q2/A mixture of A and B is to be separated by distillation Xf=0.45, concentration of distillate is…

A: The net movement of mass from one location to another is called mass transfer, which usually means…

Q: A student recrystallized some impure benzoic acid and isolated it by filtration. He scraped the…

A: Recrystallization can be defined as the process in which old arrangement of particles in the crystal…

Q: 12 g of compound “Y” dissolves in 10 ml of acetone at 25 0C and 0.85 g of the same compound…

A: The necessary condition to recrystallize any impure sample is that the solubility should be…

Q: The distribution coefficient between methylene chloride and water for solute Y is 15. An amount of…

A: Distribution coefficient simply denotes how a compound is distributed in a mixture of two immiscible…

Q: The

A: Given: Data tabulation on Limonene (ug/ml) & Response of Detector is given Response…

Q: (c) What is the minimum distribution ratio that permits removal of 99% of a solute from 50.0 mL of…

Q: A mixture of benzoic acid and naphthalene was separated by a liquid-liquid extraction by converting…

A: Here we have to choose the correct option about how can be the benzoic acid can be recovered after…

Q: Which of the following statements about fractional distillation are true.? Select all that are True.…

A: Solution : Fractional distillation is a type of distillation technique that is used to…

Q: A mixture of 5 mL of acetone (boiling point 56 ° C) and toluene (boiling point 111 ° C) was…

A: Volume of mixture= 5 mLGiven,Mixture contains acetone and touleneboiling point of acetone= 56…

Q: You have 100 mL of a solution of benzoic acid in water; the amount of benzoic acid in the solution…

A: Volume of benzoic acid solution = 100 mL Mass of benzoic acid in solution = 0.30 g Distribution…

Q: Extraction of the aqueous salicylic acid solutions with 10% ethyl acetate/hexane (density ~ 0.7…

A: As you have posted two independent questions in a single request, we will solve the first question…

Q: Indicate with (+) or (-) if the test compound is soluble or insoluble in the solvent. Is Acetanilide…

A: Solubility of organic compound depend on the nature of functional group present

Q: A compound has a distribution coefficient of 14 between water and diethylether. If 350 mg are…

A: Given the distribution coefficient between water and diethyl ether, K = 14 Here the organic phase is…

Q: Why is a calibration curve necessary for experiment of determination of phosphate in water?

A: In analytical chemistry, a calibration curve, also known as a standard curve, is a general method…

Q: Write all the steps of recrystallization of impure naphthalene from methanol. How to identify the…

A: In this question, we have to find out the correct answer of given problem by the help of…

Q: A tea bag containing 15 grams of tea leaves with 0.7% of caffeine was used in solid-liquid…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

Approximately 6 mL of concentrated perchloric acid (72%) was transferred to a bottle and diluted with about 1.0L of water. A sample containing 250.0 mg of primary standard sodium tetraborate (NazB407 .10H2O, FW= 381.42 g/mol) was dissolved in 50.00 mL water and required 27.25 mL of the HCIO4 solution to reach the methyl red end point. A 25.00 mL solution of an unknown NH3 sample required 13.24 mL of the HCIO4 solution. Calculate the molarity of the NH3.
Based on the table below, calculate F-factor and X in the water sample. (Berdasarkan jadual di bawah, kirakan faktor-F dan X dalam sampel air.) 7. Abs nitrite concentration Standard 0.032 0.4ppm Xppm Water sample 0.067
Students were tasked to conduct a recrystallization experiment to test the ability of the three newly discovered solvents in their laboratory to purify and separate a mixture containing compounds X and Y. The solubilities of the two compounds in g/50 mL of hot and cold solvents are given in the table: Calculate value of filtrate and precipitate of hot and cold filtration of each Solvent (1,2,3).
1a. Use the given table to construct a temperature-composition diagram for cyclohexane Toluene mixture. Based on the plot, what is the composition of the distillate obtained by Simple distillation 20 mole percent cyclohexene and 80 mole percent toluene? Show your Work on the plot. 1b. Estimate the composition of the distillate of 20 mole percent of cyclohexane if the Distillation column had three theoretical plates.
Hexanoic acid was added to an immiscible biphasic solvent system, water and CCl4 at 20.0OC and the equilibrium concentrations of hexanoic acid were determined to be 3.66 g/L in H2O and 67.0 g/L in CCl4. Caluclate the distrubution coeffiecent (D2) of hexanoic acid in water with respect to CCl4.
The separation and purification processes given below and the method used against them are given. Which or which of these pairings are correct? Brewing the tea - Extraction Purification of water from impurities-Chromatography Separating olive pomace from oil while olive oil is being produced - Decantation Obtaining oil fractions - Ordinary distillation Obtaining essential oils and using them in perfume making - Water-steam distillation A. I, IV, V B. I, II, III, IV, V C. I, II, V D. I, II, III, V E. I, II, III, IV
An organic compound has a distribution coefficient of 1.5 in methylene chloride and water. If 50 mg of this compound is dissolved in 15 mL of water, in which case will more of the compound be extracted into the methylene chloride: one extraction with 15 mL of methylene chloride or three extractions using 5 mL of methlene chloride each time? Show all work.
Why was the tea extract washed with three separate portions of 20 ml of CH2Cl2 instead of 60 ml at once? Use the concept of the distribution coefficient, KD, to support your claim. Assume that the KD for caffeine in a water/dichloromethane system is 7.8
The distribution constant, Kp, for compound A between toluene and water is 9.65. What is the concentration of compound A remaining in the aqueous phase after 30.0 mL of 0.295 M A is extracted with each quantity of toluene indicated? one 25.0 mL portion: [A]] %3D M two 12.5 mL portions: [A]2 = M five 5.00 mL portions: [A]5 = M ten 2.50 mL portions: [A]10 i M
Students were tasked to conduct a recrystallization experiment to test the ability of the newly discovered solvents in their laboratory to purify and separate a mixture containing compounds X and Y. The solubility of the two compounds in g/50 mL of hot and cold solvents are given by the photo.
(DV 20 ml. of an aqueous solution of 2 mmol butyric acid is shaken with 10 mL ether. After the layers are separated, it was found that 0.5 mmol of butyric acid remains in the aqueous layer. Calculate "D" and "%E".
1 gram of a substance is soluble in 100 mL of cold acetone and in 25.0 mL of boiling acetone. A student performed recrystallization starting with 0.220g of the same crude substance dissolving it in 5.0 mL of acetone. What is the maximum percent recovery of the substance?