5. The figure below represents the anatomy of the lower limb when balanced on your toes and the body weight acts through the tibia. The Achilles Tendon makes an angle () of 8° with the vertical and for this foot x1 is 6.2 cm and x2 is 12.3 cm. Calf Muscle Tibia Achilles Tendon Calculate the tension (T) in the Achilles Tendon if a 70 kg man stands on the toes of both

5. The figure below represents the anatomy of the lower limb when balanced on your toes and the body weight acts through the tibia. The Achilles Tendon makes an angle () of 8° with the vertical and for this foot x1 is 6.2 cm and x2 is 12.3 cm. Calf Muscle Tibia Achilles Tendon Calculate the tension (T) in the Achilles Tendon if a 70 kg man stands on the toes of both

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Two masses are attached to a uniform meter stick as shown in the figure below. The masses of m1 and m2 are as given and the meter stick weighs 150 g. A force F with unknown magnitude is applied on one end of the stick at an angle of 30° to balance the system. 30 cm 40 cm 30 cm 30° m1 50 g m2 75 g slImstimee (a) What is the magnitude of F? (Ans: 6.21 N) (b) What are the reaction forces on the support? (Ans: Rx = 5.38 N; Ry = 5.80 N)
Two blocks are connected by a (massless) string that passes over a (massless, frictionless) pulley as shown. Assume the interface between block A and the horizontal tabletop to be frictionless. pulley If mA = 6.3 kg and mg = 8.8 kg, what is the tension in the string? Express your answer in N, to at least one digit after the decimal point.
20 kN 20 kN 3 m H 3 m 60 kN 4 m Determine the force and nature in the member JD. JD = Blank 1 kN Nature = Blank 2 for the nature put C for compression and T for tension. Blank 1 Add your answer Determine the force and nature in the member BC. BC = Blank 1 kN Nature = Blank 2 for the nature put C for compression and T for tension. Blank 1 Add your answer Blank 2 Add your answer Determine the force and nature in the member CD. CD = Blank 1 kN Nature = Blank 2 for the nature put C for compression and T for tension. Blank 1 Add your answer Blank 2 Add your answer
Two weights are hung over two frictionless pulleys that are connected by a wire rope to a 500 Ib horizontal block that are in between and below them. The wire rope attached to the upper left end of the block and to the left pulley is at 45 degrees with the horizontal and the wire rope that connects the upper right end of the block to the right pulley is at 30 degrees with the horizontal. If the weight on the left pulley is 50 lb, fs= 0.30 and fk = 0.20 on the surface of block what weight W on the right pulley will cause the 500 lb block to just start moving to the right? *
Renkler Vertically positioned 0A mast weighing 1500N A ball joint at point 0, cables AB and AC is kept in balance. Like the pole 20 kN will occur in each cable when force is applied determine the force (Dimensions in m) 7. 20 kN 21
A gardener uses a 60-N wheelbarrow to transport a 250-N bag of fertilizer. What force must she exert on each handle? (There are two handles and the force is distributed equally to each of them.) 0.15 m 250 N 60 N -0.7 m- -0.15 m
F1 F2 a F3 A d. F4 Consider the following values: - F5 a = 13 m; b = 8 m; c = 10 m; d = 5 m; F1 = 3 kN; F2 = 11 kN; F3 = 2 kN; F4 = 20 kN; F5 =2 kN; a = 30° e = 60° B = 30°
The figure shows the Russel fracture traction device and a mechanical model of the leg. The leg is held in balance in the position indicated by the two weights attached to the two cables. The combined weight of the leg and the cast is W=210 N. The horizontal distance between points A and B where the cables are attached to the leg is L=100 cm and the vertical distance is d=6 cm. Point C is the center of gravity of the cast and leg at three quarters of the L measured from point A (3L/4= 75 cm). The angle that cable 2 makes with the horizontal is measured as β=33°. Accordingly, in order for the leg to remain in balance in the shown position; a) Find the tensile force T1 in cable 1. (Write your result in N) b) Find the tensile force T2 in cable 2. (Write your result in N) c) Find the angle α of cable 1 with the horizontal.
During the push-off phase of a running stride the ground reaction force under the 1* metatarsal was measured to be 900.95 N at 30°. At this instant the triceps surae (gastrocnemius-soleus complex) is pulling on the calcaneus with a force of 1,222.75 N at an angle of 65°, and the tibialis anterior muscle is pulling with a force of 484.33 N at an angle of 60° on the medial cuneiform bone. The mass of the runner is 62 kg. Assume that the foot is a single rigid body, no other ankle musculature is active and the system is static. NOTE: All angles are reported relative to the right horizontal. Complete the free-body diagram of the foot shown below. a. What is the net horizontal talocrural joint reaction force? b. What is the net vertical talocrural joint reaction force? c. What is the magnitude of resultant talocnural joint reaction force? d. What is the orientation of the resultant țalocrural joint reaction force relative to the right horizontal?
A 68.4 kg man stands on his toes by exerting an upward force through the Achilles tendon, as shown in the figure. Part (a) In units of newtons, what is the magnitude of the force through the Achilles tendon if he stands on one foot? Part (b) Calculate the force in units of newtons at the pivot of the simplified lever system shown. That force is representative of forces in the ankle joint.
A 4.2‑kg brown hare walks on a horizontal beam (the beam's mass m = 2.8 kg and length a = 2.4 m). The beam is suspended with two ropes attached to the ends of the beam. What should be the distance between the hare and the left end of the beam so that the tension in the left rope is three times as big as the tension in the right rope? 1. The distance from the left end, b = If the hare is at the distance found in the previous question, calculate the tension in each rope. 2. The tension in the left rope, T1 = 3. The tension in the right rope, T2 = ------------------------------------------------------------------ A bike wheel has a radius of R = 0.62 m and a mass of m = 2.6 kg spins at 270 rpm. What is the angular momentum of the wheel? Assume that the wheel has a shape of a ring. The angular momentum of the wheel, L ? A typical bowling ball might have a mass of 7 kg and a radius of 12 cm. How fast the ball should spin to have the same angular momentum as the wheel from the…
The lumbar portion of the human spine supports the entire weight of the upper torso and the force load imposed on it. We consider here the disk (shaded red) between the lowest vertebra of the lumbar region (L5) and the uppermost vertebra of the sacrum re- gion. (a) For the case L 0, determine the com- pressive force C and the shear force S supported by this disk in terms of the body weight W. The weight W, of the upper torso (above the disk in question) is 68% of the total body weight W and acts at G,. The vertical force F which the rectus muscles of the back 25 mm G1 W L3 L4 L5 G2 4r exert on the upper torso acts as shown in the figure. (b) Repeat for the case when the person holds a weight of magnitude L W/3 as shown. State any assumptions. F Sacrum 300 mm \50 mm