A series of solutions containing NAOH, Na,CO, and NaHCO, alone or in compatible combination, was titrated with o.1202 M HCI. Tabulated below are the volumes of acid needed to titrate 25.00-mL portions of each solution to (1) a phenolphthalein and (2) a bromocresol green end point. Use this information to deduce the composition of the solutions. In addition, calculate the mass in milligrams of each solute per milliliter of solution. (2) (1) (a) 22.42 22.44 42.13 36.42 32.23 33.333

A series of solutions containing NAOH, Na,CO, and NaHCO, alone or in compatible combination, was titrated with o.1202 M HCI. Tabulated below are the volumes of acid needed to titrate 25.00-mL portions of each solution to (1) a phenolphthalein and (2) a bromocresol green end point. Use this information to deduce the composition of the solutions. In addition, calculate the mass in milligrams of each solute per milliliter of solution. (2) (1) (a) 22.42 22.44 42.13 36.42 32.23 33.333

Chemistry & Chemical Reactivity

10th Edition

ISBN:9781337399074

Author:John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Publisher:John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Chapter4: Stoichiometry: Quantitative Information About Chemical Reactions

Section4.9: Spectrophotometry

Problem 2.1ACP: Excess KI is added to a 100.0-mL sample of a soft drink that had been contaminated with bleach,...

See similar textbooks

Similar questions

A solid containing tris was dissolved in water and brought to a total volume of 50.00 ml. A 10.00 ml aliquot of the solution was titrated with 0.09978 M HCl to a bromcresol green endpoint. The aliquot consumed 38.93 ml of titrant. Calculate the weight of tris in the original sample.
The concentration of ammonia in a cleaning product was determined by back titration.Firstly, 10.00 cm3 of the cleaning product was pipetted into a large conical flask,containing 250.00cm3 of 0.50 mol/l HCl to give Solution A.Following a period of reaction and shaking, 50.00cm3 of Solution A was removed anddiluted to 250 cm3 with water in a volumetric flask to give Solution B.20 cm3 samples of Solution B were titrated against 0.05 mol/l Na2CO3 solution, givingan average titre of 12.45 cm3. i) Write equations for the reactions that have taken place.ii) Determine the concentration of NH3 in the original cleaning product in mol/l,g/l, ppm, and % w/v.
Water sample from different river water was subjected to a qualitative alkaline analysis by titrating against 0.1250 MHC1 and using phenolphthalein and bromocresol green end point. The table below shows the volumes of acid needed to titrate 25.00-mL portions of each sample and their corresponding end point, separately. Use this information to deduce the composition of the solutions. Calculate the molar concentration of each solute. Volume (mL) Phenolphthalein end Bromocresol green Solute identity concentration end point Volume (mL) Molar Sample point 22.40 of solute/s 1 22.41 2 0.00 33.40 3 15.67 42.13 4 29.64 36.42
A mixture containing only KCl and NaBr is analyzed by the Mohr method. A 0.2125-g sample is dissolved in 25 mL of water and titrated to the Ag2CrO4 endpoint, requiring 25.63 mL of 0.1110 M AgNO3. A blank titration requires 1.15 mL of titrant to reach the same end point. Report the %w/w KCl and NaBr in the sample. KCl = 74.551 NaBr = 102.89
Calcium in a 5.00 mL urine sample was precipitated, redissolved and required 16.15 mL of 0.1157 N KMnO4. Calculate the % (w/v) of calcium in the urine.
2. In one gravimetric analysis, the aluminum in a 1.2g sample of impure NHAI(SO4)2 was precipitate as hydrous ALO3.XH2O. The precipitate was filtered and ignited at 1000 °C to give anhydrous Al2O3 which weighed 0.1798g. Calculate the % Al inthe sample. 3. A sample of 0.4500g impure potassium chloride was dissolved in water treated with excess silver nitrate solution. 0.8402 g of silver chloride was precipitated. What is the percentage of potassium chloride in the sample?
A 4.912-g sample of a petroleum product was burnedin a tube furnace, and the SO2produced was collectedin 3% H2O2.Reaction:SO2(g)+H2O2→H2SO4A 25.00-mL portion of 0.00873 M NaOH was introducedinto the solution of H2SO4, following whichthe excess base was back-titrated with 15.17 mL of0.01102 M HCl. Calculate the sulfur concentrationin the sample in parts per million.
A 1.00 g sample of NaOH which has been exposed to the air for some time is dissolve in water and water and diluted to 500.0 ml. 100.0 ml of the solution is titrated with 0.1062 N HCl (MOH indicator) and requires 38.60 ml. A second 100 .0 ml portion is titrated with excess BaCl2, diluted to 250 .0 ml and filtered. 200.0 ml of this filtrate then require 29.62 ml of the HCl ( HpH indicator) . Calculate the % NaOH and Na2CO3 in the original sample.
A 0.512 g sample of a commercial phosphate detergent was ignited at a red heat to destroy the organic matter. The residue was taken up in hot HCl, which converted the P to H3PO4. The phosphate was precipitated as MgNH4PO4.6H2O by addition of Mg2+ followed by aqueous NH3. After being filtered and washed the precipitate was converted to Mg2P2O7 by ignition at 1000 0C and the residue weighed 0.1151g. (a) What is the Gravimetric Factor to convert Mg2P2O7 to P? (b) Calculate the percent P in the sample could you type it out please
An impure sample of KCIO, (FW = 122.5 g/mol) weighing 0.1353 grams was dissolved in 50.0 mL distilled water, added with KI & acid. The 1₂ formed was titrated with 38.00 mL of 0.1005 N Na₂S₂O3 with starch as indicator. Calculate the % (w/w) KCIO3 in the sample.
1. A 0.3516 g sample of commercial phosphate detergent was ignited at a heat to destroy the organic matter. The residue was taken up in hot HCI which converted P to H3PO4. The phosphate was precipitated as MGNH4PO4.6H2O by addition of Mg+ followed by aqueous NH3. After being filtered and washed, the precipitate was converted to Mg2P2O7 by ignition at 1000 OC. This residue weighed 0.2161 g. Calculate the percent P (30.974) in the sample? Ans 17.11%
The nitrogen and protein content of a 2.8391 g sample of milk was determined using Kjeldahl analysis. After digestion, the liberated NH3 was distilled in a flask containing 25.00 mL of standard 0.250 M HCI. Titration requires 31.65 mL of standard 0.100 M N2OH to reach the desired endpoint. Calculate the weight percent of N (FW=14.01) and protein in the sample of milk. Report values in 3 SF. % N = % % Protein =