60 u(-t)V 30 10 20 3 120 V -2) VC(t) ve İC(t) 'yi bulunuz. 8 40 5 u(t)A + Vc(t) 45V F Icht)

Q: Combinational logic circuits' results are entirely dependent on their inputs.

A: Combinational logic circuits : There are mainly two types of logic circuit one is combinational…

Q: What range of output voltage is developed in the circuit of figure below if the I₁=0.066 mA, I₂ =…

A:

Q: 2. The current passing through a resistor in a circuit is 0.01 A when the voltage across the same…

A: Given data, In a resistor, current I1=0.01 A when the voltage across it is V1=5 V. To determine the…

Q: Design parabolic reflector antenna operates on frequency of 12GHz and has gain of 20dbi for…

A: Given Data: Frequency f=12GHz Gain=20dbi

Q: (i) (ii) Explain what happens to a BJT transistor in active mode and what its main application at…

A: When p side of diode is at higher potential than n side it is forward bias. When p side of diode is…

Q: Explain what is band bending and why it occurs when two dissimilar materials like p-type and n-type…

A: What is Band bending in semiconductors?

Q: Q. 13. When a bank of capacitors is disconnected from the power system, interruption takes place A)…

A: When a bank of capacitors is disconnected from the power system, interruption takes place when A)…

Q: A sequential logic circuit's outputs are dependent on both the inputs and the previous output. O a.…

A: A sequential logic circuit's outputs are dependent on: Options are: Both the inputs and the…

Q: Q. 17. In secondary ionization by photons: A) Electrons are emitted from the cathode. B) The photons…

A: In secondary ionization by photons: A) Electrons are emitted from the cathode. B) The photons give…

Q: 7.1 In the circuit in Fig. P7.1, the voltage and current expressions are v=160e-10V, 120t: i =…

A: the voltage and current expression of series RL circuit is given it is asked to find the values of…

Q: get? B) Determine the cutoff frequency of an op-amp having specified values Unity- Gain bandwidth of…

A:

Q: The uncertainty in an ammeter is 0.1A and the uncertainty in measurement of power is 30 watts. If…

A: Given- Uncertainty in ammeter = 0.1 A, Uncertainty in power measurement = 30 watts, Ammeter reading…

Q: 8. Determine the output X for typical combinational logic circuit (a) (b) (a) 1 A B Σ WJ Σ Cout (b)…

A: it is asked to find the output of given 2 combinational logic circuits

Q: In the circuit below, V, 2 Volts, R₁ = 80, R₂ = 70. Find the Voltage v across R₂. Give you answer to…

A: Given circuit,

Q: An NPN transistor is used in the amplifier circuit of figure 1. The characteristic IB = f(VBE) is…

A: According to the question, for the given circuit as shown below

Q: Find the natural response of the circuit

A: Theory: Under steady state L - short C - open Case 1)  α<ω0 (underdamped)x(t)=x(∞)+e-αt[C1cosωdt…

Q: 6. A BJT current source is designed as shown below, where QREF= Q₁. If IREF= 5 mA, determine Rp to…

A: A BJT current source is designed as shown in the figure, Where,Qref=Q1If IREF=5mAand…

Q: NMOS Cascode Amplifier with Source Degeneration and Miller Capacitance VBIAS VIO ID k VTH VA CM 11…

A:

Q: The Thevenin voltage for the circuit is A) 5.0 V B) 10 V C) 6.67 V D) 8.33 V

A: Given data, Circuit diagram is given as,

Q: Combinational logic circuits' results are entirely dependent on their inputs.

A: Circuits A circuit is a fully enclosed circle through which electricity travels. A current source,…

Q: The following signal is periodic with the period of y [n] = cos(0.1mm) + 2 sin(0.1km) samples

A: Given data, Signal is given as, yn=cos0.1πn+3sin0.1πn.

Q: Write an expression for the current i,(t).

A: Given :  Resistance R1=910Ω, Resistance R2=8.2 kΩ, Voltage Source VS = 0.05 sin4638t.

Q: 3. Determine the Thevenin's and Norton's equivalent circuit of the given network. lov ԵՂ M 15.0 F…

A: Given circuit,

Q: he node (busbar) and branch (line) data of a power system are provided in Table Q1.1 and Table Q1.2…

A: Given data, The slack bus reference node is Node 1 Busbars 1 and 2 are buses with generators. A load…

Q: Q12. In the circuit Fig.Q12, C is fully charged before the switch is moved to discharge. Current…

A: In d.c. analysis, under steady state condition,, a capacitor will behave as Open circuit. The…

Q: A FM wave is represented by the following equation, V=9sin (5 x 10ft +3sin1300t) Find: a) Carrier…

A: Given data,, FM wave is represented as V=9sin5×104t+3sin1300t.

Q: Draw the per-phase equivalent circuit of a three-phase squirrel-cage induction machine. List all of…

A:

Q: A PID controller is designed to control the robot leg, and the control system is shown in Figure 2…

A: Type of control system Closed-loop control system  The more accurate response even in the case on…

Q: A series circuit contains 0.1-H inductor, 0.1 μF capacitor and 2.5-k resistor. A voltage source 100…

A:

Q: A unity feedback system has a plant transfer function described by G(2) as follows: 1 G(z) = 22-72…

A: Given transfer function is :G(z)=1z2−7z+11

Q: Q. 25. A Rogowski coil is required to measure a 2 A current at a frequency of 4 kHz. The voltmeter…

A: 25. Given data Current value, I=2 A Frequency, f=4 kHz The time period is ten times that of the time…

Q: 1) The AC circuit shown in Figure Q3-1 is expressed in the phasor domain. Given that V₁ = 50 Z V…

A:

Q: G/ Desing non-inverting OP-amp Cir Cuit to get Gain 50

A:

Q: a second-order process is controlled using a P controller with a feedback closed-loop control…

A:

Q: current in R3 resistor

A:

Q: 1. Explain the different between active high and active low input with positive and negativ…

A:

Q: (3) Determine the initial value of the function f(t), where: S 4s (b) F(s) = 2s +9s +6 (a) F(s) = s²…

A: F(S)=s2s2+ω2 Initial value of f(t) =lims→∞sF(s)=lims→∞s×ss2+ω2,=lims→∞11+(ωs)2,=11+0,=1.     x…

Q: I=0.1A/0° R₁. • 20 Ω x 82 20 Ω Xc a ob 32 Ω R, = 68 Ω

A: given circuit: To calculate the Thevenin equivalent voltage across the terminal a and b, replace…

Q: Three sides of an infinitely long rectangular metallic pipe are grounded at x=0, x=a and y=0. The…

A: Given data, Three sides of an infinitely long rectangular metallic pipe are grounded at, x=0 x=a and…

Q: Using general-purpose open-loop zero crossing logic a Vo = 5 V = OV an op-amp, design. based on the…

A: Types of op-amp Inverting Op-amp Non-inverting Op-amp  The Ideal operational amplifier is an…

Q: 3.5 Obtain v, in the circuit of Fig. 3.54. 30 V (+ 2 ΚΩ Figure 3.54 20 V 5 ΚΩ +1 4 ΚΩ Vo

A:

Q: Question 1 Find V₁ and V₂ in the circuit shown in Fig. Q1 www "990 12V www +92- Fig. Q1 10V

A:

Q: Solve the following. Show complete solution, resistor combination and circuit transformation. Box…

A:

Q: How can you shield your machine from electrical spikes?

A: The objective is to determine the way to protect the device by the voltage surges.

Q: a) A sudden electrical surge is known to cause a nearly one-second-long power spike in an electrical…

A: a) Given data Pt=sint-t5 We need to find the maximum that can be designed and also the number of…

Q: A two-pole, 50-Hz synchronous generator has a rating of 200 MVA, 0.8 power factor lagging. The…

A: Given data: The frequency is f=50 Hz The number of poles, P =2 The power factor is 0.8 lagging The…

Q: Q2. A step down chopper has a resistive load of 2002 and input voltage VS = 220V. When chopper is…

A:

Q: Table 1: Laplace Transform Properties Linearity L{af(t)} = aF(s) Superposition L {f₁(t) + f₂(t)} =…

A:

Q: Find the binary equivalent for each of the following numbers. Show your work! a. 36410 b. 2169 10

A: a) Decimal number is 36410. Binary equivalent of given decimal numbers will be calculated as…

Q: Q. 31. A 4 kV, 110 Hz Schering bridge with a grounded detector as shown in fig. 4 has Cs-100 PF. In…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…